A BiCMOS Seventh-Order Lowpass Channel-Select Filter Operating at 2.5V Supply for a Spread-Spectrum Wireless Receiver(Special Section on Analog Circuit Techniques and Related Topics)
スポンサーリンク
概要
- 論文の詳細を見る
This paper presents a 7th-order channel-select filter for a spread-spectrum wireless receiver operating with a minimum power supply of 2.5V.The channel-select filter implements a sharp transition from 2MHz to 4MHz and a stopband attenuation of 50dB.The 7th-order filter is realized by a cascade of a passive RC integrator, a 3rd-order leapfrog filter, an operational amplifier based differentiator, a 2nd-order notch filter, and a 1st-order allpass filter.It is designed in a 0.35μm single-poly BiCMOS process.Simulation results show feasibility of the proposed filter.
- 社団法人電子情報通信学会の論文
- 2000-02-25
著者
-
藤井 信男
九州大学システム情報科学研究院電気電子システム工学部門
-
TANAKA Satoshi
Central Research Laboratory, Hitachi Ltd.
-
Takagi S
Graduate School Of Science And Engineering Tokyo Institute Of Technology
-
Sato Takuro
Niigata Institute Of Technology
-
Sato Takahide
Graduate School Of Science And Engineering Tokyo Institute Of Technology
-
JEONG Moonjae
the Department of Physical Electronics, Tokyo Institute of Technology
-
TAKAGI Shigetaka
the Department of Physical Electronics, Tokyo Institute of Technology
-
FUJII Nobuo
the Department of Physical Electronics, Tokyo Institute of Technology
-
KAWAMOTO Hiroshi
Semiconductor & Integrated Circuits Division, Hitachi Ltd.
-
Jeong Moonjae
The Department Of Physical Electronics Tokyo Institute Of Technology
-
Sato T
Graduate School Of Science And Engineering Tokyo Institute Of Technology
-
Takagi Shigetaka
Tokyo Inst. Of Technol. Tokyo Jpn
-
Kawamoto Hiroshi
Semiconductor & Integrated Circuits Division Hitachi Ltd.
-
Tanaka Satoshi
Central Research Laboratory Hitachi Ltd.
-
Fujii Nobuo
The Department Of Physical Electronics Faculty Of Engineering Tokyo Institute Of Technology
-
TANAKA Satoshi
Central Research Laboratories, Sysmex Corporation
関連論文
- 零出力発電制動を用いたリニアレールブレーキの電源システム
- リニア誘導モータを用いた発電制動型レールブレーキシステム
- リニアレールブレーキ用電機子の設計検討
- Variability analysis of MOS differential amplifier (特集 小規模アナログ集積回路設計技術)
- Isolation and molecular characterization of a SoWRKY1 transcription factor from spinach (Spinacia oleracea)
- High expression of ubiquitin carboxy-terminal hydrolase-L1 and -L3 mRNA predicts early recurrence in patients with invasive breast cancer
- 零出力発電制動を用いたリニアモータ型レールブレーキの励磁電源レス運転
- リニア誘導モータを応用したレールブレーキの設計と実験的検証
- Methods for Improving Efficiency of Linear Induction Motor for Urban Transit(Intemational Symposium on Speed-up and Service Technology for Railway and MAGLEV Systems)
- D702 METHODS FOR IMPROVING EFFICIENCY OF LINEAR INDUCTION MOTOR FOR URBAN TRANSIT
- リニア誘導モータの端効果の補償法について
- 空心形X-Yリニア同期モータ
- 新都市交通用リニア誘導モータの端効果補償特性
- X-Yリニア同期モータの磁束密度と推力特性
- 旅導型二次元駆動用モータの運動時の特性
- 自己回転型磁気車輸とそれを用いた試験車の特性
- 輸送用ラダー形リニア誘導モータの端効果に関する解析的検討
- 二層巻サーフェス誘導モータの静止時の特性
- 二次元駆動用サーフェス誘導モータ
- 磁気車輪の特性における二次導体壁高さの効果
- トロイダルコアを用いたサーフェス誘導モータの基本特性
- サーフェス誘導モータの電磁界解析
- 磁気車輪の磁極に関する解析的検討
- 永久磁石回転型磁気車輪の磁極と特性との関係
- 磁気車輪の電磁力分布の三次元数値計算
- FOREWORD (Special Section on Analog Technologies in Submicron Era)
- Design of Low Power Track and Hold Circuit Based on Two Stage Structure
- Multi-Path Analog Circuits Robust to Digital Substrate Noise
