Development of Module Generators from Extracted Design Procedures : Application to Analog Device Generation
スポンサーリンク
概要
- 論文の詳細を見る
This paper proposes a new approach for the development of a module generator that can parameterize both the size and the structure of layout. The proposed method acquires a design procedure from the design process of a designer, and reuses it to synthesize new layouts with different input parameters that affect the size or the structure of layout. In this method, a designer creates a module layout on a layout editor instead of writing a program. From his design process, a procedure to synthesize the layout is automatically derived. Then, it is generalized so that it could be valid under different values of input parameters. The generalized procedure is independent of design rules, and is capable of synthesizing error-free module layouts of different size and structure. Also, the procedure includes designer's requirements on how the layout should be designed. The experimental results of applying the approach for developing generators of analog device components show effectiveness of our approach.
- 社団法人電子情報通信学会の論文
- 1995-02-25
著者
-
小野寺 秀俊
京都大学工学部電子工学科
-
Onodera H
Kyoto Univ. Kyoto‐shi Jpn
-
Onodera Hidetoshi
Kyoto Univ. Kyoto‐shi Jpn
-
Morie T
Graduate School Of Life Science And Systems Engineering Kyushu Institute Of Technology
-
Morie Takashi
Faculty Of Engineering Kyoto University
-
小野寺 秀俊
滋賀県立大学工学部
-
小野寺 秀俊
京都大学大学院工学研究科電子通信工学専攻
-
Onodera Hidetoshi
Faculty of Engineering, Kyoto University
-
Tamaru Keikichi
Faculty of Engineering, Kyoto University
-
Onodera Hidetoshi
Faculty Of Engineering Kyoto University
-
TAMARU Keikichi
Okayama University of Science
-
Tamaru K
Okayama University Of Science
-
Tamaru Keikichi
Faculty Of Elctronics Kyoto University
関連論文
- パネル討論 : 設計/CAD技術はディープサブミクロン時代の挑戦に耐えられるか
- CMOS論理ゲートにおける貫通電流による消費電力の定式化
- 抵抗アレイモデルを用いたアナログ回路用概略配線
- 形状最適化コンパクション
- ビルディングブロックレイアウトのための分枝限定配置手法
- ばらつき考慮設計に向けて(アナログ,アナデジ混載,RF及びセンサインタフェース回路)
- ばらつき考慮設計に向けて(アナログ,アナデジ混載,RF及びセンサインタフェース回路)
- 基板バイポーラ効果によるSEUとMCUの発生機構の検討(製造性考慮設計,システムオンシリコンを支える設計技術)
- C-12-56 ω_nドメイン設計手法によるCDR-ICの低ジッタ化(C-12.集積回路,一般セッション)
- Optimal Termination of On-Chip Transmission-Lines for High-Speed Signaling(Analog Circuits and Related SoC Integration Technologies)
- Interconnect RL Extraction Based on Transfer Characteristics of Transmission-Line(Interconnect,VLSI Design and CAD Algorithms)
- Si-Substrate Modeling toward Substrate-Aware Interconnect Resistance and Inductance Extraction in SoC Design(Interconnect,VLSI Design and CAD Algorithms)
- Performance Limitation of On-Chip Global Interconnects for High-Speed Signaling(Selected Papers from the 17th Workshop on Circuits and Systems in Karuizawa)
- Representative Frequency for Interconnect R(f)L(f)C Extraction(Parasitics and Noise)(VLSI Design and CAD Algorithms)
- Instruction-Level Power Estimation Method by Considering Hamming Distance of Registers(Selected Papers from the 16th Workshop on Circuits and Systems in Karuizawa)
- PA-1 大学の研究をどのように産業界に活かすか?
