Thermal Analysis of AC Contactor Using Thermal Network Finite Difference Analysis Method
スポンサーリンク
概要
- 論文の詳細を見る
To predict the thermal behavior of switchgear quickly, the Thermal Network Finite Difference Analysis method (TNFDA) is adopted in thermal analysis of AC contactor in the paper. The thermal network model is built with nodes, thermal resistors and heat generators, and it is solved using finite difference method (FDM). The main circuit and the control system are connected by thermal resistors network, which solves the problem of multi-sources interaction in the application of TNFDA. The temperature of conducting wires is calculated according to the heat transfer process and the fundamental equations of thermal conduction. It provides a method to solve the problem of boundary conditions in applying the TNFDA. The comparison between the results of TNFDA and measurements shows the feasibility and practicability of the method.
- （社）電子情報通信学会の論文
- 2008-08-01
著者
-
CHEN Degui
State Key Laboratory of Electric Insulation and Power Equipment, Xian Jiaotong University
-
LI Xingwen
State Key Laboratory of Electric Insulation and Power Equipment, Xian Jiaotong University
-
Chen D
State Key Laboratory Of Electrical Insulation And Power Equipment Xi'an Jiaotong University
-
Chen D
School Of Electrical Engineering Xi'an Jiaotong University
-
Li Xingwen
Xi'an Jiaotong Univ. Xi'an Chn
-
Niu Chunping
State Key Laboratory Of Electrical Insulation And Power Equipment Xi'an Jiaotong University
-
Chen Degui
State Key Laboratory Of Electric Insulation And Power Equipment Xi'an Jiaotong University
-
Geng Yingsan
State Key Laboratory of Electrical Insulation and Power Equipment, Xi'an Jiaotong University
-
Li Xingwen
State Key Laboratory Of Electric Insulation And Power Equipment Xi'an Jiaotong University
-
Niu Chunping
State Key Laboratory Of Electric Insulation And Power Equipment Xi'an Jiaotong University
-
Geng Yingsan
State Key Laboratory Of Electrical Insulation And Power Equipment (xi'an Jiaotong University)
-
Geng Yingsan
State Key Laboratory Of Electrical Insulation And Power Equipment Xi'an Jiaotong University
-
Li Xingwen
Xi'an Jiaotong Univ. Chn
-
Li Xingwen
State Key Laboratory of Electrical Insulation and Power Equipment, Xi'an Jiaotong University
関連論文
- Thermal Simulation of a Contactor with Feedback Controlled Magnet System
- Investigation on the Interruption Process of Molded Case Circuit Breakers Including the Influence of Blow Open Force (国際セッションIS-EMD2005) -- (Contactors & Circuit Breakers)
- Calculation and Analysis of Dynamic Characteristics of Multilink Permanent Magnetic Actuator in Vacuum Circuit Breaker
- Analysis of the Dynamic Characteristics of the Permanent Magnetic Actuator with Multi-bar Linkage
- An Integrated Calculation Method to Predict Arc Behavior
- Analysis and Research on Electro-Dynamic Repulsion Force Acting on the Paralleled Conductors in Air Circuit Breaker(Contactors & Circuit Breakers,Recent Development of Electromechanical Devices (Selected Papers from ICEC2006))
- Modeling of the Combination Wave Generator and Simulation of the Surge Immunity Test
- A New Design of Arc Chamber to Improve the Interruption Performance
- Preliminary Study of the Magnetic Method Used to Measure Air Arc Behavior
- A New Method to Evaluate the Short-Time Withstand Current for Air Circuit Breaker
- Analysis and Optimization for a Contactor with Feedback Controlled Magnet System
- Effect of Back-Volume of Arc-Quenching Chamber on Arc Behavior
- Analysis and Optimization for AC Contactor with Feedback Controlled Magnet System(Session 8 -Contactors & Breakers-)
- Thermal Analysis of AC Contactor Using Thermal Network Finite Difference Analysis Method(Session 7 -Modeling-)