- High Speed Transconductance-C-Opamp Integrator Using Current-Feedback Amplifier(Building Block, Analog Circuit and Device Technologies)
- Design Optimization of Active Shield Circuits for Digital Noise Suppression Based on Average Noise Evaluation(Analog Circuit Techniques and Related Topics)
- Equivalent Saturated MOSFET Circuit with Wide Input Range(Analog Circuit Techniques and Related Topics)
- Optimized Design of Active Shield Circuit with Consideration on On-chip Layout
- Rail-to-Rail V-I Conversion Using a Pair of Single Channel MOSFETs Operating in Plural Regions
- Extension of Current Conveyor Concept and Its Applications
- Fully On-Chip Active Guard Band Circuit for Digital Noise Cancellation(Special Section on Analog Circuit Techniques and Relate)
- Wide-Input Range Linear Voltage-to-Current Converter Using Equivalent MOSFETs without Cutoff Region(Special Section on Analog Circuit Techniques and Related Topics)
- Design Optimization of Active Guard Band Circuit with Consideration on Device Matching and Frequency Characteristic
- High PSRR Active Guard Band Circuit For Digital Noise Suppression
- A Novel Design Strategy for Class A CMOS Second Generation Current Conveyors(Special Section on Analog Circuit Techniques Supporting the System LSI Era)
- Substrate Noise Suppression Using Active Guard Band Circuit
- A BiCMOS Seventh-Order Lowpass Channel-Select Filter Operating at 2.5V Supply for a Spread-Spectrum Wireless Receiver(Special Section on Analog Circuit Techniques and Related Topics)
- Zero Common-Mode Gain Fully Balanced Circuit Structure
- Design of an All-Pass Filter using a class AB 3-Input CMOS OTA
- Integrator-Based Filter Structures with Good Frequency Characteristics
- Design of a Novel Linear 3-Input CMOS OTA and Its Application to Filter Realization
- An Area-Efficient and Highly-Linear CMOS Four-Quadrant Analog Multiplier
- D-12-38 Frequency Plan for GSM/DCS1800 Dual-band Direct-conversion Radio
- Forward Subchannel Control Scheme for TDD Multi-Carrier Mobile Communication System (Special Section on Multi-dimensional Mobile Information Networks)
- Two Dimensional Equalization Scheme of Orthogonal Coding Multi-Carrier CDMA(Special Section of Papers Selected from ITC-CSCC'97)
- Bit Error Rate Evaluation of Delay Time Control Scheme for Reverse Channel on Orthogonal Coding Multi-Carrier CDMA (Special Section on Mutli-dimensional Mobile Information Network)
- Over Current Protection for PFM Control DC-DC Converter
- High Efficiency DC-DC Converter for Wide-ranging Loads with Gradual Reverse Current Stopping Technique
- BS-8-9 Performance Analysis of Handoff Algorithm in Multi-hop Wireless Systems(BS-8. Technology and Architecture for Ubiquitous Network Systems,ENGLISH SESSION)
- Design and Implementation of High-Speed and High-Q Active Bandpass Filters with Reduced Sensitivity to Integrator Nonideality (Special Section on High-Speed Analog Circuits and Signal Processing)
- A 270-MHz CMOS Quadrature Modulator for a GSM Transmitter(Special Section on Analog Circuit Techniques and Related Topics)
- Minimization of Output Errors of FIR Digital Filters by Multiple Decompositions of Signal Word
- High-Frequency, Low-Voltage Circuit Technology for VHF Paging Receiver (Special Section on High-Speed Analog Circuits and Signal Processing)
- An Evolutionary Synthesis of Analog Active Circuits Using Current Path Based Coding