- モデル依存性の小さいMOSFETパラメータ抽出システムの実現
- 相互結合インダクタを用いたTIA帯域向上手法(若手研究会)
- AI-1-3 ディペンダブルVLSIプラットフォームへの挑戦(AI-1.デイベンダブルVLSIに向けて,依頼シンポジウム,ソサイエティ企画)
- A 90nm 48×48 LUT-Based FPGA Enhancing Speed and Yield Utilizing Within-Die Delay Variations(Low-Power and High-Performance VLSI Circuit Technology,VLSI Technology toward Frontiers of New Market)
- A 90nm LUT Array for Speed and Yield Enhancement by Utilizing Within-Die Delay Variations(Digital,Low-Power, High-Speed LSIs and Related Technologies)
- Low-Power Design of CML Driver for On-Chip Transmission-Lines Using Impedance-Unmatched Driver(Analog Circuits and Related SoC Integration Technologies)
- A Leakage Reduction Scheme for Sleep Transistors with Decoupling Capacitors in the Deep Submicron Era(Electronic Circuits)
- Experimental Study on Cell-Base High-Performance Datapath Design(IP Design)(VLSI Design and CAD Algorithms)
- Experimental Study on Cell-Base High-Performance Datapath Design
- Timing Analysis Considering Spatial Power/Ground Level Variation(Physical Design,VLSI Design and CAD Algorithms)
- 不確定パラメタの導入によるアナログ回路設計手順の再利用率向上手法
- A-58 モデル依存性の小さいMOSFETパラメータ抽出システムの実現(A-3. VLSI設計技術,一般講演)
- モデル依存性の小さいMOSFETパラメータ抽出手法
- アナログ回路設計手順の保存・再利用化手法
- Special Section on Analog Circuit Techniques for System-on-Chip Integration
- FOREWORD (Special Section on Analog Technologies in Submicron Era)
- Image Segmentation/Extraction Using Nonlinear Cellular Networks and Their VLSI Implementation Using Pulse-Modulation Techniques(Special Section on Analog Circuit Techniques and Relate)
- A 1-D CMOS PWM Cellular Neural Network Circuit and Resistive-Fuse Network Operation
- Image Object Extraction Using Resistive-Fuse and Oscillator Networks and a Pulse-Modulation Circuit for Their LSI Implementation
- デザインルールチェック並列処理化の一手法 : 並列スケジューリングによる手順割り当て
- デザインルールチェック並列処理化の一手法 : 並列スケジューリングによる手順割り当て
- 中間モデルを用いたモデル依存性の小さいMOSFETパラメータ抽出手法
- Timing Analysis Considering Temporal Supply Voltage Fluctuation
- Successive Pad Assignment for Minimizing Supply Voltage Drop(Power/Ground Network, VLSI Design and CAD Algorithms)
- An Area/Delay Efficient Dual-Modular Flip-Flop with Higher SEU/SET Immunity
- Pulse Modulation Techniques for Nonlinear Dynamical Systems and a CMOS Chaos Circuit with Arbitrary 1-D Maps(New System Paradigms for Integrated Electronics)
- An Hadamard Transform Chip Using the PWM Circuit Technique and Its Application to Image Processing(Special Issue on High-Performance Analog Integrated Circuits)
- A CMOS Stochastic Associative Processor Using PWM Chaotic Signals(Special Issue on Integrated Systems with New Concepts)
- Bio-Inspired VLSIs Based on Analog/Digital Merged Technologies
- Merged Analog-Digital Circuits Using Pulse Modulation for Intellingent SoC Applications (Special Section on Analog Circuit Techniques Supporting the System LSI Era)
- A High-Resolution Hadamard Transform Circuit Using Pulse Width Modulation Technique
- A Multi-Quantum-Dot Associative Circuit Using Thermal-Noise Assisted Tunneling
- A Nonlinear Oscillator Network for Gray-Level Image Segmentation and PWM / PPM Circuits for Its VLSI Implementation(Special Section on Intelligent Signal and Image Processing)
- New Non-Volatile Analog Memory Circuits Using PWM Methods (Special Issue on Integrated Electronics and New System Paradigms)
- A Stochastic Association Circuit Using PWM Chaotic Signals
