Amorphization of D0_<19> Intermetallics by Hydrogenation
スポンサーリンク
概要
- 論文の詳細を見る
Structural changes of titanium based D0_<19> intermetallics, i.e. Ti_3Ga, Ti_3In, Ti_3Sn and Ti_3Al caused by hydrogenation were studied by X-ray diffractometry (XRD) and transmission electron microscopy (TEM). Ti_3Ga and Ti_3In amorphize by hydrogenation, while Ti_3Al and Ti_3Sn absorb hydrogen in the crystalline state. However, Ti_3Al alloyed with Zr or Hf amorphize by hydrogenation. Crystallization and hydrogen desorption behaviors of the amorphous alloys prepared by hydrogenation were examined by differential scanning calorimetry (DSC) and hydrogen analysis. The mechanism and the factor controlling amorphization of the D0_<19> intermetallics by hydrogenation are discussed.hydrogenamorphousintermetallicscrystallizationtransformation
- 東北大学の論文
- 1995-03-30
著者
-
MASUMOTO Tsuyoshi
The Research Institute of Electrical and Magnetic Materials
-
MASUMOTO Tsuyoshi
Institute for Materials Research, Tohoku University
-
Masumoto T
The Research Institute Of Electrical And Magnetic Materials
-
Aoki K
Tohoku Univ. Sendai Jpn
-
Aoki Kiyoshi
The Research Institute For Iron Steel And Other Metals
-
Aoki Kiyoshi
Institute For Materials Research
-
Aoki Kiyoshi
Institute For Materials Research Tohoku University
-
Mori Katsuhiko
Institute For Materials Research Tohoku University
-
Masumoto Tsuyoshi
Institute For Materials Research
-
Aoki Kiyoshi
Institute for Materials Research, Tohoku University
関連論文
- Random Anisotropy Model for Nanocrystalline Soft Magnetic Alloys with Grain-Size Distribution
- Development of Common Mode Choke Coil Made of New Nanocrystalline Soft Magnetic Alloy "NANOPERM^[○!R]"
- High Mechanical Strength of Al-(V, Cr, Mn)-(Fe, Co, Ni)Quasicrystalline Alloys Prepared by Rapid Solidification
- Faceted Etch Pits Formed on Surfaces of an Icosahedral Al_Pd_Mn_ Quasicrystal
- New Class of Amorphous and Icosahedral Phases in Zn-Mg-Rare-Earth Metal Alloys
- Magnetic Properties and Phase Stability of Icosahedral Al-Pd-Mn-B Quasicrystals
- Novel Face-Centered Icosahedral Phase in Al-Mg-Li System
- Temperature Dependence of Hardness and Expansion in an Icosahedral Al-Pd-Mn Alloy
- Crystallization-Induced Phason Relaxation in Icosahedral Al-Pd-Mn Alloys
- Compositional Effect on the Two-Stage Enthalpy Relaxation of Metal-Metalloid Amorphous Alloys upon Annealing
- Superconducting Properties of Metastable bcc Solid Solution in Melt-quenched Zr-Ge Binary Alloys
- Young's Modulus of Fe-Si-B Amorphous Wires
- The Critical Thickness for the Formation of Fe-, Ni- and Co-Based Amorphous Alloys with Metalloids
- Formation Range, Mechanical Properties and Thermal Stability of Superconducting Zr-Si Amorphous Alloys
- Formation of Metastable Phases in the Zr -Al System by Electron Beam Deposition
- Layered Structure and Superconducting Properties of Ag-Sheathed Bi_Pb_Sr_2Ca_2Cu_3O_y Wires Prepared by Combined Jellyroll and Hotextrusion Technique
- Formation of Glassy Pd-Ni-P Alloys by Mechanical Alloying and Their Structure and Thermal Stability
- Mossbauer Effect of Decagonal and Amorphous Phases in Al-Ni-Fe System
- Effect of Additional Cu Element on Structure and Crystallization Behavior of Amorphous Fe-Nb-Si-B Alloys
- Phason Strains and Periodicity in Al-Ru-Cu Icosahedral Quasicrystals
- Magnetic Properties of Fe-Based Binary Crystalline Alloys Produced by Vapor Quenching
