Development of a miniature motor-driven pulsatile LVAD driven by a fuzzy controller
スポンサーリンク
概要
- 論文の詳細を見る
- 2007-09-01
著者
-
Okamoto Eiji
Hokkaido Tokai Univ. Sapporo Jpn
-
MITAMURA Yoshinori
Graduate School of Information Science and Technology, Hokkaido University
-
INOUE Yusuke
Graduate School of Information Science, Hokkaido University
-
Makino Tsutomu
Department Of Information Science School Of Engineering Hokkaido Tokai University
-
Yasuda Takahiko
Department Of Information Science School Of Engineering Hokkaido Tokai University
-
Tani Makiko
Department Of Information Science School Of Engineering Hokkaido Tokai University
-
Tanaka Shuji
Department Of Nanomechanics Tohoku University
-
Okamoto Eiji
Department Of Information Science School Of Engineering Hokkaido Tokai University
-
Mitamura Y
Graduate School Of Information Science And Technology Hokkaido University
-
Mitamura Yoshinori
Graduate School Of Information Science And Technology Hokkaido University
-
Mitamura Yoshinori
Department Of Human Science And Informatics School Of Bioscience And Engineering Tokai University
-
Yasuda Takahiko
Department Of Hematology Japanese Red Cross Nagoya First Hospital
-
AKASAKA Yuta
Department of Information Science, School of Engineering, Hokkaido Tokai University
-
MITOH Ayumu
Tomakomai College of Technology
-
Inoue Yusuke
Department Of Biomedical Engineering Graduate School Of Medicine The University Of Tokyo
-
Okamoto Eiji
Department Of Computer Science And Engineering Graduate School Of Engineering Nagoya Institute Of Te
-
Akasaka Yuta
Department Of Information Science School Of Engineering Hokkaido Tokai University
-
Tanaka Shuji
Department Of Information Electronics Faculty Of Engineering Fukuoka Institute Of Technology
-
Mitamura Yoshinori
Department Of Human Science And Informatics School Of Biological Science And Engineering Tokai Unive
-
Tanaka Shuji
Department Of Electronics Faculty Of Engineering Fukuoka Institute Of Technology
-
Tanaka Shuji
Department of Electronic Materials Engineering, Fukuoka Institute of Technology,
-
Mitamura Yoshinori
Graduate School of Engineering, Hokkaido University
-
TANAKA Shuji
Department of Chemistry, Faculty of Science, Kyushu University
関連論文
- Correlation Between Left Ventricular Diastolic Function and Ejection Fraction in Dilated Cardiomyopathy Using Magnetic Resonance Imaging With Late Gadolinium Enhancement
- Outcome of allogeneic bone marrow transplantation from unrelated donors for adult Philadelphia chromosome-negative acute lymphocytic leukemia in first complete-remission
- Preparation of Thin Lithium Niobate Layer on Silicon Wafer for Wafer-level Integration of Acoustic Devices and LSI
- Establishment of in silico systems to predict the effects of genetic polymorphism on the enzymatic activity of cytochrome P450
- Risk and Protective Factors Related to Mortality from Pneumonia among Middle-aged and Elderly Community Residents : The JACC Study
- A nonpulsatile total artificial heart with 1/R control
- Application of Screen-Printed Catalytic E1ectrodes to MEMS-Based Fuel Cells (特集:燃料電池を支えるMEMS/NEMS技術)
- Serologically HLA-DR-Mismatched Unrelated Donors Might Provide a Valuable Alternative in Allogeneic Transplantation : Experience from a Single Japanese Institution
- Introducer Needles of Peripheral Intravenous Catheters : Assessment of Magnetic Field Interactions with 1.5T and 3T MR Systems
- Three-dimensional stereotactic surface projection of brain perfusion SPECT improves diagnosis of Alzheimer's disease
- Optimised Versions of the Ate and Twisted Ate Pairings
- Debris-Free Laser-Assisted Low-Stress Dicing for Multi-Layered MEMS : Separation Method of Glass Layer
- Micro-Nano Electro Mechanical Systems
- Vertical Diaphragm Electrostatic Actuator for a High Density Ink Jet Printer Head
- Mode-Locked Fiber Lasers Using Adjustable Saturable Absorption in Vertically Aligned Carbon Nanotubes
