Effects of Frequency on the Crack-Healing Behavior of Si_3N_4/SiC Composite under Cyclic Stress(<Special Issue>Macro-, Micro-, Meso-, and Nano-scopic Strength of Materials Relating to Microstructures)
スポンサーリンク
概要
- 論文の詳細を見る
Si_3N_4/SiC ceramics were hot-pressed to investigate the effect of stress frequency on the crack-healing behavior under cyclic stress. The specimens having pre-crack of 100μm were subjected to crack-healing under constant or cyclic bending stresses of 300MPa at temperatures between 800 and 1200℃. The resultant bending strength of the crack-healed specimen was investigated. At a healing temperature of 900℃, the pre-cracks had been completely healed both under constant stress and cyclic stress of 0.5Hz. However, the pre-cracks had not completely healed under a cyclic stress of 5 and 10Hz. Thus, the stress frequency affects crack-healing behaviors at 900℃. On the other hand, when the healing temperature was higher than 1000℃, the pre-cracks were healed completely under both constant stress and cyclic stress up to 10Hz. The effects of stress frequency were dependent on the healing temperature. The reasons for this were discussed from the viewpoint of competitive mechanism of fatigue crack growth and crack-healing.
- 2006-07-15
著者
-
SAITO Shinji
Toshiba Corporation, Advanced Semiconductor Devices Research Laboratories
-
ANDO Kotoji
Department of Energy & Safety Engineering, Yokohama National University
-
Saito Shinji
Nhk Spring Co. Ltd.
-
Takahashi Koji
Department Of Chemistry And Chemical Engineering Yamagata University
-
MIZOBE Yuuta
Yokohama National University
-
Takahashi K
Department Of Energy & Safety Engineering Yokohama National University
-
Takahashi Koji
Department Of Aeronautics And Astronautics Kyushu University
-
TAKAHASHI Koichi
Department of Liberal Arts, Tohoku Gakuin University
-
Ando Kotoji
Department of Energy & Safety Engineering, Yokohama National University
-
TAKAHASHI Koji
Departent of Materials Science and Engineering,Faculty of Engineering,Yamagata University
関連論文
- Five cases of thrombocytopenia induced by primary human herpesvirus 6 infection
- Temperature Dependence of the Ideality Factor of Ba_K_xBiO_3/Nb-doped SrTiO_3 All-Oxide-Type Schottky Junctions
- Effect of the Field Dependent Permittivity and Interfacial Layer on Ba_K_xBi0_3/Nb-Doped SrTi0_3 Schottky Junctions
- The Influence of the Bottom Shape of an Agitated Vessel Stirred by Dual Impellers on the Distribution of Solid Concentration
- Ferrielectricity in Chiral Smectic C_β of an Antiferroelectric Liquid Crystal
- Deflection of Light at the Boundaries between Ferroelectric and Antiferroelectric States in Chiral Smectic Liquid Crystals
- Optical Activity in Antiferroelectric Liquid Crystals
- Dielectric Relaxation Modes in the Phases of Antiferroelectric Liquid Crystals
- Phase Sequence in Smectic Liquid Crystals Having Fluorophenyl Group in the Core ( FERROELECTRIC MATERIALS AND THEIR APPLICATIONS)
- Substrate Specificities of Deuterolysin from Aspergillus oryzae and Electron Paramagnetic Resonance Measurement of Cobalt-substituted Deuterolysin(Biochemistry & Molecular Biology)
- Analysis of Device Characteristics for InGaN Semiconductor Lasers
- Room Temperature Pulsed Operation of Nitride Based Multi-Quantum-Well Laser Diodes with Cleaved Facets on Conventional C-Face Sapphire Substrates
- The Influence of Surface Treatment on the Quality of Pd/Au Contacts to p-type ZnSe
- Surface Preparation Effects for Molecular Beam Epitaxial Growth of ZnSe Layers on InGaP Layers
- Electronic Coupling of Quantum-Well States in Double Ag Nanofilm Structures
- Soluble Egg Shell Membrane Protein as a Regulating Material for Collagen Matrix Reconstruction
- Time Variation of the Cosmic Ray Muon Flux in Underground Detectors and Correlation with Atmospheric Temperature
- Investigation of New Embedding Mediums for Cytochemistry and Immunoelectronmicroscopy.
