Growth Manner of Intermetallic Compounds at the Weld Interface of Steel/Aluminum Alloy Lap Joint Fabricated by a Defocused Laser Beam
スポンサーリンク
概要
- 論文の詳細を見る
- Japan Institute of Metalsの論文
- 2007-06-01
著者
-
KUMAI Shinji
Department of Materials Science and Engineering, Tokyo Institute of Technology
-
Lee Kwang-jin
Department Of Electronics Engineering Korea University
-
Lee Kwang-jin
Department Of Materials Science And Engineering Tokyo Institute Of Technology
-
Ishikawa Nobuhiro
High Voltage Electron Microscopy Station National Institute Of Materials Science
-
Furuya Kazuo
High Voltage Electron Microscopy Station National Institute For Materials Science
-
Kumai Shinji
Department Of Materials Science And Engineering Tokyo Institute Of Technology
-
KAWAMURA Naonori
Department of Materials Science and Engineering, Tokyo Institute of Technology
-
Furuya Kazuo
High Voltage Electron Microscopy Station National Institute Of Materials Science
-
Kawamura Naonori
Department Of Materials Science And Engineering Tokyo Institute Of Technology
-
Kumai Shinji
Department Of Materials Science And Engineering Interdisciplinary Graduate School Of Science And Eng
-
KUMAI Shinji
Department of Material Science and Engineering, Tokyo Institute of Technology
関連論文
- A High Resolution, Wide Range Digital Impedance Controller(Papers Selected from AP-ASIC 2004)
- Formation of Internal Crack in High-Speed Twin-Roll Cast 6022 Aluminum Alloy Strip
- Cyclic Deformation and Development of Dislocation Structures in a Centrifugally Cast Al-Al_3Ti of Functionally Graded Material
- Microstructural Refinement of Hyper-Eutectic Al-Si-Fe-Mn Cast Alloys to Produce a Recyclable Wrought Material
- Carbon Nanostructure on a Tungsten Needle Tip Formed by Electron Beam Induced Deposition and Its Graphitization through Resistive Heating
- Effects of Heat Treatment on Electric Properties of Nanorods Formed by Electron Beam-Induced Deposition
- Nanodot and Nanorod Formation in Electron-Beam-Induced Deposition Using Iron Carbonyl
- High-Speed Twin-Roll Strip Casting of Al-Mg-Si Alloys with High Iron Content
- Refined Solidification Structure and Improved Formability of A356 Aluminum Alloy Plate Produced using a High-Speed Twin-Roll Strip Caster
- Fabrication of Free-Standing Tungsten-Nanowhiskers on SiO_2 Substrates with Electron-Beam Induced Deposition
- Fabrication and Characterization of Self-Standing W-Nanodendrites on Insulator SiO_2 Substrate by Electron-Beam-Induced Deposition under HVTEM
- Electron microscopy observation of interface in diffusion-bonded copper joint
- Detection of iron-oxide layer on the surface of iron nitride using high-resolution electron microscopy and Fourier filtering
- Effect of Mg on the Sintering of Al-Mg Alloy Powders by Pulse Electric-Current Sintering Process
- TEM Observation of Interfaces between Particles in Al-Mg Alloy Powder Compacts Prepared by Pulse Electric Current Sintering
- 625 Effect of Magnesium on Properties of Aluminum-Magnesium Alloy Powder Compacts by Spark Plasma Sintering
- Effect of Interface Behavior between Particles on Properties of Pure Al Powder Compacts by Spark Plasma Sintering
- In-situ, analytical, high-voltage and high-resolution transmission electron microscopy of Xe ion implantation into Al
- Xe precipitates at grain boundaries in Al under 1 MeV electron irradiation
- High-resolution electron microscopy study of defect structures in γ-TiAl irradiated with 15 keV He ions in a high-voltage transmission electron microscope
- Interfacial Microstructure of Aluminum/Metallic Glass Lap Joints Fabricated by Magnetic Pulse Welding
- A Low Jitter ADPLL for Mobile Applications(PLL, Analog Circuit and Device Technologies)
- Tear Toughness Evaluation of a Permanent Mold Cast A356 Aluminum Alloy Using a Small-size Specimen
- Tear Toughness of Permanent Mold Cast and DC Cast A356 Aluminum Alloys
- Development of a stage-scanning system for high-resolution confocal STEM
- Plastic Deformation of D0_ Ordered Al_3Ti in a Centrifugally Cast Al-Al_3Ti Composite
- Sample preparation of GaN-based materials on a sapphire substrate for STEM analysis
- Nanostructure fabrication by electron-beam-induced deposition with metal carbonyl precursor and water vapor (Special issue: Microprocesses & nanotechnology)
- Proximity Effect in Electron-Beam-Induced Deposition
- Relationship between X-ray Intensity and Electric Bias on Al_2O_3 Surface during Low Energy Ga^+ Irradiation
- Morphology of Iron Silicide Nanorods Formed by Electron-Beam-Induced Deposition Using Ultrahigh-Vacuum Transmission Electron Microscope
