Non-linear Finite Element Analysis of the Failure Progression of Fiber-reinforced Ceramics Produced by Tape Casting Technique
スポンサーリンク
概要
- 論文の詳細を見る
The purpose of this study was to investigate the failure progression process of fiber-reinforced ceramic by finite element (FE) analysis. The three-dimensional FE model for three-point bending simulation was 40mm long, 4mm wide, 3mm thick, and with a span length of 30mm. Nodal force with load increment of 20 N was applied at the center of the upper surface of the beam. To evaluate matrix fracture and fiber fracture, von Mises criterion and Tsai-Hill criterion were used respectively. Consequently, the stress-deflection curve obtained from FE simulation agreed with that obtained from the experimental testing. Differences in flexural strength and modulus between the analytical and experimental results were 1.3 and -2.9% respectively - demonstrating a close agreement between both results. In conclusion, the FE model applied in the present study was shown to be valid for predicting the failure progression of fiber-reinforced ceramics.
- 日本歯科理工学会の論文
著者
-
HAYAKAWA Tohru
Department of Dental Biomaterial, Nihon University School of Dentistry at Matsudo
-
NEMOTO Kimiya
Department of Dental Biomaterials, Nihon University School of Dentistry at Matsudo
-
Nemoto Kimiya
Department Of Dental Biomaterials Research Institute Of Oral Science Nihon University School Of Dent
-
Nemoto Kimiya
Department Of Dental Biomaterials Nihon University School Of Dentistry At Matsudo
-
Nemoto Mika
Department Of Crown And Bridge Prosthodontics Nihon University School Of Dentistry:division Of Advan
-
Tanimoto Yasuhiro
Departments of Dental Biomaterials, Nihon University School of Dentistry at Matsudo
-
NISHIWAKI Tsuyoshi
Research and Development Department, ASICS Corporation
-
Tanimoto Y
Department Of Dental Biomaterials Research Institute Of Oral Science Nihon University School Of Dent
-
Tanimoto Yasuhiro
Department Of Dental Biomaterials Nihon University School Of Dentistry At Matsudo
-
Tanimoto Yasuhiro
Department Of Dental Materials Research Institute Of Oral Science Nihon University School Of Dentist
-
Hayakawa Tohru
Department Of Dental Biomaterial Nihon University School Of Dentistry At Matsudo
-
Hayakawa Tohru
Nihon Univ. Graduate School Of Dentistry At Matsudo Chiba Jpn
-
Hayakawa Tohru
Department Of Appilied Biology Faculty Of Textile Science Kyoto Institute Of Technology
-
Nemoto K
Nihon Univ. School Of Dentistry At Matsudo Chiba Jpn
-
Nishiwaki Tsuyoshi
Research And Development Department Asics Corporation
-
Nishiwaki Tsuyoshi
Asics Corp.
