Fabrication of Four-Probe Fine Electrodes Using Scanning-Probe Nanofabrication
スポンサーリンク
概要
- 論文の詳細を見る
- Published by the Japan Society of Applied Physics through the Institute of Pure and Applied Physicsの論文
- 2003-07-30
著者
-
Abe Takumi
Department Of Neurosurgery Showa University School Of Medicine
-
Abe Takumi
Department Of Advanced Materials Science Graduate School Of Frontier Sciences University Of Tokyo
-
AKAI Tomonori
Department of Advanced Materials Science, Graduate School of Frontier Sciences, University of Tokyo
-
SHIMOMURA Takeshi
Department of Advanced Materials Science, Graduate School of Frontier Sciences, University of Tokyo
-
KATO Midori
Advanced Research Laboratory, Hitachi, Ltd.
-
ISHIBASHI Masayoshi
Advanced Research Laboratory, Hitachi, Ltd.
-
HEIKE Seiji
Advanced Research Laboratory, Hitachi, Ltd.
-
CHOI Byoung-Ki
Advanced Research Laboratory, Hitachi, Ltd.
-
HASHIZUME Tomihiro
Advanced Research Laboratory, Hitachi, Ltd.
-
ITO Kohzo
Department of Advanced Materials Science, Graduate School of Frontier Sciences, University of Tokyo
-
Ishibashi M
Advanced Research Laboratory Hitachi Ltd.
-
Ishibashi Masayoshi
Advanced Research Laboratory Hitachi Ltd.
-
Choi Byoung-ki
Advanced Research Laboratory Hitachi Ltd.
-
Heike S
Advanced Research Laboratory Hitachi Ltd.
-
Akai Tomonori
Department Of Advanced Materials Science Graduate School Of Frontier Sciences University Of Tokyo
関連論文
- Male Prolactinoma With Pituitary Apoplexy Concomitant With Intracerebral Hemorrhage
- Corticotroph Cell Adenoma without Typical Manifestations of Cushing's Disease Presenting with Cavernous Sinus Syndrome following Pituitary Apoplexy
- Aberrant Luteinizing Hormone-Releasing Hormone-Stimulated Adrenocorticotropic Hormone Secretion in a Patient with Pituitary Hyperplasia due to Primary Hypothyroidism
- Staged Transsphenoidal Surgery for Fibrous Nonfunctioning Pituitary Adenomas with Suprasellar Extension
- Perfusion Computed Tomography for the Indication of Percutaneous Transluminal Reconstruction for Acute Stroke
- Three-dimensional Computed Tomography Angiography of the Galenic System for the Occipital Transtentorial Approach
- Evaluation of Hyperacute Stroke Using Perfusion Computed Tomography
- Duplex Doppler Ultrasonography of Subclavian Steal Syndrome
- Fabrication of Four-Probe Fine Electrodes Using Scanning-Probe Nanofabrication
- Fabrication Process of Fine Electrodes Using Shadow Mask Evaporation and Tip-Induced Local Oxidation
- Manipulation of Insulated Molecular Wire with Atomic Force Microscope : Surfaces, Interfaces, and Films
- Is Eradication Therapy Useful as the First Line of Treatment in Helicobacter pylori-Positive Idiopathic Thrombocytopenic Purpura? Analysis of 207 Eradicated Chronic ITP Cases in Japan
- Stability of Metallofullerene LaC_ on UV Light Irradiation
- Preparation and Oxidation of Metallofullerenes Containing Praseodymium
- Secondary Transnasal Surgery after Negative Exporation in Cushing's Disease
- Self-Diffusion in Intrinsic and Extrinsic Silicon Using Isotopically Pure ^Silicon/Natural Silicon Heterostructures
- Self-Diffusion in Extrinsic Silicon Using Isotopically Enriched ^Si Layer : Semiconductors
- Epitaxial Growth of Pure ^Si Layers on a Natural Si(100) Substrate Using Enriched ^SiH_4
- Expression and functional characterization of the P-selectin glycoprotein ligand-1 in various cells
- Deterioration of Glycemic Control during Octreotide LAR Treatment in an Acromegalic Japanese Patient with Type 2 Diabetes Mellitus
- Nanofabrication Using Atomic Force Microscopy Lithography for Molecular Devices
- Dot-Array Resist Patterning Using Scanning Probe Microscopy with a Hybrid Current-Voltage Control Method
- Nanofabrication Using Atomic Force Microscopy Lithography Combined with Optical Lithography
- Combining Atomic Force Microscopic Lithography with Photolithography
- Fabrication of High-Resolution and High-Aspect-Ratio Patterns on a Stepped Substrate by Using Scanning Probe Lithography with a Multilayer-Resist System
- Fabrication of High-Resolution and High-Aspect-Ratio Patterning on a Stepped Substrate by Scanning Probe Lithography Using a Multilayer-Resist System
