Rail-to-Rail OTA Based on Signal Decomposition(<Special Section>Analog Circuit Techniques and Related Topics)
スポンサーリンク
概要
- 論文の詳細を見る
This paper proposes a rail-to-rail OTA. By adding a signal decomposing circuit at the input of given OTAs that have a limited input voltage range, a rail-to-rail OTA is obtained. Each decomposed input voltage signal is converted to a current signal by an OTA and each output current of OTAs is summed to obtain a linear output signal. Since the input signal is decomposed into small magnitude voltage signals, the OTAs used to the voltage-current conversion do not require a wide input-range and any OTA can be used to realize a rail-to-rail input voltage range OTA. HSPICE simulations are performed to verify the validity of the proposed method.
- 社団法人電子情報通信学会の論文
- 2005-02-01
著者
-
藤井 信男
九州大学システム情報科学研究院電気電子システム工学部門
-
Takagi S
Graduate School Of Science And Engineering Tokyo Institute Of Technology
-
FUJII Nobuo
Department of Electrical and Electronic Systems Engineering, Faculty of Information Science and Elec
-
TAKAGI Shigetaka
Department of Communications and Integrated Systems, Graduate School of Science and Engineering, Tok
-
TAKAI Nobukazu
Department of Electronic Engineering, Graduate School of Engineering, Gunma University
-
Fujii Nobuo
Tokyo Inst. Of Technol. Tokyo Jpn
-
Takai N
Department Of System Electronics And Information Technology Tokyo Polytechnic University
-
Takai Nobukazu
Department Of Electronic Engineering Graduate School Of Engineering Gunma University
-
Takagi Shigetaka
Department Of Communications And Integrated Systems Graduate School Of Science And Engineering Tokyo
-
Fujii Nobuo
Department Of Civil Engineering
関連論文
- 零出力発電制動を用いたリニアレールブレーキの電源システム
- リニア誘導モータを用いた発電制動型レールブレーキシステム
- リニアレールブレーキ用電機子の設計検討
- 零出力発電制動を用いたリニアモータ型レールブレーキの励磁電源レス運転
- リニア誘導モータを応用したレールブレーキの設計と実験的検証
- Methods for Improving Efficiency of Linear Induction Motor for Urban Transit(Intemational Symposium on Speed-up and Service Technology for Railway and MAGLEV Systems)
- D702 METHODS FOR IMPROVING EFFICIENCY OF LINEAR INDUCTION MOTOR FOR URBAN TRANSIT
- リニア誘導モータの端効果の補償法について
- 空心形X-Yリニア同期モータ
- 新都市交通用リニア誘導モータの端効果補償特性
- X-Yリニア同期モータの磁束密度と推力特性
- 旅導型二次元駆動用モータの運動時の特性
- 自己回転型磁気車輸とそれを用いた試験車の特性
- 輸送用ラダー形リニア誘導モータの端効果に関する解析的検討
- 二層巻サーフェス誘導モータの静止時の特性
- 二次元駆動用サーフェス誘導モータ
- 磁気車輪の特性における二次導体壁高さの効果
- トロイダルコアを用いたサーフェス誘導モータの基本特性
- サーフェス誘導モータの電磁界解析
- 磁気車輪の磁極に関する解析的検討
- 永久磁石回転型磁気車輪の磁極と特性との関係
- 磁気車輪の電磁力分布の三次元数値計算
- Capacitance Reduction Technique for Switched-Capacitor Circuits Based on Charge Distribution and Partial Charge Transfer
- EMI Reduction by Spread-Spectrum Clocking in Digitally-Controlled DC-DC Converters
- DSP Code Optimization Utilizing Memory Addressing Operation (Special Section on Digital Signal Processing)
- Design of Low Power Track and Hold Circuit Based on Two Stage Structure
- Multi-Path Analog Circuits Robust to Digital Substrate Noise
- High Speed Transconductance-C-Opamp Integrator Using Current-Feedback Amplifier(Building Block, Analog Circuit and Device Technologies)
- Design Optimization of Active Shield Circuits for Digital Noise Suppression Based on Average Noise Evaluation(Analog Circuit Techniques and Related Topics)
- Equivalent Saturated MOSFET Circuit with Wide Input Range(Analog Circuit Techniques and Related Topics)
- Optimized Design of Active Shield Circuit with Consideration on On-chip Layout
- Rail-to-Rail V-I Conversion Using a Pair of Single Channel MOSFETs Operating in Plural Regions
- Extension of Current Conveyor Concept and Its Applications
- Fully On-Chip Active Guard Band Circuit for Digital Noise Cancellation(Special Section on Analog Circuit Techniques and Relate)
- Wide-Input Range Linear Voltage-to-Current Converter Using Equivalent MOSFETs without Cutoff Region(Special Section on Analog Circuit Techniques and Related Topics)
- Design Optimization of Active Guard Band Circuit with Consideration on Device Matching and Frequency Characteristic
- High PSRR Active Guard Band Circuit For Digital Noise Suppression
- A Novel Design Strategy for Class A CMOS Second Generation Current Conveyors(Special Section on Analog Circuit Techniques Supporting the System LSI Era)
- Substrate Noise Suppression Using Active Guard Band Circuit
- A BiCMOS Seventh-Order Lowpass Channel-Select Filter Operating at 2.5V Supply for a Spread-Spectrum Wireless Receiver(Special Section on Analog Circuit Techniques and Related Topics)
- Zero Common-Mode Gain Fully Balanced Circuit Structure
- Design of an All-Pass Filter using a class AB 3-Input CMOS OTA
- Integrator-Based Filter Structures with Good Frequency Characteristics
- Design of a Novel Linear 3-Input CMOS OTA and Its Application to Filter Realization