- Debris-free Low-stress High-speed Laser-assisted Dicing for Multi-layered MEMS
- Debris-Free High-Speed Laser-Assisted Low-Stress Dicing for Multi-Layered MEMS
- THE P53 GENE STATUS AND OTHER CELLULAR CHARACTERISTICS OF HUMAN CELL LINES MAINTAINED IN OUR LABORATORY
- Numerical estimation of heat distribution from the implantable battery system of an undulation pump LVAD
- Estimation of ^Tc-MAG3 clearance by single-sample methods and camera-based methods
- Breast parenchymal activity on scintimammography : Comparison between bone-seeking agents and ^Tc-sestamibi
- Deadtime of a Single-crystal Gamma Camera in Abdominal Imaging
- Electrostatically Controlled, Pneumatically Actuated Microvalve with Low Pressure Loss
- MEMS-Based Solid Propellant Rocket Array Thruster with Electrical Feedthroughs
- Diffusion and Electrical Properties of Iron-Related Defects in N-Type Silicon Grown by Czochralski- and Floating Zone Method
- Iron-Related Donor Level in N-Type Silicon
- Investigation of Ni Induced Deep Levels in N-Type Si by a Temperature Dependence of Piezoelectric Photothermal Signals
- Design and Fabrication of Passive Wireless SAW Sensor for Pressure Measurement
- Modulation of Carbachol-Induced Cl^- Currents and Fluid Secretion by Isoproterenol in Rat Submandibular Acinar Cells
- Role of Calcium Ions in the Potentiation by Isoproterenol of Carbachol-Induced Ionic Currents and Secretion Activity in Rat Salivary Glands
- In-Diffusion and Annealing Processes of Substitutional Nickel Atoms in Dislocation-Free Silicon
- Aromatic Allylsulfenylation with in Situ Generated Allylic Thiols under the Heck Conditions
- Aromatic Allylsulfenylation with in Situ Generated Allyl Thiols under the Heck Conditions
- Silver(I)-Catalyzed Aminocyclization of 2,3-Butadienyl and 3,4-Pentadienyl Carbamates : An Efficient and Stereoselective Synthesis of 4-Viny-2-oxazolidinones and 4-Vinyltetrahydro-2H-1,3-oxazin-2-ones
- COMPARISON OF AGING AND IMMORTALIZATION PROCESS OF CELLS DERIVED FROM BRAINS OF NEWBORN AND OLD RATS
- MEMS-based Air Turbine with Radial-inflow Type Journal Bearing
- Fabrication of Anti-Corrosive Capacitive Vacuum Sensors with a Silicon Carbide/Polysilicon Bi-Layer Diaphragm and Electrical Through-Hole Connections on the Opposite Side
- Acupuncture-induced cerebral blood flow responses in dystonia
- Prognostic Significance of Right Ventricular Dimension on Acute Decompensation in Chronic Left-Sided Heart Failure
- PEUTZ-JEGHERS SYNDROME ASSOCIATED WITH RENAL AND GASTRIC CANCER THAT DEMONSTRATED AN STK11 MISSENSE MUTATION
- Fabrication of Deep Silicon Microstructures by the Combination of Anodization and p^ Etch Stop
- Gamma/Delta T Cell Lymphoma
- Reproducibility of Short Echo Time Proton Magnetic Tesonance Spectroscopy using Point-resolved Spatially Localized Spectroscopy Sequence in Normal Human Brains
- Local Recurrence of Breast Cancer Demonstrated on ^Tc-MIBI Scintigraphy
- Physical Characteristics of Dose Calibrator
- Effect of the Distribution of Radioactive Sources on Deadtime Loss in a Single-Crystal Gamma Camera
- Distribution of Electrically Active Nickel Atoms in Dislocation-Free N-and P-Type Silicon Crystals Measured by Deep Level Transient Spectroscopy
- History of blood transfusion before 1990 is associated with increased risk for cancer mortality independently of liver disease : a prospective long-term follow-up study
- ON THE SUPERCOOLED DRIZZLE OBSERVED AT INUVIK IN THE MID-WINTER SEASON (WANTS-ARCTIC; CANADA)
- An Evaluation on Throughput Performance for Type II Hybrid-ARQ Using Non-binary Rate-Compatible-Punctured LDPC Codes
- Basic study of a transcutaneous information transmission system using intra-body communication
- Carbon-Nanotube-Enhanced Thermal Contactor in Low Contact Pressure Region