- Dynamic Characteristic Analysis and Optimization for the Energy-Saving and Bounce-Reducing Double-Coil Contactor(Contactors & Circuit Breakers,Recent Development of Electromechanical Devices (Selected Papers from IS-EMD2005))
- Dynamic Characteristic Analysis and Optimization for The Energy-Saving Contactor With Double Coils (国際セッションIS-EMD2005) -- (Contactors & Circuit Breakers)
- Investigation on the Dynamic Characteristics of a Magnetic Release in Molded Case Circuit Breaker(Contactors & Circuit Breakers, IS-EMD2004-Recent Development of Electro-Mechanical Devices)
- Investigation on the Dynamic Characteristics of a Magnetic Release in Molded Case Circuit Breaker(Session 5 : Contactactors & Circuit Breakers)
- Numerical Analysis and Experimental Investigation of Dynamic Behavior of AC Contactors Concerning with the Bounce of Contact(Contactor and Relay)(IS-EMD2003 : Recent Technical Trend of Electro-Mechanical Devices)
- Invited paper Numerical Analysis and Experimental Investigation of Dynamic Behavior of AC Contactors Concerning with the Bounce of Contacts (国際セッションIS--EMD 2003) -- (Session 5 Switching devices)
- Numerical Analysis and Experimental Investigation of Dynamic Behavior of AC Contactors Concerning with the Bounce of Contacts
- Research on the Electrical Performance of CuCrTa and CuCr55 Contact Materials for 126kV Vacuum Interrupter
- Hybridized Time-Domain Macromodeling and Circuit Simulation for Signal Integrity Analysis of the High-Speed Interconnects On PCB (国際セッションIS-EMD2005) -- (Signal Transmission and Optical Connectors)
- A new method to calculate the frequency characteristics of the Rogowski coil based on the frequency simulation(Session 6 : Sensing Devices)
- Theoretical Investigation on the Interference Rejection for the Current Measurement Using Magnetic Sensor Arrays(IS-EMD2003 : Recent Technical Trend of Electro-Mechanical Devices)
- Theoretical investigation on the interference rejection for the current measurement using magnetic sensor arrays (国際セッションIS--EMD 2003) -- (Session 2 Measurements and evaluation)
- Theoretical investigation on the interference rejection for the current measurement using magnetic sensor arrays
- Influence of the Linkage Transfer Position on the Interruption Performance of MCCB
- Simulation of Pressure Rise in Arc Quenching Chamber of Molded Case Circuit Breaker During its Interruption Process
- Simulation and Analysis for a Permanent Contactor with and without Current-Feedback System
- Simulation of the Interruption Process of MCCB with Double Repulsive Contacts
- Simulation and Analysis for a Permanent Contactor with and without Current-feedback System
- Analysis and Optimization for the Operating Mechanism of Air Circuit Breaker
- Analysis and Optimization for the Operating Mechanism of Air Circuit Breaker(Session 8 -Contactors & Breakers-)
- Research on Capacitive Divider with Symmetrical Low-Voltage Arms
- Thermal Analysis of AC Contactor Using Thermal Network Finite Difference Analysis Method
- Effect of Different Vent Configurations on the Interruption Performance of Arc Chamber
- Study of the Main Factors Affecting the Potential Distribution for Porcelain Zinc Oxide Arresters
- New Method to Model the Equivalent Circuit of the Pulse Generator in Electrical Fast Transient/Burst Test
- New Method to Model the Equivalent Circuit of the Pulse Generator in EFT/B Test
- Implementation of ASIC for Monitoring and Control Unit in Intelligent Electrical Apparatus (国際セッションIS-EMD2005) -- (Signal Transmission and Optical Connectors)
- The Influence of the Insulation Baffle of Iron Splitter Plates on Arc Behavior(Session 8 -Contactors & Breakers-)
- Experimental Investigation on the Arc Motion with Different Configurations of Quenching Chamber in AC Contactor(Contactors & Circuit Breakers,Recent Development of Electromechanical Devices (Selected Papers from IS-EMD2005))
