Effect of Cooling Rate on A_3 Transformation Temperatures of Iron and Iron-Nickel Binary Alloys
スポンサーリンク
概要
- 論文の詳細を見る
Effects of cooling rate on A_3 points of a few pure irons, iron-low carbon alloys and iron-nickel alloys have been examined at cooling rates between 100℃/sec and 60, 000℃/sec by using a gas quench apparatus. A_3 point of iron containing less than 0.003 wt% C falls gradually with the increase in cooling rate and continuously approaches a fixed temperature (maximum supercooled A_3), but in the iron containing more than 0.006 wt% C it falls discontinuously to the Ms temperature at the cooling rate of about 20, 000℃/sec. Maximum supercooled A_3 points of these irons are affected seriously by a very small content of carbon below 0.005 wt% C, falling remarkably from about 720℃ at 0.001 wt% C to about 650℃ at 0.003 wt% C with increasing carbon content. In the case of iron-nickel alloys it falls with increasing cooling rate and discontinuously by about 100℃ at a certain cooling rate which depends on the nickel content. The drop of the transformation temperature is independent of a further cooling rate. The critical cooling rate decreases from about 25, 000℃/sec at 1% Ni to about 2, 000℃/sec at 20% Ni. The Ms points of these alloys are in agreement, at higher nickel concentrations, with those reported previously, but are displaced to a lower temperature side at lower nickel concentration.
- 東北大学の論文
著者
-
IMAI Yunoshin
The Research Institute for Iron, Steel and Other Metals
-
IZUMIYAMA Masao
The Research Institute for Iron, Steel and Other Metals
-
Izumiyama Masao
The Research Institute For Iron Steel And Other Metals
-
Tsuchiya Masayuki
The Research Institute For Iron Steel And Other Metals
-
Imai Yunoshin
The Research Institute For Iron Steel And Other Metals
関連論文
- Residual Stress in Steel Due to Heat Treatment
- Effect of Cyclic Heat-Treatments on the Martensitic Transformation in Iron-Nickel Binary Alloys
- Effect of Micro-Structure on Creep of 25% Chromium Steel
- Relationship between the Solid Phase Equilibrium and the Isothermal Martensite Transformation in Fe-Ni-Cr and Fe-Ni-Mn Alloys
- Structural Diagrams and Phase Reactions of Fe-Cr-N Ternary System
- Microstructures and Nitrides of Fe-Cr-N Ternary System
- Residual Stresses in Steels due to Heat Treatments
- Effect of Nickel on the Solubility and Diffusion of Nitrogen in Alpha-Iron
- Study on A_3 Transformation of Dispersion-Strengthened Iron
- Mechanical and Physical Properties of Dispersion-Strengthened Iron
- Self-Diffusion in Single Crystal of Silver Containing Alumina Particles
- Studies on the Yield Strength of Dispersion Strengthened Alloys
- Effects of Alloying Element on Supercooled A_3 Transformation of Iron
- Effect of Cooling Rate on A_3 Transformation Temperatures of Iron and Iron-Nickel Binary Alloys
- Quenched Structure and Tempering Process of Iron-Nitrogen Binary Alloys
- Thermodynamic Study on the Transformation of Austenite into Martensite in Iron-High Nitrogen and Iron-Carbon Binary System
- Sub-Zero Treatment of Quenched Steel. I : On the Stabilization of Retained Austenite
- The Precipitation of χ-carbide in the Tempering Process of High Carbon Steels
- Transformation of Retained Austenite and Observation of Cracks under Low-Cycle Fatigue Testing
- Solubility of Nitrogen in Austenitic Iron under High Nitrogen Pressure and Thermodynamic Properties of Iron-Nitrogen Interstitial Solid Solution
- Development of High Temperature and High Pressure Equipment for Study of Reaction between Gas and Metals, and Some Experimental Results
- Structural Diagrams and Solid Phase Reactions of the Quaternary 7% Cr-Fe-C-N System
- Structural Diagrams and Phase Reactions of the Quaternary 12%Cr-Fe-C-N System
