Contamination Evaluation System for Extreme Ultraviolet Mirrors with the Use of Undulator Radiation
スポンサーリンク
概要
- 論文の詳細を見る
A high-intensity extreme ultraviolet (EUV) irradiation and reflectivity measurement system was developed in order to add a contamination inhibition mechanism to Mo/Si multilayer mirrors for EUV lithography. The system can irradiate EUV light at a high flux density of 500 mW/mm2, and it can measure the reflectivity change in situ. As a first experiment using this equipment, irradiation on a Si-capped multilayer was carried out. In this experiment, the water vapor pressure was changed, and changes in the reflectivity were examined. As a result, the decrease in reflectivity increased with an increase in the water vapor pressure. In the meantime, it was indicated that the decrease in reflectivity at an equal dose reversed when the irradiation intensity was lowered using a filter. As a result of surface analysis, the Si-capping layer was oxidized in the irradiation area, and there was deposition of C in the outer part of the irradiation area.
- 2005-07-15
著者
-
Fukuda Yasuaki
Extreme Ultraviolet Lithography System Development Association (euva)
-
Kakutani Yukinobu
Laboratory Of Advanced Science And Technology For Industry University Of Hyogo
-
Niibe Masahito
Laboratory of Advanced Science &Technology for Industry, Himeji Institute of Technology
-
Terashima Shigeru
Extreme Ultraviolet Lithography System Development Association (EUVA), 11th Floor, Kawasaki East One Building, 11-1 Ekimae-honcho, Kawasaki-ku, Kawasaki 210-0007, Japan
-
Matsunari Shuichi
Extreme Ultraviolet Lithography System Development Association (EUVA), 11th Floor, Kawasaki East One Building, 11-1 Ekimae-honcho, Kawasaki-ku, Kawasaki 210-0007, Japan
-
Aoki Takashi
Extreme Ultraviolet Lithography System Development Association (EUVA), 11th Floor, Kawasaki East One Building, 11-1 Ekimae-honcho, Kawasaki-ku, Kawasaki 210-0007, Japan
-
Kondo Hiroyuki
Extreme Ultraviolet Lithography System Development Association (EUVA), 3-23 Kanda Nishiki-cho, Chiyoda-ku, Tokyo 101-0054, Japan
-
Takase Hiromitu
Extreme Ultraviolet Lithography System Development Association (EUVA), 3-23 Kanda Nishiki-cho, Chiyoda-ku, Tokyo 101-0054, Japan
-
Gomei Yoshio
Extreme Ultraviolet Lithography System Development Association (EUVA), 3-23 Kanda Nishiki-cho, Chiyoda-ku, Tokyo 101-0054, Japan
-
Kakiuchi Kazuya
Laboratory of Advanced Science and Technology for Industry, University of Hyogo, 3-1-2 Kouto, Kamigoori-cho, Ako-gun, Hyogo 678-1205, Japan
関連論文
- Stress Changes and Stability of Sputter-Deposited Mo/B_4C Multilayer Films for Extreme Ultraviolet Mirrors
- Contrast Measurement of Reflection Masks Fabricated from Cr and Ta Absorbers for Extreme Ultraviolet Lithography
- Nonlinear behavior of decrease in reflectivity of multilayer mirrors for extreme ultraviolet lithography optics by high-flux extreme ultraviolet irradiation in various vacuum environments (Special issue: Microprocesses and nanotechnology)
- Fabrication of Aspherical Mirrors for Extreme Ultra-Violet Lithography (EUVL) Using Deposition Techniques
- A Novel Design of Three-Aspherical-Mirror Imaging Optics for Extreme Ultra-Violet Lithography
- Damage Characteristics of TiO2 Thin Film Surfaces Etched by Capacitively Coupled Radio Frequency Helium Plasmas
- Effect of Dielectric Barrier Discharge Air Plasma Treatment on TiO2 Thin Film Surfaces
- A Novel Design of Three-Aspherical-Mirror Imaging Optics for Extreme Ultra-Violet Lithography
- Inhibition of Contamination of Ru-Capped Multilayer Mirrors for Extreme Ultraviolet Lithography Projection Optics by Ethanol
- New Extreme Ultraviolet Irradiation and Multilayer Evaluation System for Extreme Ultraviolet Lithography Mirror Contamination in the NewSUBARU
- Contamination Evaluation System for Extreme Ultraviolet Mirrors with the Use of Undulator Radiation
- Defect Evolution in Multiwalled Carbon Nanotube Films Irradiated by Ar Ions
- Thermal Durability of Diamond Like Carbon Films Containing Tungsten Fabricated by Focused-Ion-Beam Chemical Vapor Deposition
- Annealing Effect of W Incorporated Diamond-Like Carbon Fabricated by Ga Focused Ion Beam Chemical Vapor Deposition
- Characteristics of TiO2 Thin Film Surfaces Treated by Helium and Air Dielectric Barrier Discharge Plasmas
- Damage Analysis of Plasma-Etched n-GaN Crystal Surface by Nitrogen K Near-Edge X-ray Absorption Fine Structure Spectroscopy
- Damage Analysis of n-GaN Crystal Etched with He and N2 Plasmas
- X-ray Absorption Studies on the Growth Process of Radio-Frequency-Magnetron-Sputtered Boron Nitride Films: Effects of Bias Voltage and Substrate Temperature
- Comparison between Damage Characteristics of p- and n-GaN Surfaces Etched by Capacitively Coupled Radio Frequency Argon Plasmas (Special Issue : Dry Process)
- X-ray Absorption Studies on the Growth Process of Radio-Frequency-Magnetron-Sputtered Boron Nitride Films : Effects of Bias Voltage and Substrate Temperature