Structural Diagrams and Phase Reactions of Fe-Cr-N Ternary System
スポンサーリンク
概要
- 論文の詳細を見る
Isothermal structural diagrams of Fe-Cr-N system in the range of composition from 0 to 40% chromium and up to 1% nitrogen were described at various temperatures below 1300℃. From the considerations on the phase relationship and the phase reaction, the structural diagrams were also obtained with various cross-sections at 0.1, 0.2 and 0.3% nitrogen, and 7, 13, 18 and 26% chromium. In this ternary system, the existence of the following three invariant reactions was presumed : (1) L+α〓γ+Cr_2N at about 1330℃, (2)γ+Cr_2N〓α+CrN at about 790℃ and (3)γ+CrN〓α+Fe_4N at about 760℃.
- 東北大学の論文
著者
-
IMAI Yunoshin
The Research Institute for Iron, Steel and Other Metals
-
MASUMOTO Tsuyoshi
The Research Institute of Electrical and Magnetic Materials
-
Imai Yunoshin
The Research Institute For Iron Steel And Other Metals
-
Masumoto Tsuyoshi
The Research Institute For Iron Steel And Other Metals
-
MAEDA Keikichi
The Research Institute for Iron, Steel and Other Metals
-
Maeda Keikichi
The Research Institute For Iron Steel And Other Metals
-
Masumoto Tsuyoshi
The Research Development Corporation Of Japan:the Research Institute For Iron Steel And Other Metals
関連論文
- Residual Stress in Steel Due to Heat Treatment
- Effect of Cyclic Heat-Treatments on the Martensitic Transformation in Iron-Nickel Binary Alloys
- Random Anisotropy Model for Nanocrystalline Soft Magnetic Alloys with Grain-Size Distribution
- Development of Common Mode Choke Coil Made of New Nanocrystalline Soft Magnetic Alloy "NANOPERM^[○!R]"
- High Mechanical Strength of Al-(V, Cr, Mn)-(Fe, Co, Ni)Quasicrystalline Alloys Prepared by Rapid Solidification
- Faceted Etch Pits Formed on Surfaces of an Icosahedral Al_Pd_Mn_ Quasicrystal
- New Class of Amorphous and Icosahedral Phases in Zn-Mg-Rare-Earth Metal Alloys
- Magnetic Properties and Phase Stability of Icosahedral Al-Pd-Mn-B Quasicrystals
- Novel Face-Centered Icosahedral Phase in Al-Mg-Li System
- Temperature Dependence of Hardness and Expansion in an Icosahedral Al-Pd-Mn Alloy
- Crystallization-Induced Phason Relaxation in Icosahedral Al-Pd-Mn Alloys
- Compositional Effect on the Two-Stage Enthalpy Relaxation of Metal-Metalloid Amorphous Alloys upon Annealing
- Superconducting Properties of Metastable bcc Solid Solution in Melt-quenched Zr-Ge Binary Alloys
- Young's Modulus of Fe-Si-B Amorphous Wires
- The Critical Thickness for the Formation of Fe-, Ni- and Co-Based Amorphous Alloys with Metalloids
- Formation Range, Mechanical Properties and Thermal Stability of Superconducting Zr-Si Amorphous Alloys
- Formation of Metastable Phases in the Zr -Al System by Electron Beam Deposition
- Layered Structure and Superconducting Properties of Ag-Sheathed Bi_Pb_Sr_2Ca_2Cu_3O_y Wires Prepared by Combined Jellyroll and Hotextrusion Technique
- Formation of Glassy Pd-Ni-P Alloys by Mechanical Alloying and Their Structure and Thermal Stability
- Mossbauer Effect of Decagonal and Amorphous Phases in Al-Ni-Fe System
- Effect of Additional Cu Element on Structure and Crystallization Behavior of Amorphous Fe-Nb-Si-B Alloys
- Phason Strains and Periodicity in Al-Ru-Cu Icosahedral Quasicrystals
- Magnetic Properties of Fe-Based Binary Crystalline Alloys Produced by Vapor Quenching
- Electrical Resistance and Magnetoresistance in Quasi-Crystalline and Amorphous Al-Mn Alloys