- RELATION BETWEEN IMPACT VELOCITY OF PARTICLE AND SIZE OF CRATER FORMED ON SOFT SURFACE
- Thin Film Growth of YBa_2Cu_3O_ by ECR Oxygen Plasma Assisted Reactive Evaporation
- Development of High Efficiency Gyrotron with Depressed Collector for ECH System
- 単軸エクストル-ダ-内の異なる形状のピン混合領域における分配混合の2次元解析
- Field-Induced Phase Transitions in Antiferroelectric Liquid Crystal
- Superconductivity in Single-Crystalline Sr_La_xTiO_3
- Characterization of Ba_K_xBiO_3 Superconducting Thin Films for Three-Terminal Devices
- Preparation and Characteristics of a Superconducting Base Transistor with an Au/Ba_K_xBiO_3/Niobium-Doped SrTiO_3 Structure
- Junction Characteristics of an Au/Ba_K_xBiO_3/Niobium-Doped SrTiO_3 Structure
- A case of averrant thyroid carcinoma connected with the thyroid by a fibrous band
- D315 A NOVEL FLUIDIC MICROMOTOR DRIVEN BY THERMOCAPILLARY FORCE(Micro-scale phenomena)
- The Effect of Microwave-Plasma on Decomposition and Oxidation of Ba(THD)_2
- Effect of Pre-crack Size and Crack-healing Temperature on Fatigue Strength of Mullite/SiC Ceramics(Ceramics & Rocks 2)
- Neutrino Burst from Supernovae and the Implications for Neutrino Oscillation Parameters
- Mixing Time for Different Diameters of Impeller at a High Solid Concentration in an Agitated Vessel
- GI-10 EVALUATION METHOD OF GEAR MEASURING INSTRUMENT USING V-GROOVE ARTIFACT(INSPECTION OF GEARS)
- GI-08 EVALUATION OF GEAR MEASURING INSTRUMENT USING MULTIPLE-TOOTH INVOLUTE HELICOID ARTIFACT(INSPECTION OF GEARS)
- Coloured Petri Net Based Modelling and Analysis of Multiple Product FMS with Resource Breakdowns and Automated Inspection(Concurrent Systems)
- The Modeling and analysis of Guide-path configurations of an integrated Automated guided Vehicle system using Colored Petri Net
- Hierarchical Control Modeling of Automated Guided Vehicle System (AGVS) using Colored Petri Net
- Colored Petri Net based Performance analysis of Flexible Manufacturing System with planned and unplanned Resource Breakdowns
- Colored Petri Net based Performance analysis of Flexible Manufacturing System with planned and unplanned Resource Breakdowns
- Improved Physical and Biochemical Features of a Collagen Membrane by Conjugating with Soluble Egg Shell Membrane Protein
- Contribution of the Net Charge to the Regulatory Effects of Amino Acids and ε-Poly(L-lysine) on the Gelatinization Behavior of Potato Starch Granules
- Interfacial Behavior of Fatty-Acylated Sericin Prepared by Lipase-Catalyzed Solid-Phase Synthesis
- Thermal Behavior of Fowl Feather Keratin
- Comparison of Device Performance in Two Thin-Film Electroluminescent Devices Made of Vacuum-Sublimed Dye Film and Spin-Coated Polymer Film
- Enhancement of Nitrogen Incorporation in ZnSe Grown on Misoriented GaAs Substrates by Molecular Beam Epitaxy
- Electroluminescent Behaviors in Multilayer Thin-Film Electroluminescent Devices Using 9, 10-Bisstyrylanthracene Derivatives
- Electronic and Geometric Structures of Fullerenes and Metallofullerenes
- Blue-Light-Emitting Organic Electroluminescent Devices with Oxadiazole Dimer Dyes as an Emitter
- Fermi Surfaces of Alkali-Metal-Doped C_ Solid
- Spectroscopic Study on Plasma-Enhanced Chemical Vapor Deposition of YBa_2Cu_3O_x Superconducting Thin Films
- Stable,Single-Mode Oscillation with High-Order Volume Mode at 1MW,170GHz Gyrotron
- Numerical Simulation of the Flow Field in the Mixing Section of a Screw Extruder by the Lattice Gas Automata Method
- Synthesis and Characterization of Ba β-Diketonate Cormplexes for Chemical Vapor Deposition of Thin-Film Superconductors
- Gassed Power Consumption and Gas Hold-up for a Dual Hollow Blade Impeller System in a Stirred Vessel
- Gas Dispersion Characteristics of Newly Developed Impellers in a Stirred Vessel
- A Novel Measurement Technique for Mixing Time in an Aerated Stirred Vessel
- Effects of Frequency on the Crack-Healing Behavior of Si_3N_4/SiC Composite under Cyclic Stress(Macro-, Micro-, Meso-, and Nano-scopic Strength of Materials Relating to Microstructures)
- Serotonin-immunoreactive Epithelial Cells in the Main Excretory Ducts of Rat Submandibular Glands
