Influence of Water-Soluble Polymers on the Dissolution of Nifedipine Solid Dispersions with Combined Carriers
スポンサーリンク
概要
- 論文の詳細を見る
The objective of this investigation was to clarify the influence of water-soluble polymers on the dissolution behavior of nifedipine from solid dispersions with combined carriers. All the solid dispersions of nifedipine were prepared by the fusion method using nicotinamide and 4 different water-soluble polymers, hydroxypropylmethylcellulose (HPMC), polyvinylpyrrolidone (PVP), partially hydrolyzed polyvinyl alcohol (PVA) and pullulan. HPMC, PVP or PVA dissolved in the fused liquid of nicotinamide and operated efficiently on the amorphous formation of nifedipine in solid dispersions. In dissolution studies, the drug concentration for these dispersions increased to more than twice intrinsic drug solubility. The rank order of the drug concentration was HPMC>PVP>PVA. However, since pullulan did not dissolve in the fused nicotinamide, nifedipine was present as a crystalline state in the solid dispersion; the supersaturation behavior of the drug was scarcely observed. The compatibility, namely, the solubility and miscibility, between nicotinamide or nifedipine and the polymers, was determined by differential scanning calorimetry using the mixtures treated with fusing and subsequent rapid cooling. Both HPMC and PVP exhibited high compatibility not only with nicotinamide but also with nifedipine. The crystallization behavior of nifedipine from a supersaturated solution containing nicotinamide or the polymers was studied. The inhibitory effect of HPMC or PVP for drug crystallization was evident, which would be related not to the solubilizing effect but to the adhesive force of the polymer for the drug. Therefore, it was understood that the use of a polymer with high compatibility and adhesion with nifedipine provides a high supersaturation level of the drug in dissolution. Further, the solubility parameter was found to be useful for selecting a suitable polymer as a component of combined carriers.
- 公益社団法人日本薬学会の論文
- 1998-03-15
著者
-
Suzuki Hideshi
Fuji Laboratory Janssen Pharmaceutical K. K.
-
Sunada Hisakazu
Faculty Of Pharmacy Meijo University
関連論文
- Studies of Rapidly Disintegrating Tablets in the Oral Cavity Using Co-ground Mixtures of Mannitol with Crospovidone
- Preparation of Rapidly Disintegrating Tablets Containing Itraconazole Solid Dispersions
- Rapidly Disintegrating Tablets Prepared by a Surface-Modifying Method : Comparison of Disintegrants
- Preparation and Evaluation of Solid Dispersions of Nitrendipine Prepared with Fine Silica Particles Using the Melt-Mixing Method
- Preparation and Evaluation of Solid Dispersion for Nitrendipine-Carbopol and Nitrendipine-HPMCP Systems Using a Twin Screw Extruder
- Evaluation of Bitterness Suppression of Macrolide Dry Syrups by Jellies
- Preparation and Evaluation of a Compressed Tablet Rapidly Disintegrating in the Oral Cavity
- Analysis of the Release Process of Phenylpropanolamine Hydrochloride from Ethylcellulose Matrix Granules V. : Release Properties of Ethylcellulose Layered Matrix Granules
- Analysis of the Release Process of Phenylpropanolamine Hydrochloride from Ethylcellulose Matrix Granules IV. Evaluation of the Controlled Release Properties for in Vivo and in Vitro Release Systems
- Analysis of the Release Process of Phenylpropanolamine Hydrochloride from Ethylcellulose Matrix Granules III. Effects of the Dissolution Condition on the Release Process
- Analysis of the Release Process of Phenylropanolamine Hydrochloride from Ethylcellulose Matrix Granules II. Effects of the Binder Solution on the Release Process
- Analysis of the Release Process of Phenylpropanolamine Hydrochloride from Ethylcellulose Matrix Granules
- Preparation of Solid Dispersion for Ethenzamide-Carbopol and Theophylline-Carbopol Systems Using a Twin Screw Extruder
- Improvement of the Dissolution Rate of Nitrendipine Using a New Pulse Combustion Drying Method
- Effect of Several Cellulosic Binders and Method of Their Addition on the Properties and Binder Distribution of Granules Prepared in an Agitating Fluidized Bed
- Effect of Process Variables on the Properties and Binder Distribution of Granules Prepared by a High-Speed Mixer
- Preparation and Evaluation of Combination Tablet Containing Incompatible Active Ingredients
- Release from or through a Wax Matrix System. IV. Generalized Expression of the Release Process for a Reservoir Device Tablet
- Release from or through a Wax Matrix System. III. Basic Properties of Release through the Wax Matrix Layer
- Release from or through a Wax Matrix System. II.^ Basic Properties of Release from or through the Wax Matrix Layer
- Dissolution of Solid Dosage Form. VII. Effect of Shape on the Dissolution of Nondisintegrating Single Component Tablet under Non-sink Condition
- Sustained-Release Progesterone Vaginal Suppositories 1 : Development of Sustained-Release Granule(Biopharmacy)
- Influence of Physicochemical Properties on Drug Release Rate from Hydroxypropylmethylcellulose Matrix Tablets
- Influence of Water-Soluble Polymers on the Dissolution of Nifedipine Solid Dispersions with Combined Carriers
- Preparation and Evaluation of Ibuprofen Solid Dispersion Systems with Kollidon Particles Using a Pulse Combustion Dryer System
- Some Factors Influencing the Dissolution of Solid Dispersions with Nicotinamide and Hydroxypropylmethylcellulose as Combined Carriers
- Effect of Process Variables on the Properties and Binder Distribution of Granules Prepared in a Fluidized Bed
- Release from or through a Wax Matrix System VI. : Analysis and Prediction of the Entire Release Process of the Wax Matrix Tablet
- Release from or through a Wax Matrix System. V. Applicability of the Square-Root Time Law Equation for Release from a Wax Matrix Tablet
- Release from or through a Wax Matrix System.I. Basic Release Properties of the Wax Matrix System
- Mechanistic Studies on Hydrotropic Solubilization of Nifedipine in Nicotinamide Solution
- Indomethacin Controlled Release Matrix Tablet Prepared by Wet Granulation Procedure
- Comparison of Nicotinamide, Ethylurea and Polyethylene Glycol as Carriers for Nifedipine Solid Dispersion Systems