- Electrical Resistance and Magnetoresistance in Quasi-Crystalline and Amorphous Al-Mn Alloys
- Preparation of Amorphous Metallic Powder
- Amorphization by Compound-Element Milling in Al- TM(TM=Mn, Fe, Co and Ni) Binary System
- Formation, Thermal Stability and Mossbauer Effect of Amorphous, Quasicrystalline and Crystalline Phases in Al-(Cu, Ni)-Fe Systems
- Production of Amorphous Alloy Balloons by Utilizing Viscous Flowability
- Space Group Determination of Decagonal Quasicrystals of an Al_Ni_Fe_ Alloy Using Convergent-Beam Electron Diffraction
- Interface Stability, Growth and Morphology in Icosahedral Quasi Crystals
- Quasicrystals As a Hume-Rothery Phase : An Empirical Approach((B)Quasicrystals)
- Quasicrystals in Al-Pd-TM (TM=Transition Metal) Systems Prepared by Rapid Solidification
- Al-Ge-Mn and Al-Cu-Ge-Mn Quasi-Crystals with Coercivity at Room Temperature : Condensed Matter
- Production of Bi-Sr-Ca-Cu-O Glasses by Liquid Quenching and their Glass Transition and Structural Relaxation : Condensed Matter
- Effects of Substrate Temperature and Heat Treatment on GMR Properties of Co-RE-O Nano-granular Films
- High-Strain-Rate Superplasticity due to Newtonian Viscous Flow in La_Al_Ni_ Metallic Glass
- Stress Overshoot in Stress-Strain Curves of Zr_Al_Ni_Cu_ Metallic Glass
- Molecular Dynamics Study of Structural and Dynamical Properties of Zr_xNi_ (x=0〜100) Amorphous and Liquid Alloys
- Molecular Dynamics Simulation of Phase Separation in Lennard-Jones Liquids
- Molecular Dynamics Study for Structure and Dynamics of Amorphous and Liquid Zr_Ni_ Alloys
- Upper Critical Fields on High Temperature Superconductivity in La-Sr-Cu-O System
- Effect of Temperature and Deformation on the Structure of Amorphous Metals
- Powder-Forming Tendency of Nonequilibrium Phases in Fe-C-X (X=Cr, Mo, W, Al or Si) Alloys by Comminution and Microstructure and Hardness of Their Sintered Compacts
- Rapidly Solidified Powder Metallurgy Mg_Zn_1Y_2Alloys with Excellent Tensile Yield Strength above 600 MPa
- Nanocrystalline Soft-Magnetic Fe-Zr-B-Cu Composites by Consolidation of Amorphous Powders Coated with Oxide Film through Sol-Gel Process
- Soft Magnetic Properties of Bulk Nanocrystalline Fe-(Zr, Hf)-B Alloys Produced by Extruding Amorphous Powders
- Soft-Magnetic Properties of Nanocrystalline Fe-Zr-B-Ni Bulk Alloy Produced by Warm Extrusion
- Thermal, Mechanical and Physical Properties of Supercooled Liquid in Pd-Cu-Ni-P Amorphous Alloy
- High T_c Superconductivity of a Melt-Spun Er_1Ba_2Cu_3 Oxide Ribbon
- Hydrogenation of Amorphous and Crystalline Gd-Co Alloys
- Dynamic Compaction of Amorphous Co_Fe_Si_B_ Alloy Powders Obtained by a Cavitation Method
- Delayed Fracture of Amorphous Alloys in Atmosphere
- Crystallization Behavior of Amorphous High-Carbon Alloy Steels
- Nonequilibrium Phases in Melt-Quenched Co-W-C Alloys and Their Powder-Forming Tendency by Comminution
- Structural Diagrams and Phase Reactions of Fe-Cr-N Ternary System
- Microstructures and Nitrides of Fe-Cr-N Ternary System
- High Frequency Core Loss and Initial Permeability of Ferromagnetic Amorphous Ribbons
- Magnetostriction of Fe-Co Amorphous Alloys
- Ti-Nb-Si Amorphous Alloys for Application to Diaphragm in Watches
- The Structure of Amorphous Iron-Phosphorus Alloys
- Structural Study of an Amorphous Liquid-quenched Ni_-P_ Alloy
- Effects of Alloying Elements on the Corrosion Behavior of Amorphous Cobalt-Base Alloys