- Preparation of Amorphous Metallic Powder
- Amorphization by Compound-Element Milling in Al- TM(TM=Mn, Fe, Co and Ni) Binary System
- Formation, Thermal Stability and Mossbauer Effect of Amorphous, Quasicrystalline and Crystalline Phases in Al-(Cu, Ni)-Fe Systems
- Production of Amorphous Alloy Balloons by Utilizing Viscous Flowability
- Space Group Determination of Decagonal Quasicrystals of an Al_Ni_Fe_ Alloy Using Convergent-Beam Electron Diffraction
- Interface Stability, Growth and Morphology in Icosahedral Quasi Crystals
- Quasicrystals As a Hume-Rothery Phase : An Empirical Approach((B)Quasicrystals)
- Quasicrystals in Al-Pd-TM (TM=Transition Metal) Systems Prepared by Rapid Solidification
- Al-Ge-Mn and Al-Cu-Ge-Mn Quasi-Crystals with Coercivity at Room Temperature : Condensed Matter
- Production of Bi-Sr-Ca-Cu-O Glasses by Liquid Quenching and their Glass Transition and Structural Relaxation : Condensed Matter
- Effects of Substrate Temperature and Heat Treatment on GMR Properties of Co-RE-O Nano-granular Films
- High-Strain-Rate Superplasticity due to Newtonian Viscous Flow in La_Al_Ni_ Metallic Glass
- Stress Overshoot in Stress-Strain Curves of Zr_Al_Ni_Cu_ Metallic Glass
- Molecular Dynamics Study of Structural and Dynamical Properties of Zr_xNi_ (x=0〜100) Amorphous and Liquid Alloys
- Molecular Dynamics Simulation of Phase Separation in Lennard-Jones Liquids
- Molecular Dynamics Study for Structure and Dynamics of Amorphous and Liquid Zr_Ni_ Alloys
- Upper Critical Fields on High Temperature Superconductivity in La-Sr-Cu-O System
- Effect of Temperature and Deformation on the Structure of Amorphous Metals
- Powder-Forming Tendency of Nonequilibrium Phases in Fe-C-X (X=Cr, Mo, W, Al or Si) Alloys by Comminution and Microstructure and Hardness of Their Sintered Compacts
- Rapidly Solidified Powder Metallurgy Mg_Zn_1Y_2Alloys with Excellent Tensile Yield Strength above 600 MPa
- Nanocrystalline Soft-Magnetic Fe-Zr-B-Cu Composites by Consolidation of Amorphous Powders Coated with Oxide Film through Sol-Gel Process
- Soft Magnetic Properties of Bulk Nanocrystalline Fe-(Zr, Hf)-B Alloys Produced by Extruding Amorphous Powders
- Soft-Magnetic Properties of Nanocrystalline Fe-Zr-B-Ni Bulk Alloy Produced by Warm Extrusion
- Thermal, Mechanical and Physical Properties of Supercooled Liquid in Pd-Cu-Ni-P Amorphous Alloy
- High T_c Superconductivity of a Melt-Spun Er_1Ba_2Cu_3 Oxide Ribbon
- Hydrogenation of Amorphous and Crystalline Gd-Co Alloys
- Dynamic Compaction of Amorphous Co_Fe_Si_B_ Alloy Powders Obtained by a Cavitation Method
- Delayed Fracture of Amorphous Alloys in Atmosphere
- Crystallization Behavior of Amorphous High-Carbon Alloy Steels
- Nonequilibrium Phases in Melt-Quenched Co-W-C Alloys and Their Powder-Forming Tendency by Comminution
- Structural Diagrams and Phase Reactions of Fe-Cr-N Ternary System
- Microstructures and Nitrides of Fe-Cr-N Ternary System
- High Frequency Core Loss and Initial Permeability of Ferromagnetic Amorphous Ribbons
- Magnetostriction of Fe-Co Amorphous Alloys
- Ti-Nb-Si Amorphous Alloys for Application to Diaphragm in Watches
- The Structure of Amorphous Iron-Phosphorus Alloys
- Structural Study of an Amorphous Liquid-quenched Ni_-P_ Alloy
- Effects of Alloying Elements on the Corrosion Behavior of Amorphous Cobalt-Base Alloys