- Characteristics of Nanoscale Lithography Using AFM with a Current-Controlled Exposure System
- Characteristics of Nanoscale Lithography Using Atomic Force Microscope with Current-Controlled Exposure System
- Encapsulation of Ferritin within a Hollow Cylinder of Glycolipid Nanotubes
- Direct Imaging of Thermodynamic Process In Atom Migration by Using Scanning Tunneling Microscopy
- Reduced Density of Missing-Dimer Vacancies on Tungsten-Contaminated Si (100)-(2×n) Surface by Hydrogen Termination
- Control of Surface Current on a Si(111) Surface by Using Nanofabrication
- Theoretical Study of Ga Adsorbates around Dangling-Bond Wires on am H-Terminated Si Surface: Possibility of Atomic-Scale Ferromagnets
- Initial Stage of Molecular Adsorption on Si(100) and H-terminated Si(100) Investigated by UHV-STM(STM-Si(001))
- Scanning Tunneling Spectroscopy of Dangling-Bond Wires Fabricated on the Si(100) -2 × 1 -H Surface
- Property Change of Si(111) Surface by Scanning Tunneling Microscope Manipulation
- Evaluation of Thin Silicon Dioxide Layers by Beam Assisted Scanning Tunneling Microscope
- Analysis of Rubbed Polyimide Films by Polarized Infrared Spectroscopy : Effects of Immersion in Organic Solvents
- Effectiveness of Secondary Transnasal Surgery in GH-Secreting Pituitary Macroadenomas
- Primitive Trigeminal Artery Variant Associated with Intracranial Ruptured Aneurysm and Cerebral Arteriovenous Malformation : Case Report
- Dielectric Study on the Johari-Goldstein Mode of Glass-Forming Sorbitol
- Dielectric Relaxation of Glass-Forming Organic Liquid in the Crossover Regime between Normal and Supercooled Liquid States
- On the Swelling and Elastic Properties of Highly Charged Polyelectrolyte Networks
- How to Extract the Counterion Valency Effect on Polyelectrolyte Conformations
- Pulse Injection of Carbon Nanotubes onto a H-terminated Si(100) Surface
- First Principles Study of Dihydride Chains on H-Terminated Si(100)-2×1 Surface (Special Issue: Scanning Tunneling Microscopy/Spectroscopy and Related Techniques)
- Scanning Tunneling Microscopy/Spectroscopy of La_2@C_ Multilayer Islands on Si(100)-2×1-H Surfaces
- Initial-Stage Dihydride Formation on Si(100)-2x1-H Surface
- Scanning Tunneling Microscopy of the GaAs(001) Surface Reconstructions(STM-GaAs)
- FI-STM Investigation of Fullerenes Adsorbed on the Semiconductor and Metal Surfaces(STM-C_)
- Initial Backbond Oxidation at an Unpaired Dangling Bond Site on a Hydrogen-Terminated Si (100) 2×1 Surface
- Electrical Conductivity Measurement of DNA Double-Stranded Chains by "One-by-One" Cutting Method Using Atomic Force Microscopy(Cross-disciplinary physics and related areas of science and technology)
- Electrical Conduction of Ag Nanowire Fabricated on Hydrogen-Terminated Si(100) Surface (Special Issue: Scanning Tunneling Microscopy/Spectroscopy and Related Techniques)
- Role of Non-180° Domain Switching in Electrical Properties of Pb(Zr_, Ti)O_3 Thin Films
- Method of Distinguishing SrBi_2Ta_2O_9 Phase from Fluorite Phase Using X-Ray Diffraction Reciprocal Space Mapping
- Structural Studies on New Co Polyamine Complexes by X-Ray Absorption Fine Structure Spectroscopy
- Study of Initial Stage of Molecular Adsorption on Si(100) by Scanning Tunneling Microscopy
- Growth Control of Nano-Needle on Silicon Surface Using Scanning Tunneling Microscope
- Development of an In-Situ Method of Fabricating Artificial Atom Structures on the Si(100) Surface
- Interaction of Ga Adsorbates with Dangling Bonds on the Hydrogen Terminated Si(100) Surface
- In Situ Direct Imaging of Scanning Tunneling Microscope Tip Apex
- In Situ Direct Imaging of Scanning Tunneling Microscope Tip Apex
- Room-Temperature Adsorption of Si Atoms on H-terminated Si(001)-2×1 Surface(Condensed Matter: Structure, Mechanical and Thermal Properties)
- Observation of Color Image Using Near-Field Optical Microscope
- Nanofabrication Using Atomic Force Microscopy Lithography Combined with Optical Lithography
- Factors Affecting Voltammetric Responses for Redox-active Solid Layers of Li4Ti5O12 Coated on Electrodes
- Fabrication of Four-Probe Fine Electrodes Using Scanning-Probe Nanofabrication
- Characteristics of Nanoscale Lithography Using AFM with a Current-Controlled Exposure System