- Simulation of SF6 arc characteristic concerning different pressure boundary condition(Session 7 -Modeling-)
- Study of the Effect of Gassing Material on Arc Behavior in Low Voltage Circuit Breaker(Contactors & Circuit Breakers,Recent Development of Electromechanical Devices (Selected Papers from ICEC2006))
- Simulation of Permanent Magnetic Actuators with Multi-magnetic Circuit for High Voltage Vacuum Circuit Breakers
- Investigation on the Interruption Process of Molded Case Circuit Breakers Including the Influence of Blow Open Force(Contactors & Circuit Breakers,Recent Development of Electromechanical Devices (Selected Papers from IS-EMD2005))
- Experimental Investigation on the Arc Motion with Different Configurations of Arc Chamber in AC Contactor (国際セッション IS-EMD2005) -- (Arc Discharges & Related Phenomena)
- Measurement of the Dielectric Recovery Strength and Reignition of AC Contactors(Contactors & Circuit Breakers, IS-EMD2004-Recent Development of Electro-Mechanical Devices)
- Measurement of the Dielectric Recovery Strength and Reignition of AC Contactors(Session 5 : Contactactors & Circuit Breakers)
- Experimental Investigation of the Influence of Several Factors on the Arc Motion of a Model Quenching Chamber with Gas-Driven Arc(Contactor and Relay)(IS-EMD2003 : Recent Technical Trend of Electro-Mechanical Devices)
- Thermal Simulation of a Contactor with Feedback Controlled Magnet System
- Calculation and Analysis of Dynamic Characteristics of Multilink Permanent Magnetic Actuator in Vacuum Circuit Breaker
- A Method to Predict the Spring Parameters of the Adjustable Magnetic Release for Molded Case Circuit Breakers
- A Control Method for Improving Performance of Permanent Magnetic Actuators in Vacuum Circuit Breakers
- Effect of Magnetic Field of Arc Chamber and Operating Mechanism on Current Limiting Characteristics of Low-Voltage Circuit Breakers(Recent Development of Electro-Mechanical Devices (IS-EMD 2002))
- Effect of magnetic field of arc chamber and operating mechanism on current limiting characteristics of low-voltage circuit breakers (国際セッションIS-EMD2002〔英文〕)
- Effect of Different Vent Configurations on the Interruption Performance of Arc Chamber
- A Novel Optical Fiber Measurement System of Arc Motion in Molded Case Circuit Breakers(Contactor and Relay)(IS-EMD2003 : Recent Technical Trend of Electro-Mechanical Devices)
- Simulation of Permanent Magnetic Actuators with Multi-magnetic Circuit for High Voltage Vacuum Circuit Breakers
- Modeling of the Combination Wave Generator and Simulation of the Surge Immunity Test
- The Influence of Back Gas Flow on the Interruption Performance of Low-Voltage Circuit Breaker (Electromechanical Devices)
- Analysis of the Characteristics of an AC Solenoid Magnetic Release with Permanent Magnet (Electromechanical Devices)
- Modeling of the Electrical Fast Transient/Burst Generator and the Standard Injection Clamp
- Environmentally-friendly Switches : Arcing Phenomena in Vacuum and SF_6 Substitutes
- Experimental Study of the Arc Plasma Characteristics in SF_6, N_2, and CO_2
- The Static and Dynamic Analyses of actuator with Branch Magnetic circuit for Electronic trip of Low-Voltage Circuit Breaker
- Analysis of the Characteristics of an AC Solenoid Magnetic Release with Permanent Magnet
- The Influence of Back Gas Flow on the Interruption Performance of Low-Voltage Circuit Breaker
- Environmentally-Friendly Switches: Arcing Phenomena in Vacuum and SF6 Substitutes
- Study of the Interruption Process of the Selective Miniature Circuit Breaker (Electromechanical Devices)
- Study of the Optimization Design of Low Voltage Circuit Breakers : A Systematic Review
- Study of the Interruption Process of the Selective Miniature Circuit Breaker