- A Comparative Study on Time Domain Sequential Equalizer with MLD and MLSE Equalizer on MIMO Frequency Selective Channels
- Development of a miniature motor-driven pulsatile LVAD driven by a fuzzy controller
- Effect of Recirculation of^Tc-Sn Colloid in Estimating Mean Transit Time of Soft-Tissue Vascular Anomalies by Direct Puncture Scintigraphy: A Simulation Analysis
- Computer assisted design for the implantable left ventricular assist device (LVAD) blood pump using computational fluid dynamics (CFD) and computer-aided design and manufacturing (CAD/CAM)
- Feasibility of a remote monitoring system for patients with an implantable left ventricular assist device using Personal Handy-Phone System telecommunication technology
- Printing Sub-100 Nanometer Features Near-field Photolithography
- Efficient Content Replication Strategy for Data Sharing Considering Storage Capacity Restriction in Hybrid Peer-to-Peer Networks
- Application of Wavelet Packet Modulation to Mobile Communication(Wide Band Systems)
- A Shape-Directed Scaling Method for Fundus Image with Maintenance to Blood-Vessel Shapes and Color Reality
- A magnetic fluid seal for rotary blood pumps
- Phase I clinical study of NMK36 : a new PET tracer with the synthetic amino acid analogue anti-[^F]FACBC
- Design of a miniature implantable left ventricular assist device using CAD/CAM technology
- In-Diffusion and Isothermal Annealing of Iron-Related Defects in Czochralski N-Type Silicon
- Automatic calibration of the inlet pressure sensor for the implantable continuous-flow ventricular assist device
- A magnetic fluid seal for rotary blood pumps : effects of seal structure on long-term performance in liquid
- Physicians' recommendations to their patients concerning a novel pandemic vaccine : a cross-sectional survey of the 2009 influenza A/H1N1 pandemic in Japan
- Scalar Multiplication on Pairing Friendly Elliptic Curves
- Use of an oral effervescent agent in the evaluation of gastric ^Ga uptake
- MEMS-Based Fuel Reformer with Suspended Membrane Structure
- Interface of data transmission for a transcutaneous communication system using the human body as transmission medium
- For what am I participating? : The need for communication after receiving consent from biobanking project participants : experience in Japan
- An Effective Downlink Resource Allocation Scheme Based on MIMO-OFDMA-CDM in Cellular System
- Interstitial MR Lymphography in Mice : Comparative Study with Gadofluorine 8, Gadofluorine M, and Gadofluorine P
- A Note on the Pairing Computation Using Normalized Miller Functions
- EORTC QLQ-BM22 and QLQ-C30 quality of life scores in patients with painful bone metastases of prostate cancer treated with strontium-89 radionuclide therapy
- An Effective Downlink Resource Allocation Scheme Based on MIMO-OFDMA-CDM in Cellular System
- Distribution of Substitutional Nickel Atoms in Dislocated Silicon Crystal
- Charging Method of Micropatterned Electrets by Contact Electrification Using Mercury
- Majority-Carrier Capture Cross Section of Amphoteric Nickel Center in Silicon Studied by Isothermal Capacitance Transient Spectroscopy
- In-Diffusion and Isothermal Annealing of Iron-Related Defects in n-Type Silicon
- Low-Stress Epitaxial Polysilicon Process for Micromirror Devices
- Diffusion-weighted Imaging of the Breast: Comparison of B-values 1000 s/mm2 and 1500 s/mm2
- Implementation of an Elliptic Curve Scalar Multiplication Method Using Division Polynomials
- Specificity of Prunus Aminopeptidase toward Peptide Substrates
- Substrate Specificity of a Proline Iminopeptidase from Apricot Seeds
- Vacuum test of a micro-solid propellant rocket array thruster
- The helical flow pump with a hydrodynamic levitation impeller
- Alkaline-developable and Positive-type Photosensitive Polyimide based on Fluorinated Poly(amic acid) from Diamine with High Hydrophobicity and Fluorinated Diazonaphtoquinone