関連論文
- Discoidin Domain Receptor-1 Gene Expression of Osteoblasts on Fibronectin Coated Titanium Disks
- Development of dual-curing type experimental composite resin cement for orthodontic bonding : Effect of additional amount of accelerators on the mechanical properties
- NMR Study on the Adhesion Efficacy of Experimental Phosphonic Acid Monomers
- Thin Carbonate Apatite Layer Deposited on Titanium using Molecular Precursor Method
- Molecular Precursor Method Can Coat Thin Carbonate-containing Apatite (CA) Film inside Titanium Fiber Mesh
- Cell-adhesive Protein Immobilization Using Tresyl Chloride-activation Technique for the Enhancement of Initial Cell Attachment
- Frontier Molecular Orbital Study for the Reaction of Tresyl Chloride
- Deposition of Thin Calcium Phosphate Film onto Titanium Using RF Magnetron Sputtering Technique
- Effect of Acidic Primers on Bonding Three Magnetic Steel Alloys with Tri-n-butylborane Initiated Methacrylic Resin
- Properties of an Indirect Composite Material Polymerized with Two Different Laboratory Polymerizing Systems
- Localization of a novel 252-kDa plasma membrane protein that binds Cry1A toxins in the midgut epithelia of Bombyx mori
- Immobilization of Fibronectin onto Organic Hexamethyldisiloxane Coatings with Plasma Surface Modification : Analysis of Fibronectin Adsorption Using Quartz Crystal Microbalance-dissipation Technique
- X-ray Phase-Contrast Imaging and X-ray Absorption Fine Structure Analysis using Parametric X-ray Radiation Generated at LEBRA, Nihon University
- Polycationic protamine for water-insoluble complex formation with DNA
- A Clinical and Histopathological Study of Guided Bone Regeneration Using Polytetrafluoroethylene Membrane in the Wound Resulting from Human Tooth Extraction
- Dynamic Viscoelastic Behavior of Dental Composites Measured by Split Hopkinson Pressure Bar
- Non-linear Finite Element Analysis of the Failure Progression of Fiber-reinforced Ceramics Produced by Tape Casting Technique
- A Simplified Numerical Simulation Method of Bending Properties for Glass Fiber Cloth Reinforced Denture Base Resin
- Bonding Durability between Orthodontic Brackets and Human Enamel treated with Megabond Self-etching Primer Using 4-META/MMA-TBB Resin Cement
- SEM Observation of Human Enamel and Resin Tag Formation After Phosphoric Acid Etching : Influence of Saliva Contamination
- Development of Self-etching Primer Adhesive in All-in-one Bonding System
- Tensile Bond Strength of 4-META/MMA-TBB Resin to Ground Bovine Enamel Using a Self-etching Primer
- Influence of Apatite Crystallinity in Porous PLGA/Apatite Composite Scaffold on Cortical Bone Response
- Pre-intercalated DNA/Lipid/PLGA Film as a Drug Carrier
- Complexation of DNA with Cationic Polyamino Acid for Biomaterial Purposes
- Preparation and Tissue Response of Lipid-coated b-FGF
- Drug Binding and Releasing Characteristics of DNA/Lipid/PLGA Film
- Monitoring of DNA Complex Formation by Means of Quartz Crystal Microbalance
- PBS Buffer Solutions with Different pH Values Can Change Porosity of DNA-chitosan Complexes
- Antibacterial Activities and Bonding of MMA/TBB Resin Containing Amphiphilic Lipids
- Comparison of Bone Mineral Density and Area of Newly Formed Bone Around Ti-15%Zr-4%Nb-4%Ta Alloy and Ti-6%Al-4%V Alloy Implants
- A Novel 96-kDa Aminopeptidase Localized on Epithelial Cell Membranes of Bombyx mori Midgut, Which Binds to Cry1Ac Toxin of Bacillus thuringiensis
- Increase in Indole -3- acetic Acid (IAA) level and Nitrilase Activity in Turnips Induced by Plasmodiophora brassicae Infection
- Mode Superposition Transient Dynamic Analysis for Dental Implants with Stress-absorbing Elements : A Finite Element Analysis
- Adhesion of Restorative Resin to Teeth: Effects of Functional Groups of Dentin Primer to Collagen
- Application of Finite Element Analysis for Taper Implant-abutment Joints in Dental Implant Systems
- Influence of Cortical Bone Quality on Stress Distribution in Bone around Dental Implant
- Effect of Base Monomer's Refractive Index on Curing Depth and Polymerization Conversion of Photo-cured Resin Composites