- A Pattern Matching Processor Using Analog-Digital Merged Architecture Based on Pulse Width Modulation
- An Analog-Digital Merged Neural Circuit Using Pulse Width Modulation Technique (Special Section on Analog Circuit Techniques and Related Topics)
- A Stochastic Associative Memory Using Single-Electron Devices and Its Application in Digit Pattern Association
- A Stochastic Associative Memory Using Single-Electron Tunneling Devices (Special Issue on Technology Challenges for Single Electron Devices)
- 特集「システムLSI設計とその技術」の編集にあたって
- アナログ/ディジタル混載LSIのCAD技術
- BPBP型FMPPを用いたプロセッサボードの設計
- Model-Adaptable Parameter Extraction System for MOSFET Models
- Development of Module Generators from Extracted Design Procedures : Application to Analog Device Generation
- A-3-13 SystemC を用いたハードウェア・ソフトウェア設計 : SystemC のRTL記述からHDLへの変換
- A-3-12 SystemC を用いたハードウェア・ソフトウェア強調設計
- Architecture and Performance Evaluation of a New Functional Memory : Functional Memory for Addition (Special Section on VLSI Design and CAD Algorithms)
- A Real-Time Low-Rate Video Compression Algorithm Using Multi-Stage Hierarchical Vector Quantization (Special Section on VLSI for Digital Signal Processing)
- An LSI for Low Bit-Rate Image Compression Using Vector Quantization(Special Issue on Multimedia, Network, and DRAM LSIs)
- A Memory-Based Parallel Processor for Vector Quantization:FMPP-VQ (Special Issue on New Concept Device and Novel Architecture LSIs)
- A Current Mode Cyclic A/D Converter with Submicron Processes (Special Section on Analog Circuit Techniques for System-on-Chip Integration)
- A Bit-Parallel Block-Parallel Functional Memory Type Parallel Processor Architecture (Special Issue on New Architecture LSIs)
- A Language for Designing Module Generators (Special Issue on Synthesis and Verification of Hardware Design)
- A Comprehensive Simulation and Test Environment for Prototype VLSI Verification(Verification)(Test and Verification of VLSI)
- Hardware Architecture for Kohonen Network (Special Issue on New Architecture LSIs)
- Compaction with Shape Optimization and Its Application to Layout Recycling
- Experiments with Power Optimization in Gate Sizing (Special Section of Letters Selected from the 1994 IEICE Spring Conference)
- Estimation of Short-Circuit Power Dissipation for Static CMOS Gates (Special Section of Selected Papers from the 8th Karuizawa Workshop on Circuits and Systems)
- FOREWORD (Special Issue on Synthesis and Verification of Hardware Design)
- Micro-Loading効果を考慮したCMOS回路の比精度解析
- レイアウトを考慮したCMOS回路の比精度解析
- The Trend of Functional Memory Development (Special Issue on LSI Memories)
- Development of procedure for modeling MOSFET compatible with ITRS: noise and 1-5 characteristics modeling for RF/analog MOSFET (集積回路)
- More Mooreに立ちはだかるCMOSばらつきの理解に向けて(低電力設計,システムオンシリコンを支える設計技術)
- ビット並列ブロック並列型FMPPにおける機能メモリのテスト方法
- ビット並列ブロック並列型FMPPアーキテクチャをとるプロトタイプLSIチップの概要
- ビット並列ブロック並列方式による機能メモリ型並列プロセッサの設計
- C-12-46 完全差動回路構成GVCOの高速化設計(C-12.集積回路,一般セッション)
- C-12-25 On-chip Monitor Circuits to Estimate Global Variations of Threshold Voltage and Gate Length
- Area-Effective Inductive Peaking with Interwoven Inductor for High-Speed Laser-Diode Driver for Optical Communication System
- Variation-Tolerance of a 65-nm Error-Hardened Dual-Modular-Redundancy Flip-Flop Measured by Shift-Register-Based Monitor Structures