A Triple-Band WCDMA Direct Conversion Receiver IC with Reduced Number of Off-Chip Components and Digital Baseband Control Signals

概要

論文の詳細を見る
This paper presents a triple-band WCDMA direct conversion receiver (DCR) IC that needs a small number of off-chip components and control signals from digital baseband (DBB) IC. The DCR IC consists of 3 quadrature demodulators (QDEMs) with on-chip impedance matching circuit and an analog baseband block (ABB) that contains a low-pass filter (LPF) with fc automatic tuning circuit using no off-chip components and a linear-in-dB variable-gain amplifier (VGA) with on-chip analog high-pass filter (HPF). In order to make use of DBB control-free DC offset canceler, the DCR is designed to avoid large gain change under large interference that causes long transient response. In order to realize that characteristic without increasing quiescent current, the QDEM is used that employs class AB input stage and low-noise common mode feedback (CMFB) output stage. The DCR IC was fabricated in a SiGe BiCMOS process and occupies about 2.9mm×3.0mm. The DCR needs SAW filters only for off-chip components and a gain control signal from DBB IC for AGC loop. The IIP3 of over -4.4dBm for small signal input level and that of over +1.9dBm for large signal input level are achieved. The gain compression of the desired signal is less than 0.3dB for ACS Case-II condition.
（社）電子情報通信学会の論文
2008-06-01