- Microheater-Driven Dancing Microbubble
- Functional Changes of Lysozyme by Conjugating with Carboxymethyl Dextran
- Control of Crystal Size Distributions in a Seeded Batch Crystallizer
- EFFECT OF SCALE ON PARTICLE-IMPELLER IMPACT IN AN AGITATED VESSEL EQUIPPED WITH A RUSHTON TURBINE
- PARTICLE-IMPELLER IMPACT IN AN AGITATED VESSEL EQUIPPED WITH A RUSHTON TURBINE
- Increased Hydrophobicity of Carboxymethyl Starch Film by Conjugation with Zein(Food & Nutrition Science)
- Collisional Evolution of Galaxy Clusters and the Growth of Common Halos
- Gas-Liquid Mass Transfer Coefficient of a Pitched Bladed Paddle Up-Pumping at Extraordinary Large Gas Flow Rates
- Development of an Aerobic Cultivation System by Using a Microbubble Aeration Technology
- Theoretical Tool for Optimum Design of Mixer, and Visualization and Quantification of Mixing Performance
- Increase of cytochrome c oxidase negative fibers in rimmed vacuole myopathy with inflammatory changes
- Lactic Acid Fermentation from Rice by Adopting Food Wastes as Nutrients
- Polymerized Structure and Improved Physical and Biochemical Material Properties of Carboxymethyl Dextran-Conjugated Collagen
- Soft Textural and Emulsifiable Gelatin Formed by Conjugating with Fatty-Acylated Saccharide
- Reversible Thermal Transition of Soluble Branched Chains from Slightly Acid-treated Potato Starch
- Mediastinal lymphatic drainage from pulmonary lobe based on CT observations of histoplasmosis : implications for minimal N2 disease of non-small-cell lung cancer
- Improvement of the Physical Properties of Pepsin-Solubilized Elastin-Collagen Film by Crosslinking
- Development of a Lactic Acid Recovery System Using Ammonia from a Fermentation Broth
- Liquefaction for the Lactic Acid Fermentation from Rice
- Flow in a Poppet Valve : Computation of Pressure Distribution using a Streamline Coordinate System
- DEVELOPMENT AND MIXING CHARACTERISTICS OF FOLDING ANCHOR IMPELLER FOR ROUND-BOTTOMED FLASK
- PARTICLE-IMPELLER IMPACT FOR A SIX BLADED 45°PITCHED TURBINE IN AN AGITATED VESSEL
- EFFECT OF PARTICLE-IMPELLER IMPACT RATE ON PROPERTIES OF PRODUCT CRYSTALS IN AGITATED CRYSTALLIZERS OF DIFFERENT SIZES
- Structural Characterization of the Gene for Human Histidine-Rich Glycoprotein, Reinvestigation of the 5'-Terminal Region of cDNA and a Search for the Liver Specific Promoter in the Gene
- Numerical Processing of a Visualized Streak Line Image using a Streamline Coordinate System
- Fabrication of a Microevaporator Equipped with a Piezoelectrically-Driven Diaphragm Pump
- A NEW GROWTH KINETIC MODEL FOR PHOTO-AUTOTROPHIC MICROALGAE CULTURE
- Mass Transfer Characteristics by Surface Aeration of Large Paddle Impeller : Application to a Polymerization Reactor with Liquid Level Change
- Numerical Analysis of an Axisymmetric Jet Using a Streamline Coordinate System
- EFFECT OF SIZE OF SPHERICAL PARTICLE ON COMPLETE SUSPENSION SPEED IN AGITATED VESSELS OF DIFFERENT SCALE
- A STUDY OF THE AGITATION SPEED TO JUST CAUSE COMPLETE SUSPENSION FOR NON-SPHERICAL PARTICLES
- Development of a Simulator for the Fuel Injecton Sysem of a Diesel Engine
- Improvement of Static Fatigue Strength of Silicon Nitride Composite Crack-Healed under Cyclic Stress(International Workshop on Smart Materials and Structural Systems, W03 Jointly organized by Material & Processing Division, Material & Mechanics Division,
- Biotransformation of Isoflavones by the Larvae of the Common Cutworm (Spodoptera litura)
- MIXING OF HIGHLY VISCOUS NEWTONIAN LIQUID IN A HELICAL RIBBON AGITATED VESSEL AT VARIOUS LIQUID DEPTHS
- Control of Collagen Molecular Assembly with Anionic Polysaccharides
- Distribution of Solid Particles Lighter than Liquid in an Agitated Vessel Stirred by Dual Impellers
- 酢酸セルロース-ジルコニア複合ゲル繊維へのウレアーゼの包括固定化
- LOCAL GAS HOLDUP AND GAS RECIRCULATION RATE IN AN AERATED VESSEL EQUIPPED WITH A RUSHTON TURBINE IMPELLER
- Effect of Impeller Blade Angle on Power Consumption and Flow Pattern in Horizontal Stirred Vessel
- A new methodology to guarantee the structural integrity of ceramics components