Improvement of the Surface Layer of Steel Using Microwave Plasma Nitriding

スポンサーリンク

概要

• 論文の詳細を見る
• Japan Institute of Metalsの論文
• 2004-03-20

著者

• ONUKI Jin

  Department of Materials Science and Engineering, Ibaraki University

• Onuki Jin

  Akita Prefectural University

• Koizumi M

  Department Of Electronics And Information Systems Faculty Of Systems Science And Technology Akita Pr

• Onuki J

  Dep. Of Materials Sci. And Engineering Ibaraki Univ.

• Onuki J

  Akita Prefectural Univ. Honjo Jpn

• Onuki Jin

  Department Of Electronic And Information Systems Faculty Of Systems Science And Technology Akita Pre

• TAKEUCHI Manabu

  Department of Electrical and Electronic Engineering, Ibaraki University

• KOMIYAMA Takao

  Department of Electronics and Information Systems, Faculty of Systems Science and Technology, Akita

• Takeuchi Mitsuaki

  Department Of Applied Science School Of Engineering Tokai University

• Khoo Khyoupin

  Graduate School Of Science And Engineering Ibaraki University

• Komiyama Takao

  Department Of Electronic And Information Systems Faculty Of Systems Science And Technology Akita Pre

• Takeuchi Manabu

  Department Of Electrical And Electronic Engineering Ibaraki University

関連論文

• Impact of High Heating Rate, Low Temperature, and Short Time Annealing on the Realization of Low Resistivity Cu Wire
• 有機溶媒,ナフタレンの電気伝導に及ぼすフラ-レンド-ピングの影響
• Formation and Characterization of GaAs Quantum Wires at Giant Step Edges on Vicinal (110) GaAs Surfaces
• Effects of Anthracene Doping on Electrical and Light-Emitting Behavior of 8-Hydroxyquinoline-Aluminum-Based Electroluminescent Devices
• High-Temperature Thick Al Wire Bonding Technology for High-Power Modules
• High-Strength and High-Speed Bonding Technology using Thick Al-Ni Wire
• Development of A New High-Frequency, High-Peak Current Power Source for High Constricted Arc Formation
• Molecular Dynamics Simulation of Grain Growth of Cu Film : Effects of Adhesion Strength between Substrate and Cu Atoms
• Molecular Dynamics Simulation of Void Generation during Annealing of Copper Wiring
• Joining of Oxide Dispersion Strengthened Ni Based Super Alloys
• Liquid Phase Epitaxial Growth of lnGaAsP on GaAs_P_y Substrates (y=0.3l and 0.39)
• LPE Growth of Lattice-Matched InGaAsP on GaAs_P_ Substrates and Low Threshold Current Density Operation of Visible InGaAsP DH Lasers
• CW Lasing Characteristics of Visible InGaAsP Lasers Grown on GaAsP Substrates
• Influence on the Electro-Migration Resistance by Line Width and Average Grain Size along the Longitudinal Direction of Very Narrow Cu Wires
• Enzymatic Properties of Phenylalanine 101 Mutant Enzyme of Ribonuclease Rh from Rhizopus niveus
• Enzymatic Properties of Double Mutant Enzymes at Asp51 and Trp49 and Asp51 and Tyr57 of RNase Rh from Rhizopus niveus
• Enzymatic Properties of Mutant Forms of RNase Rh from Rhizopus niveus as to Asp51^1
• Enzymatic Properties of Mutant Enzymes at Trp49 and Tyr57 of RNase Rh from Rhizopus niveus ^1
• Dual Jet Ionizer for Manufacturing Semiconductor Devices
• Effect of Gaseous Atmospheres on Particle Generation by Emitters for Corona Discharge Ionizers (論文特集:2004年度静電気学会全国大会)
• Effects of Moisture Sorption on the Rate of Charge Decay from Polymer Powder Layers
• Mechanochemical Effect in ZnTe Powder Associated with Grinding
• Contact Charging of a-Se Electrophotographic Photoreceptor with Molten Gallium
• Microstructures of 50-nm Cu Interconnects along the Longitudinal Direction
• Influence of Grain Size Distributions on the Resistivity of 80nm Wide Cu Interconnects
• Aspect ratio dependence of the resistivity of fine line Cu interconnects
• Filling a Narrow and High Aspect-Ratio Trench with Electro-Cu Plating
• Filling 80-nm-Wide and High-Aspect-Ratio Trench with Pulse Wave Copper Electroplating and Observation of the Microstructure