- An Area-Efficient and Highly-Linear CMOS Four-Quadrant Analog Multiplier
- Forward Subchannel Control Scheme for TDD Multi-Carrier Mobile Communication System (Special Section on Multi-dimensional Mobile Information Networks)
- Over Current Protection for PFM Control DC-DC Converter
- High Efficiency DC-DC Converter for Wide-ranging Loads with Gradual Reverse Current Stopping Technique
- SAR ADC Algorithm with Redundancy and Digital Error Correction
- Impurity Spin resonance in Antiferromagnetic CoCl_22H_2O
- Minimization of Output Errors of FIR Digital Filters by Multiple Decompositions of Signal Word
- Reduction of Bootstrapped Switch Area Consumption Using Pre-Charge Phase
- Rail-to-Rail OTA Based on Signal Decomposition(Analog Circuit Techniques and Related Topics)
- Wide Tuning Range Voltage-Controlled Ring Oscillator(Devices and Circuits for Next Generation Multi-Media Communication Systems)
- Mapping Circuit for Rail-to-Rail Operation
- New Estimation Method for Fatty Acid Composition in Oil Using Near Infrared Spectroscopy(Analytical Chemistry)
- Higher Order Spectra Analysis of Nonstationary Harmonizable Random Processes
- Automated Design of Analog Circuits Accelerated by Use of Simplified MOS Model and Reuse of Genetic Operations(Analog Circuits and Related SoC Integration Technologies)
- An Unwrapping of Signals in Transform Domain and Its Application in Signal Reconstruction
- A Reassignment Method for Improved Readability of Time-Frequency Representations
- Active Shield Circuit for Digital Noise Suppression in Mixed-Signal Integrated Circuits(Analog Circuit Techniques and Related Topics)
- Reduction in Element Value Spreads on Integrator-Based Filters
- Topology-Independent Predistortion for Integrator-Based Filters (Special Section on Analog Technologies in Submicron Era)
- Jitter Tolerant Continuous-Time Sigma-Delta A-D Converter Employing In-Loop Low-Pass Filter(Analog Circuit Techniques and Related Topics)
- リニア誘導モータを応用したレールブレーキの設計と実験的検証
- Production Test Considerations for Mixed-signal IC with Background Calibration
- 零出力発電制動を用いたリニアモータ型レールブレーキの励磁電源レス運転
- SAR ADC Architecture with Digital Error Correction
- Operational Transconductance Amplifier with Rail-to-Rail Input Stage Using Single Channel Type MOSFETs(Special Section on Analog Circuit Techniques and Related Topics)
- A Rail-to-Rail CMOS Voltage Follower under Low Power Supply Voltage(Special Section on Analog Circuit Techniques Supporting the System LSI Era)
- Low Voltage OTA Using Two-MOSFET Subtractors between Rails(Special Section on Analog Circuit Techniques and Related Topics)
- Wide Dynamic Range MOS Analog Inverter (Special Issue on Circuit Technologies for Memory and Analog LSIs)
- MOSFET Instantaneous Companding Integrator(Special Section on Analog Circuit Techniques Supporting the System LSI Era)
- Design of Active Shield Circuit with Automatic Tuning Scheme(Mixed Signal, Analog Circuit and Device Technologies)
- 低電圧低周波電流モ-ドフィルタ
- Capacitance Reduction Technique for Switched-Capacitor Circuits Based on Charge Distribution and Partial Charge Transfer
- Automated Design of Analog Circuits Using a Cell-Based Structure
- Special Section on Analog Circuit Techniques and Related Topics
- Design of Wideband Linear Voltage-to-Current Converters
- Automated Design of Analog Circuits Starting with Idealized Elements(VLSI Design Technology and CAD)
- Experimental study on liquefaction of saturated sand contained a little clay
- A Simulation Study of a Controlled Tokamak Plasma
- The asymptotic periodic waveform evaluation method for steady state analysis
- GaAs MESFET High Frequency Current Mirror
- Steep Down-Slope Sawtooth Wave Generator Utilizing Two Triangluar Waves Exclusively
- GaAs MESFET high output impedance current mirror
- GaAs FET Current-Mode Integrators and Their Application to Filters (Special Section on Analog Circuit Techniques and Related Topics)
- Rail-to-Rail OTA Utilizing Linear V-I Conversion Circuit Whose Input Stage is Composed of Single Channel MOSFETs(Selected Papers from the 17th Workshop on Circuits and Systems in Karuizawa)
- GaAs MESFET Linearized Transconductor and Active Load with no CMFB (Special Section on Analog Circuit Techniques for System-on-Chip Integration)
- A Design of MOSFET-C Impedance Simulation Circuits Based on a GIC
- Realization of Leapfrog Filters Using Current Differential Buffered Amplifiers
- Low-Power Switched-Current Track-and-Hold Circuit
- Design for Testability That Reduces Linearity Testing Time of SAR ADCs
- Moment Functions for Fast Discrete Wigner Trispectrum
- Implementation of Low-Noise Switched-Capacitor Integrators with Small Capacitors
- Implementation of Low-Noise Switched-Capacitor Low-Pass Filter with Small Capacitance Spread