Preparation of Diamond-Like Carbon on Ti Film with Tetramethylsilane Buffer Layer

スポンサーリンク

概要

• 論文の詳細を見る

• Diamond-like carbon (DLC) has been applied as a coating material to improve the basic properties of strength, chemical stability, and biocompatibility. In this study, a DLC film was prepared on a titanium (Ti) coating film with tetramethylsilane (TMS) buffer for application in vivo. Although the surface roughness of the Ti film increased with increasing Ti thickness, both TMS and DLC coatings deposited on Ti films resulted in the formation of a flat surface. Observation of the initial growth of the TMS layer indicated that a TMS buffer of more than 50 nm thickness was required for DLC coating even on the flat surface of the Ti thin film.

• The Japan Society of Applied Physicsの論文
• 2013-11-25

著者

• Kaneko Satoru

  Kanagawa Industrial Technol. Center Kanagawa Jpn

• TAKAGI Shin-ichi

  Kanagawa Industrial Technology Research Institute

• Yasui Manabu

  Kanagawa Industrial Technology Center, 705-1 Shimoimaizumi, Ebina, Kanagawa 243-0435, Japan

• Horiuchi Takahiro

  Kanagawa Industrial Technology Center, Kanagawa Prefectural Government, 705-1 Shimo-Imaizumi, Ebina, Kanagawa 243-0435, Japan

• ITO Takeshi

  Kanagawa Industrial Technology Center

• Matsunaga Takashi

  Technology Research Institute of Osaka Prefecture, Izumi, Osaka 594-1157, Japan

• Saitoh Mitsuhiro

  Kanagawa Industrial Technology Center, Ebina, Kanagawa 243-0435, Japan

• Ikenaga Kaoru

  NDK, Inc., Sagamihara 252-0212 Japan

• Yasuhara Shigeo

  Japan Advanced Chemicals, Sagamihara 252-0131, Japan

• Mihirogi Katsuhiro

  Japan Advanced Chemicals, Sagamihara 252-0131, Japan

• Kobayashi Masazumi

  KOBASEI, Sagamihara 252-0331, Japan

• Kumagai Masao

  FUJI WPC, Sagamihara 252-0331, Japan

• Shimodaira Eiji

  FUJI WPC, Sagamihara 252-0331, Japan

• Sudo Rieko

  Sagamihara Incubation Center, Sagamihara 252-0212, Japan

• Horiuchi Takahiro

  Kanagawa Industrial Technology Center, Ebina, Kanagawa 243-0435, Japan

• Takagi Shin-ichi

  Kanagawa Industrial Technology Center, Ebina, Kanagawa 243-0435, Japan

関連論文

• Structural Modulation in Oxygen Deficient Epitaxial Bi_2Sr_2Ca_1Cu_2O_X Observed by X-ray Reciprocal Space Mapping
• Epitaxial Yttria-stabilized Zirconia (YSZ) Film Deposited on Si(100) Substrate by YAG Laser
• Bi_2Sr_2Ca_1Cu_2O_X Thin Film Deposition by Q-switched YAG Laser
• Twin-Free Epitaxial Films Lateral Relation between YSZ(111) and Si(111)
• Fabrication of High Performance Polymeric Microfluidic Device by a Simple Imprinting Method using a Photosensitive Sheet
• Metalorganic Chemical Vapor Deposition of Epitaxial Perovskite SrIrO_3 Films on (100)SrTiO_3 Substrates
• Epitaxial Growth of β-FeSi_2 on Single Crystal Insulator
• Application of Microchip Fabricated of Photosensitive Glass for Thermal Lens Microscopy : Instrumentation, Measurement, and Fabrication Technology
• Effect of Strain in Epitaxially Grown SrRuO_3 Thin Films on Crystal Structure and Electric Properties
• Amplified Electrochemical Detection Based on Redox Cycle at a Liquid/Liquid Interface Formed in a Microchannel
• Void Formation by the Reactive Diffusion of Titanium and Aluminum Foils
• Mass Density as Basis Parameter on Mechanical Properties under Diamond-Like Carbon Prepared in Wide Range of Conditions Using Variety of Methods
• Fabrication of Ni/Al2O3/Ni Heteroepitaxial Junction by Post-Hydrogen Reduction of NiO/Al2O3/NiO Trilayered Epitaxial Thin Film
• Fabrication of Ferromagnetic Ni(111) Nanoparticles Embedded Epitaxially in (Mg,Ni)O Matrix by Reduction of (Mg0.5Ni0.5)O(111) Epitaxial Thin Film
• Micro Press Molding of Borosilicate Glass Using Plated Ni–W Molds
• Twin-Free Epitaxial Films Lateral Relation between YSZ(111) and Si(111)
• Supercell Structure on Continuous Growth of Bi2Sr2Ca1Cu2Ox Film
• Effect of Strain on Supercell Structure of Bismuth Cuprate Superconducting Film
• Large Lattice Misfit on Epitaxial Thin Film: Coincidence Site Lattice Expanded on Polar Coordinate System
• Evolution of Atomically Stepped Surface of Indium Tin Oxide Thin Films Grown on Nanoimprinted Glass Substrates
• Epitaxial Orientation of $\beta$-FeSi2 on 3C-SiC/Si(111)
• Synthesis of Mica Thin Film by Pulsed Laser Deposition
• Numerical Simulation of Glass Imprinting for Molding Temperature Prediction
• Assessing Aptitude of Plated Ni–W Film as Mold Materials for Borosilicate Glass
• Room-Temperature Epitaxial Growth of (Li,Ni)O Thin Film with Li Content up to 60 mol %
• Fabrication of High Performance Polymeric Microfluidic Device by a Simple Imprinting Method using a Photosensitive Sheet
• Growth of Nanocubic MgO on Silicon Substrate by Pulsed Laser Deposition
• 金ナノ粒子を用いた三次元櫛形電極の作製とバイオセンシングヘの応用
• Epitaxial Indium Tin Oxide Film Deposited on Sapphire Substrate by Solid-Source Electron Cyclotron Resonance Plasma
• Development of Ni–P-Plated Inconel Alloy Mold for Imprinting on Pyrex Glass
• Fabrication of Glassy Carbon Molds Using Hydrogen Silsequioxane Patterned by Electron Beam Lithography as O2 Dry Etching Mask
• Effect of Buffer Layer on Epitaxial Growth of YSZ Deposited on Si Substrate by Slower Q-switched 266 nm YAG Laser
• Epitaxial Growth of Ferromagnetic Iron Silicide Thin Films on Silicon with Yttria-Stabilized Zirconia Buffer Layer
• Epitaxial Pt Films with Different Orientations Grown on (100)Si Substrates by RF Magnetron Sputtering
• Photoluminescence Properties from $\beta$-FeSi2 Film Epitaxially Grown on Si, YSZ and Si//YSZ
• Epitaxial Growth of (100)-Oriented $\beta$-FeSi2 Thin Films on Insulating Substrates
• Preparation of Diamond-Like Carbon on Ti Film with Tetramethylsilane Buffer Layer
• Property Variation of Ni--W Electroformed Mold for Micro-Press Molding
• Effects of post exposure bake temperature and exposure time on SU-8 nanopattern obtained by electron beam lithography

もっと見る 閉じる

スポンサーリンク