- Effect of Molybdenum on the Corrosion Behavior of Amorphous Fe-Mo-C alloys in 1N HCl
- Effect of Nickel on the Solubility and Diffusion of Nitrogen in Alpha-Iron
- Study on A_3 Transformation of Dispersion-Strengthened Iron
- Mechanical and Physical Properties of Dispersion-Strengthened Iron
- Self-Diffusion in Single Crystal of Silver Containing Alumina Particles
- Studies on the Yield Strength of Dispersion Strengthened Alloys
- Pressure Dependence of Hydrogen-Induced Amorphization in C15 Laves Phases TbM_2 (M=Fe, Co and Ni)
- Amorphization of D0_ Intermetallics by Hydrogenation
- High T_c Superconductor Prepared by Oxidization of a Liquid-Quenched Yb_1Ba_2Cu_3 Alloy Foil in Air
- Influence of Hydrogenation on the Magnetic Properties of Gd-Co Amorphous Alloys
- Hydrogenation of Amorphous and Crystalline RE-Ni Alloys
- Thermal, Magnetic and Electrical Properties of Mn-Metalloid Amorphous Ribbons
- The Magnetic and Electric Properties of (Co_ Mn_x)_2B Crystalline compounds and Amorphous Alloys
- Pressure Effects on the Curie Temperature and Electrical Resistance of Fe-based Amorphous Alloys
- Formation of a Nanoscale hcp Structure by Crystallization of an Amorphous Co_Zr_7B_2 Alloy
- Effects of Alloying Element on Supercooled A_3 Transformation of Iron
- Effect of Cooling Rate on A_3 Transformation Temperatures of Iron and Iron-Nickel Binary Alloys
- Thermodynamic Study on the Transformation of Austenite into Martensite in Iron-High Nitrogen and Iron-Carbon Binary System
- Sub-Zero Treatment of Quenched Steel. I : On the Stabilization of Retained Austenite
- The Precipitation of χ-carbide in the Tempering Process of High Carbon Steels
- Transformation of Retained Austenite and Observation of Cracks under Low-Cycle Fatigue Testing
- Solubility of Nitrogen in Austenitic Iron under High Nitrogen Pressure and Thermodynamic Properties of Iron-Nitrogen Interstitial Solid Solution
- Development of High Temperature and High Pressure Equipment for Study of Reaction between Gas and Metals, and Some Experimental Results
- Structural Diagrams and Solid Phase Reactions of the Quaternary 7% Cr-Fe-C-N System
- Structural Diagrams and Phase Reactions of the Quaternary 12%Cr-Fe-C-N System
- Constitutional Diagrams of Iron-Rich Corner in 18% Cr-Fe-C-N System
- The Temperature and Stress Dependences of the Steady-State Creep Rate of Ferritic Iron-Chromium Alloys
- Nitrogen as the Alloying Element in Steels. I : On the Effect of Nitrogen on the Temper-Brittleness in Steels
- Study of the Mechanical Properties of the Unnotched and Notched Specimens under High Speed Impact-Bending
- X-ray Investigation of Low-Cycle Fatigue in Martensitic Steels
- Isothermal Martensitic Transformation in Fe-Ni-Cr Alloy
- Precipitation of Carbides in 12% Cr Steel during Tempering
- The Effects of Grain Size and Precipitate on Strength of Nb-Treated Steels
- Precipitation Behaviours of Austenitic Steel of Manganese-Chromium Type Containing Vanadium
- Anomalous Contraction near 500℃ in Austenitic Heat-Resisting Alloys Containing Chromium and Nickel
- Determination of Condition for Electrolytic Extractions of Nitrides in Steel by Means of Potentiostat
- Nitrogen as Alloying Element in Steels. II : On the Effect of Nitrogen on Blue-Brittleness in Steels
- An Investigation on Isothermal Transformation in Steels. I : The Cause of Modification of S-Curves of Some Alloy Steels