- Effect of Molybdenum on the Corrosion Behavior of Amorphous Fe-Mo-C alloys in 1N HCl
- Effect of Nickel on the Solubility and Diffusion of Nitrogen in Alpha-Iron
- Pressure Dependence of Hydrogen-Induced Amorphization in C15 Laves Phases TbM_2 (M=Fe, Co and Ni)
- Amorphization of D0_ Intermetallics by Hydrogenation
- High T_c Superconductor Prepared by Oxidization of a Liquid-Quenched Yb_1Ba_2Cu_3 Alloy Foil in Air
- Influence of Hydrogenation on the Magnetic Properties of Gd-Co Amorphous Alloys
- Hydrogenation of Amorphous and Crystalline RE-Ni Alloys
- Thermal, Magnetic and Electrical Properties of Mn-Metalloid Amorphous Ribbons
- The Magnetic and Electric Properties of (Co_ Mn_x)_2B Crystalline compounds and Amorphous Alloys
- Pressure Effects on the Curie Temperature and Electrical Resistance of Fe-based Amorphous Alloys
- Formation of a Nanoscale hcp Structure by Crystallization of an Amorphous Co_Zr_7B_2 Alloy
- Static Consolidation of Co-base Amorphous Alloy Powders and Their Mechanical and Magnetic Properties
- Softening of Co-base Amorphous Alloys at High Temperatures
- Short-Range Structures of Amorphous and Liquid Iron and Pd_-Si_ Alloy
- Magnetic Properties of Amorphous Fe-Zr-B Alloys
- Electrical Resistance in Superconducting Amorphous Alloy Zr_Ir_
- Upper Critical Field of Superconducting Amorphous Alloy Zr_Si_
- Effect of Compositions on the Crystallization of (Fe, Ni, Co)-Si-B Amorphous Alloys
- An Electron Microscopic Study on the Crystallization of Amorphous Ti-(Fe, Co or Ni)-B Alloys
- Superconductivity of Ti-Nb-Si Alloys Crystallized from the Amorphous State
- Magnetic Properties of Amorphous (Fe_Mn_x)_Zr_ Ferromagnets
- Solubility of Nitrogen in Austenitic Iron under High Nitrogen Pressure and Thermodynamic Properties of Iron-Nitrogen Interstitial Solid Solution
- Development of High Temperature and High Pressure Equipment for Study of Reaction between Gas and Metals, and Some Experimental Results
- Structural Diagrams and Solid Phase Reactions of the Quaternary 7% Cr-Fe-C-N System
- Structural Diagrams and Phase Reactions of the Quaternary 12%Cr-Fe-C-N System
- Constitutional Diagrams of Iron-Rich Corner in 18% Cr-Fe-C-N System
- Corrosion Behavior of Amorphous Ni-Ti-P and Ni-Cr-P Alloys
- Effect of Chromium Addition on Corrosion Resistance of Amorphous Fe-B-C and Fe-B-Si Alloys
- Effect of Nickel Addition on Corrosion Resistance of Amorphous Iron Base Alloys
- Precipitation of Carbides in 12% Cr Steel during Tempering
- Microstructure and Soft Magnetic Properties of Nanocrystalline Fe-Zr-B-Al, Fe-Zr-B-Si and Fe-Zr-B-Al-Si Alloys with Zero Magnetostriction
- Recent Progress of Aluminum Base Amorphous Alloys
- Anomalous Contraction near 500℃ in Austenitic Heat-Resisting Alloys Containing Chromium and Nickel
- Heat Capacity of Pd-Si, Ni-Si-B and Zr-Based Metallic Glasses
- Superconductivity above 90 K in Y-Ba-Cu-O Compounds and Their Critical Current Densities at 77 K
- Preparation of a High T_c Superconductor by Oxidization of an Amorphous La_Sr_Cu Alloy Ribbon in Air
- Formation and High Mechanical Strength of Al-Based Alloys Containing a Nanoscale Icosahedral Phase As a Main Constituent
- Formation and Mechanical Strengths of Aluminum-based Supersaturated Solid Solutions((A)Amorphous Alloys)
- Preparation of Superconducting (Bi, Pb)-Sr-Ca-Cu Oxide Tapes with a Highly Oriented Structure by the Solidification Method
- Superconductors Prepared by Mechanical Alloying of Immiscible Elements