High Ozone Generation with a High-Dielectric-Constant Material
スポンサーリンク
概要
- 論文の詳細を見る
An optimum-dielectric-constant material with a fixed size was experimentally obtained for high ozone generation in a parallel-plate barrier discharge. The ozone production rate as a function of dielectric constant was found to depend strongly on discharge voltage. The ozone production rate for strontium titanium oxide (SrTiO3) with high dielectric constant of approximately 300 was the highest among various existing dielectric materials under low discharge voltage (root-mean-square value) of 1.2 kV, while for titanium oxide (TiO2) with dielectric constant of about 100, the highest ozone production efficiency was obtained at a wide range of discharge power and/or ozone concentration.
- Published by the Japan Society of Applied Physics through the Institute of Pure and Applied Physicsの論文
- 2004-07-15
著者
-
Ohtsu Yasunori
Department Of Electrical & Electronic Engineering Saga University
-
Toyofuku Masaharu
Department Of Electrical And Electronic Engineering Saga University
-
Fujita Hiroharu
Department Of Electrical & Electronic Engineering Saga University
-
Ohtsu Yasunori
Department of Electrical and Electronic Engineering, Saga Univerity, 1 Honjo-machi, Saga 840-8502, Japan
-
Fujita Hiroharu
Department of Electrical and Electronic Engineering, Saga Univerity, 1 Honjo-machi, Saga 840-8502, Japan
-
Toyofuku Masaharu
Department of Electrical and Electronic Engineering, Saga Univerity, 1 Honjo-machi, Saga 840-8502, Japan
関連論文
- High-Density Radio-Frequency Plasma Sources Produced by Capacitive Discharge with Various Methods for Thin-Film Preparation
- Spatial Behavior of the Plasma Potential in a Magnetized Radio-Frequency Discharge from Emissive Probe Data(Gases, plasmas, electric discharges, and beams)
- Characteristics of Microwave Plasma and Preparation of a-Si Thin Film
- Influence of Substrate Biasing on (Ba, Sr)TiO_3 Films Prepared by Electron Cyclotron Resonance Plasma Sputtering
- Measurement of Electron Energy Distribution Function in a Low-Pressure rf Discharge Plasma
- CF_3, CF_2 and CF Radical Measurements in RF CHF_3 Etching Plasma Using Infrared Diode Laser Absorption Spectroscopy ( Plasma Processing)
- Influence of Applying Bias Voltage on Diamond Nucleation while Changing the Experimental Condition
- Ar/O_2 gas pressure dependence of atomic components of zirconia prepared by intermittent zirconium arc PBII&D
- Characteristics of Hole Plasma in the Presence of Ion Beam Injection
- Temporal Behavior of Charged Particles in a Radio Frequency Afterglow Plasma Containing Negative Ions
- Ion Collection by a Hollow Probe in ECR Microwave Plasma under a Divergent Magnetic Field
- High-density radio-frequency plasma sources produced by capacitive discharge with various methods for thin-film preparation (特集 日本のプラズマ研究最前線)
- Inductively Coupled Plasma by means of a Novel External Antenna
- Dust Particles Levitation near a Powered Electrode in a Capacitively Coupled RF Plasma
- Influence of Xe Gas Concentration on Plasma Parameters and Luminance Characteristics in Fluorescent Lamps driven by an Inductively Coupled Radio Frequency Discharge Using Ne / Xe Mixture Gases
- Development of Compact Ozonizer by Barrier Discharge for High Concentration Ozone Generation
- Energy Distribution Functions of Ions Impacted on a Negatively Biased Substrate in an Electron Cyclotron Resonance Microwave Plasma
- Potential Structure of Positively Biased Oscillating Substrate in a Low Pressure Plasma
- Sheath structure of the oscillating substrate in a collisionless plasma
- Conformal Deposition of High-Purity Copper Using Plasma Reactor with H Atom Source
- V-Shaped Potential Distribution with a Virtual Cathode Generated by an Electron Beam Injection
- An Influence of a Heating Voltage on an Emissive Probe Characteristic in a Plasma
- Reduction of Electron Temperature in rf Plasma Using Magnetic Filter
- Measurements of Ion Temperature by Langmir Probes in a Non-Magnetized Plasma
- Measurements of Fast Time Evolutions of Plasma Potential Using Emissive Probe
- Influence of Electron-Beam Injection on Pre-Discharge State in a Low Pressure Gas
- Downstream Ion Energy Control in Negative Ion Plasma Produced by a Helical Antenna
- Downstream Control of Negative-Ion Plasma Parameters in Helicon Discharge
- Negative Ion Plasma Production Using Immersed Type Antenna in a Magnetic Field
- Propagation of Free-Streaming Ions and Ion Bursts Excited by a Grid in a Plasma
- RF Potential Formation in Electronegative Plasma Columu under a Magnetic Field
- An Analysis of Spherical Langmuir Probe Characteristics in a Collisionless Plasma
- Ultra-Water Repellency of Films Prepared by Capacitively Coupled C2H2F2/Ar Discharge Plasma
- Observation of an Inductively Coupled RF Discharge with One-Turn Internal Antenna
- Annular Profile of Dust Density near RF-Powered Electrode in a Capacitively Coupled Plasma
- Mode conversion of RF discharge in plasma driven by helical or spiral type antennas
- Measurements of Ion Energy Distribution Functions in an Radio Frequency Plasma Excited with an m = 0 Mode Helical Antenna and Thin Film Preparation
- Characteristics of Nucleation Using the Bias-Enhanced Nucleation Method at Low Pressure
- Potential Oscillations in an Electronegative Plasma Driven by an Asymmetry RF Discharge
- Influences of Gap Distance on Plasma Characteristics in Narrow Gap Capacitively Coupled Radio-Frequency Discharge
- Time-Averaged Energy Distribution Function of Ions Impacted on an RF-biased Substrate in Electron Cyclotron Resonance Microwave Plasma
- Energy Distribution of Ions Incident onto a Dc-Biased Substrate in Electron Cyclotron Resonance Sputtering Plasma for SrTiO3 Thin Film Preparation
- High Ozone Generation with a High-Dielectric-Constant Material
- Downstream Control of Negative-Ion Plasma Parameters in Helicon Discharge