- Constitutional Diagrams of Iron-Rich Corner in 18% Cr-Fe-C-N System
- The Temperature and Stress Dependences of the Steady-State Creep Rate of Ferritic Iron-Chromium Alloys
- Nitrogen as the Alloying Element in Steels. I : On the Effect of Nitrogen on the Temper-Brittleness in Steels
- Study of the Mechanical Properties of the Unnotched and Notched Specimens under High Speed Impact-Bending
- X-ray Investigation of Low-Cycle Fatigue in Martensitic Steels
- Isothermal Martensitic Transformation in Fe-Ni-Cr Alloy
- Precipitation of Carbides in 12% Cr Steel during Tempering
- The Effects of Grain Size and Precipitate on Strength of Nb-Treated Steels
- Precipitation Behaviours of Austenitic Steel of Manganese-Chromium Type Containing Vanadium
- Anomalous Contraction near 500℃ in Austenitic Heat-Resisting Alloys Containing Chromium and Nickel
- Effect of Nitrogen and Other Alloying Elements on the Low-Temperature Brittleness of Steel. III : Nitrogen Fix and Nitrogen in Quench-Tempered Steel
- Effect of Nitrogen and Few Other Elements on Strain Aging of Steels
- Effect of Nitrogen and Other Alloying Elements on the Low-Temperature Brittleness of Steel. IV : Effect of Quench-Tempering
- Corrosion of Chromium Steel by Liquid Bismuth
- Effect of Molybdenum upon the High-Temperature Oxidation and the V_2O_5 Attack on Ni-Cr-Base Alloys
- Corrosion of Carbon Steel by Liquid Bismuth
- Effect of Nitrogen and Other Alloying Elements on the Low-Temperature Brittleness of Steel. I : Correlation of Nitrogen and Carbon
- New Secondary Phase in Austenitic Fe-Co-Cr-Ni Base Heat-Resisting Alloy
- Determination of Condition for Electrolytic Extractions of Nitrides in Steel by Means of Potentiostat
- Residual Stresses in Steels due to Heat Treatments. II
- Effect of Nitrogen and Other Alloying Elements on the Low-Temperature Brittleness of Steel. II : Correlative Effect of Nitrogen and Phosphorus
- Precipitation Process and Age-Hardenability of Austenitic Fe-Co-Cr-Ni Base Heat-Resisting Alloys
- Phase Translation in Hadfield Steel Isothermally Heated at 500℃ after Solution Treatment
- Anomaly in Dilatation on Heating of Cold-worked 18-8 Stainless Steel
- Corrosion and Erosion of Ferritic Steel by Liquid Bismuth
- Kinetics of Transformation of Aged Retained-Austenite into Martensite
- Sub-Zero Treatment of Quenched Steel. II : Effect of the Addition of Small Amount of Elements on the Stabilization of Retained Austenite
- Nitrogen as an Alloying Element in Steel : Effect of Nitrogen on Quench-Aging of Steels
- Nitrogen as Alloying Element in Steels. II : On the Effect of Nitrogen on Blue-Brittleness in Steels
- ε-phase Formation in Solution-Treated and Heated Hadfield Steel
- Heat-Treatment of Forged Roll Steel
- Sub Zero Treatment of Quenched Steel. III : Effect of Aging on the Stabilization of Retained Austenite
- Sintered Intermetallic Compound NiAl as High Temperature Material. II
- Study on Sintering Process of Titanium Carbide by Measuring the Change in Electrical Resistivity
- New Oxidizing Method for Revealing Austenitic Grain
- A Study on the Dispersion-Strengthened Steel
- An Investigation on Isothermal Transformation in Steels. I : The Cause of Modification of S-Curves of Some Alloy Steels
- Sintered Intermetallic Compound NiAl as High Temperature Material. I
- An Investigation on Boron-Treated Steels. I : On the Hardenability of Boron-Treated Medium-Carbon Steels, especially the Effect of Nitrogen-Content in Steels
- Carbide precipitation by Heating High-Manganese Steel after Solution Treatment
- Nitrogen as an Alloying Element in Steels : The Effect of Nitrogen on the Tempering of Cold-Worked Steels
- On the Mechanism of Boron Hardenability