- Effects of sintered apatite on bone regeneration in rabbits
- Conformational and Quantum Analysis of Dental Adhesive Carboxylic Acid and Carboxylic Acid Anhydride Monomers
- Effectiveness of the Addition of Water-soluble Photoinitiator into the Self-etching Primers on the Adhesion of a Resin Composite to Polished Dentin and Enamel
- Effect of Varying HAP/TCP Ratios in Tape-cast Biphasic Calcium Phosphate Ceramics on Response in vitro
- In vitro Study of Collagen Coating of Titanium Implants for Initial Cell Attachment
- Influence of Bovine Dentin Site on the Bond Strength of Resin Cement
- Application of High Resolution Microfocus X-ray CT for the Observation of Human Tooth
- A-58. Systematic Pituitary Function Tests of the Sellar and Parasellar Tumor Cases
- Enhancement of baculovirus infection in Spodoptera exigua (Lepidoptera: Noctuidae) larvae with Autographa californica nucleopolyhedrovirus or Nicotiana tabacum engineered with a granulovirus enhancin gene
- Comparison of Otoraplin Gene Expressions in Osteoblasts Grown on Fibronectin and GRGDSP Peptide-Coated Titanium Disks
- Physical Mapping of Bombyx mori Nuclear Polyhedrosis Virus Strain D1 : Identification of Novel Interspersed Homologous Regions
- Efficacy of Water-soluble Photoinitiator on the Adhesion of Composite Resin to Bovine Teeth in All-in-one Bonding System
- Gene expression monitoring in osteoblasts on titanium coated with fibronectin-derived peptide
- Effect of Oral Administration of High Advanced-Collagen Tripeptide (HACP) on Bone Healing Process in Rat
- Modification of 4-META/MMA-TBB Resin for Safe Debonding of Orthodontic Brackets : Influence of the Addition of Degradable Additives or Fluoride Compound
- Effect of Thermal Cycling on Shear Bond Strength with Different Types of Self-etching Primer for Bonding Orthodontic Brackets using a MMA-based Resin
- Influence of silane coupling agent on the bonding of orthodontic brackets to porcelain teeth
- Atomic Force Mcroscopic Images of Acidic Conditioning Agents on Various Regions of Human Dentin
- Physical map of a Plutella exlostella granulovirus genome
- Gene Expression of MC3T3-E1 Cells on Fibronectin-immobilized Titanium Using Tresyl Chloride Activation Technique
- Influence of the Human Skin Model on Cell Viability Test and the Formation Test of Tubule-like Structures by Very Low Concentrations Copper, Titanium and Zinc Ions
- Apatite Deposition on Several Dental Biodegradable Materials in Simulated Body Fluid
- VIBRATION PROPERTIES OF SANDWICH INJECTION MOLDINGS
- Changes in Bone Quality Associated with the Mineralization of New Bone Formed Around Implant : Using XPS, Polarized Microscopy, and FTIR imaging
- Pit Formation in Human Enamel and Dentin Irradiated using the 2.94 μm LEBRA-Free Electron Laser
- Tensile Damage Analysis Method for Composite Laminates Using a Quasi-3-Dimensional Model
- Development of Al_2O_3 Fiber-reinforced Al_2O_3-based Ceramics
- SEM analysis of microstructure of adhesive interface between resin cement and dentin treated with self-etching primer
- Fibronectin Adsorption onto Plasma-polymerized Hexamethyldisiloxnane Coating
- Conformational Analysis of Bisphosphonate/Calcium Complex
- Collagen Nanofiber on Titanium or Partially Stabilized Zirconia by Electrospray Deposition
- Free Radical Study Using Electron Spin Resonance and Structural Analysis by Nuclear Magnetic Resonance of the Carisolv System
- Effects of Indentation Load on the Mechanical Behavior of Orthodontic Wire Alloys by Dynamic Micro-Indentation Method
- Influence of thickness and undercut of thermoplastic resin clasps on retentive force
- Adsorption study of pellicle proteins to gold, silica and titanium by quartz crystal microbalance method
- Evaluating the Dynamic Behavior of Taper Joint Implants Under Different Loading Conditions:A Transient Dynamic Finite Element Analysis
- Efficacy of Self-etching Primer containing Water-soluble Monomers in the Adhesion of 4-META/MMA-TBB Resin to Bovine Ground Enamel
- Experimental and Theoretical Approach for Evaluating the Flexural Properties of a Denture Base Material Relined with Three Soft Lining Materials