- Reduction of Bootstrapped Switch Area Consumption Using Pre-Charge Phase
- Rail-to-Rail OTA Based on Signal Decomposition(Analog Circuit Techniques and Related Topics)
- Wide Tuning Range Voltage-Controlled Ring Oscillator(Devices and Circuits for Next Generation Multi-Media Communication Systems)
- Mapping Circuit for Rail-to-Rail Operation
- Improved CMOS Microwave Linearity Based on the Modified Large-Signal BSIM Model(Semiconductor Materials and Devices)
- Improved CMOS Microwave Linearity Based on the Modified Large-Signal BSIM Model
- New Estimation Method for Fatty Acid Composition in Oil Using Near Infrared Spectroscopy(Analytical Chemistry)
- Single Voltage Supply High Efficiency InGaAs Pseudomorphic Double-Hetero HEMTs with Platinum Buried Gates
- An Unwrapping of Signals in Transform Domain and Its Application in Signal Reconstruction
- A Reassignment Method for Improved Readability of Time-Frequency Representations
- Active Shield Circuit for Digital Noise Suppression in Mixed-Signal Integrated Circuits(Analog Circuit Techniques and Related Topics)
- Reduction in Element Value Spreads on Integrator-Based Filters
- Topology-Independent Predistortion for Integrator-Based Filters (Special Section on Analog Technologies in Submicron Era)
- A Drive of Input and Output Impedance Effects of Functional Blocks into a Frequency Shift of Active Circuits
- Jitter Tolerant Continuous-Time Sigma-Delta A-D Converter Employing In-Loop Low-Pass Filter(Analog Circuit Techniques and Related Topics)
- リニア誘導モータを応用したレールブレーキの設計と実験的検証
- 零出力発電制動を用いたリニアモータ型レールブレーキの励磁電源レス運転
- Variability Analysis of Inverter Delay Time
- Leapfrog Filters with Transmission Zeros Using OTA-C Integrator and Resistor-Based Addition Circuit
- Novel Superharmonic Injection-Locked Quadrature Oscillator
- Half-Swing Clocking Scheme for 75% Power Saving in Clocking Circuitry(Special Issue on the 1994 VLSI Circuits Symposium)
- A Rail-to-Rail CMOS Voltage Follower under Low Power Supply Voltage(Special Section on Analog Circuit Techniques Supporting the System LSI Era)
- Low Voltage OTA Using Two-MOSFET Subtractors between Rails(Special Section on Analog Circuit Techniques and Related Topics)
- Wide Dynamic Range MOS Analog Inverter (Special Issue on Circuit Technologies for Memory and Analog LSIs)
- MOSFET Instantaneous Companding Integrator(Special Section on Analog Circuit Techniques Supporting the System LSI Era)
- Active Shielding System for Digital Noise Suppression with Consideration on Arbitrary Noise Source Position
- Analog Circuit Synthesis Based on Reuse of Topological Features of Prototype Circuits(Special Section on VLSI Design and CAD Algorithms)
- Balanced-Type OTA using Common-Mode Gain Reduction Technique
- GaAs MESFET Linearized Transconductor and Active Load with no CMFB (Special Section on Analog Circuit Techniques for System-on-Chip Integration)
- A Design of MOSFET-C Impedance Simulation Circuits Based on a GIC
- A Synthesis of Highly Linear MOS Circuits and Their Application to Filter Realization (Special Section on High-Performance MOS Analog Circuits)
- Active Guard Band Circuit With Automatic Tunability
- Track and Hold Circuit : Common Problems and Performance Improvement
- Low-Voltage Current Mode Power Factor Function Generator(Special Section on Analog Circuit Techniques and Related Topics)