- Fabrication of Alpha-Iron and Iron Carbide Nanostructures by Electron-Beam Induced Chemical Vapor Deposition and Postdeposition Heat Treatment
- Resolution in New Nanofabrication Technique Combining Electron-Beam-Induced Deposition and Low-Energy Ion Milling
- Characterization Investigation of β-FeSi_2 Semiconductor by In Situ Ultrahigh-Vacuum Transmission Electron Microscopy
- High-resolution transmission electron microscopy observation of the cross-sectional structure of reconstructed silicon (5,5,12) surface
- New scheme for calculation of annular dark-field STEM image including both elastically diffracted and TDS waves
- Growth Manner of Intermetallic Compounds at the Weld Interface of Steel/Aluminum Alloy Lap Joint Fabricated by a Defocused Laser Beam
- In-situ Observation of the Reduction of Iron Oxides by Solid State Carbon in TEM
- Gold Seed Arrangement on Nanoporous Anodic Aluminum Oxide Membrane by Centrifugal Force
- TEM Observation of the Reduction of Wustite by Hydrogen Ion Implantation
- Fabrication and investigation of tungsten deposit on top and bottom surfaces of thin film substrate (Special issue: Microprocesses & nanotechnology)
- Crystallization of Focused-Electron-Beam Deposited Tungsten Wire on Molybdenum Substrate
- Modeling the Process of Electron-Beam-Induced Deposition by Dynamic Monte Carlo Simulation
- High-Speed Twin Roll Casting of Thin Aluminum Alloy Strips Containing Fe Impurities
- Origin of Improved Ductility in Semi-Liquid Die-Cast Al-7%Si-0.4%Mg Alloys
- Effects of Dendrite Cell Size and Eutectic Si Particle Morphology on Fatigue Crack Growth in Cast and HIPed AC4CH Alloys
- The Effects of Straining Frequency and Stress Ratio on Polarization Current Responded to Cyclic Strain in a Commercial Iron
- Effects of Extrusion Temperature on Creep Properties of Spray-Formed and Hot-Extruded Al-8.3 mass%Fe Alloys
- Constant ΔΚ Fatigue Crack Growth Tests under Programmed Humidity Cycle Conditions-As a Tool to Evaluate the Effect of Humidity on Fatigue Crack Growth of Al-Li Alloys-
- Simulation and Experimental Analysis of Metal Jet Emission and Weld Interface Morphology in Impact Welding
- Interfacial Morphology of Magnetic Pulse Welded Aluminum/Aluminum and Copper/Copper Lap Joints
- Growth Manner of Intermetallic Compound Layer Produced at Welding Interface to Friction Stir Spot Welded Aluminum/Steel Lap Joint
- Microstructural Development during Fatigue of a Polycrystalline 3003 Aluminum Alloy
- Characterization of Intermetallic Compound Layer Formed at the Weld Interface of the Defocused Laser Welded Low Carbon Steel/6111 Aluminum Alloy Lap Joint
- Effect of Cooling Rates during Solidification of Al-5.5%Mg-2.3%Si-0.6%Mn and Al-13% Mg_2Si Pseudo-Binary Alloys on Their Secondary-Particle Morphology and Tear Toughness
- Competitive Nucleation and Growth of {111} Ω with {001} GP Zones and θ' in a Stress-Aged Al-Cu-Mg-Ag Alloy
- Effect of Si Content on Strip Thickness and Solidified Structure in High-Speed Twin-Roll Cast Al-Si Alloy Strips
- Effects of Mechanical constraint on the Strength of Ni_3Ge Single Crystals
- Microstructure and Joint Strength of Friction Stir Spot Welded 6022 Aluminum Alloy Sheets and Plated Steel Sheets
- Advanced High-Speed Solid-State Joining of 2024 Aluminum Alloy Studs to 5052 Aluminum Alloy Plates
- Effects of High-Temperature Solutionizing on Microstructure and Tear Toughness of A356 Cast Aluminum Alloy
- High-Speed Deformation and Collision Behavior of Pure Aluminum Plates in Magnetic Pulse Welding
- Microstructural Characterization of Intermediate Layer Produced at Aluminum/Metallic Glass Interface Fabricated by Magnetic Pulse Welding
- Fabrication and Investigation of Tungsten Deposit on Top and Bottom Surfaces of Thin Film Substrate
- Crystallization of Focused-Electron-Beam Deposited Tungsten Wire on Molybdenum Substrate
- Modeling the Process of Electron-Beam-Induced Deposition by Dynamic Monte Carlo Simulation
- Microstructural Characterization of Intermediate Layer Produced at Aluminum/Metallic Glass Interface Fabricated by Magnetic Pulse Welding
- Mechanisms of Crystalline Iron Oxide Formation in Electron Beam-Induced Deposition
- Nanodot and Nanorod Formation in Electron-Beam-Induced Deposition Using Iron Carbonyl
- Influence of probe bottom shape on microstructure and mechanical properties in friction stir spot welded 6022 aluminum alloy sheets
- Fabrication of Alpha-Iron and Iron Carbide Nanostructures by Electron-Beam Induced Chemical Vapor Deposition and Postdeposition Heat Treatment
- Cross-sectional Transmission Electron Microscopy and Optical Characterization of Gold Nanoislands
- Casting of Aluminum Alloy Clad Strip using a Roll Caster