Plasma Properties and Ion Energy Distribution in DC Magnetron Sputtering Assisted by Inductively Coupled RF Plasma
スポンサーリンク
概要
- 論文の詳細を見る
It is generally considered that an inductively coupled plasma (ICP) assisted magnetron sputtering allows independent control of the incident ion flux and its energy at the substrate. Some previous works, however, show that variation of the RF power induces changes in both the ion flux and its energy if an internal metallic coil antenna is used. In this study, we have applied an internal coil antenna with dielectric insulation, and plasma properties as well as ion energy distribution have been investigated by varying the RF power and the sputtering current. The incident ion flux was enhanced significantly by the addition of an ICP and exhibited a relatively narrow energy spread. Ion energy at the grounded substrate was found to be determined by the plasma potential and did not change markedly while increasing the RF power. These results enable us to independently adjust the incident ion flux and its energy by varying the RF power and the bias voltage to the substrate, respectively.
- Published by the Japan Society of Applied Physics through the Institute of Pure and Applied Physicsの論文
- 2003-11-15
著者
-
Li Zhuguo
Joining And Welding Research Institute Osaka University
-
Miyake Shoji
Joining & Welding Resarch Institute Osaka University
-
Mori Masakazu
Joining and Welding Research Institute, Osaka University, 11-1 Mihogaoka, Ibaraki, Osaka 567-0047, Japan
関連論文
- Low Temperature Millimeter-Wave Sintering of Aluminum Nitride with Oxide Additive of CaO-Al_2O_3-Yb_2O_3 System
- OS8(P)-28(OS08W0211) A Study on the Mechanical Properties of Silicon Nitride Ceramics Sintered by 28GHz Millimeter-Wave Heating Method
- Effects of Ion-Beam-Irradiation on Morphology and Densification of CeO_2 Films Prepared by Ion-Beam-Assisted Deposition
- Influence of Substrate Biasing on (Ba, Sr)TiO_3 Films Prepared by Electron Cyclotron Resonance Plasma Sputtering
- Morphology and Microstructure of Hard and Superhard Zr-Cu-N Nanocomposite Coatings
- Zr-based Hydrogen Absorbing Films Prepared by Ion Beam Assisted Deposition(Physics, Processes, Instruments & Measurements)
- Tribological Property of CeO_2 Films Prepared by Ion-Beam-Assisted Deposition
- Hydroxyapatite Coating on Titanium Plate with an Ultrafine Particle Beam
- Influence of Phase Change in Intergranular Oxides to Thermal Conductivity of AIN Sintered by Millimeter-Wave Heating
- Influence of RF Power Supply on ElEctron-Cyclotron-Resonance Plasma with Mirror Confinement for SrTiO_3 Thin Film Formation
- Examination of Meek's Model for Microwave Sintering Mechanism (特集 電磁エネルギー焼結)
- Formation of Carbon Nitride Films by Helicon Wave Plasma Enhanced DC Sputtering
- Decomposition Rate of Si_3N_4 during Microwave Sintering
- Ion Assisted Deposition of Crystalline TiNi Films by electron Cyclotron Resonance Plasma Enhanced Sputtering
- Characteristics of an ECR Plasma Sputtering Source at Low Ar/N_2 Gas Pressures for Thin Film Synthesis
- Studies on Magnetron Sputtering Assisted by Inductively Coupled RF Plasma for Enhanced Metal Ionization
- Inductively-Coupled-Plasma-Assisted Planar Magnetron Discharge for Enhanced Ionization of Sputtered Atoms
- Kinetics of Densification and Phase Transformation at Microwave Sintering of Silicon Nitride with Alumina and Yttria or Ytterbia as Additives (特集 放電焼結の基礎と応用)
- Production of Inductively-Coupled Large-Diameter Plasmas with Internal Antenna
- Application of Millimeter-Wave Heating to Materials Processing(Recent Trends on Microwave and Millimeter Wave Application Technology)
- Fabrication of Bulk Ceramics by High-Power Millimeter-Wave Radiation
- Measurements of Ion Energy Distribution Functions in an Radio Frequency Plasma Excited with an m = 0 Mode Helical Antenna and Thin Film Preparation
- Energy Distribution of Ions Incident onto a Dc-Biased Substrate in Electron Cyclotron Resonance Sputtering Plasma for SrTiO3 Thin Film Preparation
- Hydroxyapatite Coating on Titanium Plate with an Ultrafine Particle Beam
- Millimeter-Wave Annealing of SrBi2Ta2O9 Films Prepared by Sol–Gel Method
- Structure and Properties of Ti–Si–N Films Deposited by dc Magnetron Cosputtering on Positively Biased Substrates
- Tribological Property of CeO2 Films Prepared by Ion-Beam-Assisted Deposition
- Studies on Magnetron Sputtering Assisted by Inductively Coupled RF Plasma for Enhanced Metal Ionization
- Plasma Properties and Ion Energy Distribution in DC Magnetron Sputtering Assisted by Inductively Coupled RF Plasma