• Improvement of the Surface Layer of Steel Using Microwave Plasma Nitriding
• Microwave Plasma Nitriding of Hollow Tube Inner Wall
• The Low Temperature Bonding between Si and Electrode Using Sputtered Ag Films
• Influence of P Content in Electroless Plated Ni-P Alloy Film on Interfacial Structures and Strength between Sn-Zn Solder and Plated Au/Ni-P Alloy Film
• Influence of Phosphorus Concentration in Electroless Plated Ni-P Alloy Film on Interfacial Structures and Strength between Sn-Ag-(-Cu) Solder and Plated Ni-P Alloy Film
• Influence of Soldering Conditions on Void Formation in Large-area Solder Joints
• The Influence of Phosphorus Concentration of Electroless Plated Ni-P Film on Interfacial Structures in the Joints between Sn-Ag Solder and Ni-P Alloy Film
• A Void Free Soldering Process in Large-Area, High Power Insulated Gate Bipolar Transistor Modules
• Reliability Enhancement of Solder Joints Made by a Void Free Soldering process
• Interface Reaction between Solder and Plated Nickel Film
• Composition Modulation in Quantum Wire Structures on Vicinal (110) GaAs Studied by Photoluminescence
• Electrochromic Behavior of Amorphous Copperphthalocyanine Thin Films
• Effects of Molecular Configurations on the Electrical Resistivity of Titanylphthalocyanine Thin Films
• Humidity Sensitivity of Lamb Waves on Composite Polyimide/ZnO/Si_3N_4 Structure
• Wide Bandwidth Low Loss Filters Using Piezoelectric Leaky SAW Unidirectional Transducers with Floating Electrodes : SAW and Communication Devices
• Influence of H_2O on the SiO_2 Growth by Parallel-Resonant RF Plasma Oxidation
• Enhanced Growth of Silicon Dioxide Films by Parallel-Resonant RF Plasmas
• UHF-Range Positive/Negative Reflection Type SAW Resonators on LiNbO_3 Using New Fabrication Techinique : SAW and BAW Materials, Devices and Theories
• Effects of Heat-Treatments on Corona Charging Properties of CdS Powder Layers
• Effect of Physical Properties of Al–Si Electrode Films on the Deformation Behaviors and the Strength of Thick Al Wire Bonds during Thermal Cycle Test
• Ar Ion Beam Irradiation Effects on Magnetostrictive Characteristics of Tb-Fe Thin Film
• Improvement of Photovoltaic Performance in Copper Phthalocyanine Binder Layer Solar Cells
• Determination of the Phase-Field Parameters for Computer Simulation of Heat Treatment Process of Ultra Thin Al Film
• Waveguide-Type Multifrequency Acoustooptic Modulators
• Investigation of Low Loss and High Reliability Encapsulation Technology in Large-Area, High-Power Semiconductor Devices
• Computer Simulation of Silicon Nanoscratch Test
• SELF-LIMITING RISK OF METACHRONOUS GASTRIC CANCERS AFTER ENDOSCOPIC RESECTION
• Friction and Elongation of Al Electrodes due to Micro-Sliding between the Inner Mo Electrode and the Al Electrodes in High-Power Devices
• 多結晶銅薄膜の粒成長に及ぼす不純物の影響
• Effect of Additive-Free Plating and High Heating Rate Annealing on the Formation of Low Resistivity Fine Cu Wires
• PREFACE
• Reliability Enhancement of Thick Al-Cu Wire Bonds in IGBT Modules Using Al_2Cu Precipitates
• Void Generation Mechanism in Cu Filling Process by Electroplating for Ultra Fine Wire Trenches
• Aspect Ratio Dependence of the Resistivity of Fine Line Cu Interconnects
• Filling 80-nm-Wide and High-Aspect-Ratio Trench with Pulse Wave Copper Electroplating and Observation of the Microstructure
• Coating Adhesion Evaluation by Nanoscratching Simulation Using the Molecular Dynamics Method
• Observation of Microstructures in the Longitudinal Direction of Very Narrow Cu Interconnects
• Influence of Minimum Barrier Metal Thickness at Trenches on Void Formation in 50-nm-wide Cu Wiring
• ナノスケールダマシン銅配線のアニーリングによる構造変化
• Enzymatic Properties of Mutant Enzymes at Trp49 and Tyr57 of RNase Rh from Rhizopus niveus.
• Enzymatic Properties of Mutant Forms of RNase Rh from Rhizopus niveus as to Asp51.

もっと見る 閉じる

スポンサーリンク