Experimental Investigation on the Arc Motion with Different Configurations of Quenching Chamber in AC Contactor(Contactors & Circuit Breakers,<Special Section>Recent Development of Electromechanical Devices (Selected Papers from IS-EMD2005))
スポンサーリンク
概要
- 論文の詳細を見る
Two dimensional optical fiber measurement system is used to investigate experimentally the arc motion and reignition with four different configurations of quenching chamber in an AC contactor. It demonstrates that the splitter plate arrangement has significant effect on the arc motion in arc quenching chamber, and fixing arc runner in the first and last splitter plates benefits to arc motion, and increase the dielectric recovery strength. The results are very useful to design the quenching chamber in AC contactor with high performance.
- 社団法人電子情報通信学会の論文
- 2006-08-01
著者
-
CHEN Degui
State Key Laboratory of Electric Insulation and Power Equipment, Xian Jiaotong University
-
LI Xingwen
State Key Laboratory of Electric Insulation and Power Equipment, Xian Jiaotong University
-
Chen D
State Key Laboratory Of Electrical Insulation And Power Equipment Xi'an Jiaotong University
-
Chen D
School Of Electrical Engineering Xi'an Jiaotong University
-
Li Xingwen
Xi'an Jiaotong Univ. Xi'an Chn
-
Chen Degui
State Key Laboratory Of Electric Insulation And Power Equipment Xi'an Jiaotong University
-
Li Xingwen
State Key Laboratory Of Electric Insulation And Power Equipment Xi'an Jiaotong University
-
DAI Ruicheng
State Key Laboratory of Electrical Insulation and Power Equipment, Xi'an Jiaotong University
-
Dai Ruicheng
State Key Laboratory Of Electrical Insulation And Power Equipment Xi'an Jiaotong University
-
Li Xingwen
Xi'an Jiaotong Univ. Chn
-
Li Xingwen
State Key Laboratory of Electrical Insulation and Power Equipment, Xi'an Jiaotong University
関連論文
- Thermal Simulation of a Contactor with Feedback Controlled Magnet System
- Investigation on the Interruption Process of Molded Case Circuit Breakers Including the Influence of Blow Open Force (国際セッションIS-EMD2005) -- (Contactors & Circuit Breakers)
- Calculation and Analysis of Dynamic Characteristics of Multilink Permanent Magnetic Actuator in Vacuum Circuit Breaker
- Analysis of the Dynamic Characteristics of the Permanent Magnetic Actuator with Multi-bar Linkage
- An Integrated Calculation Method to Predict Arc Behavior
- Analysis and Research on Electro-Dynamic Repulsion Force Acting on the Paralleled Conductors in Air Circuit Breaker(Contactors & Circuit Breakers,Recent Development of Electromechanical Devices (Selected Papers from ICEC2006))
- Preliminary Study of the Magnetic Method Used to Measure Air Arc Behavior
- A New Method to Evaluate the Short-Time Withstand Current for Air Circuit Breaker
- Analysis and Optimization for a Contactor with Feedback Controlled Magnet System
- Effect of Back-Volume of Arc-Quenching Chamber on Arc Behavior
- Analysis and Optimization for AC Contactor with Feedback Controlled Magnet System(Session 8 -Contactors & Breakers-)
- Thermal Analysis of AC Contactor Using Thermal Network Finite Difference Analysis Method(Session 7 -Modeling-)
- Dynamic Characteristic Analysis and Optimization for the Energy-Saving and Bounce-Reducing Double-Coil Contactor(Contactors & Circuit Breakers,Recent Development of Electromechanical Devices (Selected Papers from IS-EMD2005))
- Dynamic Characteristic Analysis and Optimization for The Energy-Saving Contactor With Double Coils (国際セッションIS-EMD2005) -- (Contactors & Circuit Breakers)
- Investigation on the Dynamic Characteristics of a Magnetic Release in Molded Case Circuit Breaker(Contactors & Circuit Breakers, IS-EMD2004-Recent Development of Electro-Mechanical Devices)
- Investigation on the Dynamic Characteristics of a Magnetic Release in Molded Case Circuit Breaker(Session 5 : Contactactors & Circuit Breakers)
- Numerical Analysis and Experimental Investigation of Dynamic Behavior of AC Contactors Concerning with the Bounce of Contact(Contactor and Relay)(IS-EMD2003 : Recent Technical Trend of Electro-Mechanical Devices)
- Invited paper Numerical Analysis and Experimental Investigation of Dynamic Behavior of AC Contactors Concerning with the Bounce of Contacts (国際セッションIS--EMD 2003) -- (Session 5 Switching devices)
- Numerical Analysis and Experimental Investigation of Dynamic Behavior of AC Contactors Concerning with the Bounce of Contacts
- Influence of the Linkage Transfer Position on the Interruption Performance of MCCB
- Simulation of Pressure Rise in Arc Quenching Chamber of Molded Case Circuit Breaker During its Interruption Process
- Simulation and Analysis for a Permanent Contactor with and without Current-Feedback System
- Simulation of the Interruption Process of MCCB with Double Repulsive Contacts
- Simulation and Analysis for a Permanent Contactor with and without Current-feedback System
- Analysis and Optimization for the Operating Mechanism of Air Circuit Breaker
- Analysis and Optimization for the Operating Mechanism of Air Circuit Breaker(Session 8 -Contactors & Breakers-)
- Thermal Analysis of AC Contactor Using Thermal Network Finite Difference Analysis Method
- Effect of Different Vent Configurations on the Interruption Performance of Arc Chamber
- Study of the Main Factors Affecting the Potential Distribution for Porcelain Zinc Oxide Arresters
- New Method to Model the Equivalent Circuit of the Pulse Generator in Electrical Fast Transient/Burst Test
- New Method to Model the Equivalent Circuit of the Pulse Generator in EFT/B Test
- The Influence of the Insulation Baffle of Iron Splitter Plates on Arc Behavior(Session 8 -Contactors & Breakers-)
- Experimental Investigation on the Arc Motion with Different Configurations of Quenching Chamber in AC Contactor(Contactors & Circuit Breakers,Recent Development of Electromechanical Devices (Selected Papers from IS-EMD2005))
- Simulation of SF6 arc characteristic concerning different pressure boundary condition(Session 7 -Modeling-)
- Study of the Effect of Gassing Material on Arc Behavior in Low Voltage Circuit Breaker(Contactors & Circuit Breakers,Recent Development of Electromechanical Devices (Selected Papers from ICEC2006))
- Investigation on the Interruption Process of Molded Case Circuit Breakers Including the Influence of Blow Open Force(Contactors & Circuit Breakers,Recent Development of Electromechanical Devices (Selected Papers from IS-EMD2005))
- Experimental Investigation on the Arc Motion with Different Configurations of Arc Chamber in AC Contactor (国際セッション IS-EMD2005) -- (Arc Discharges & Related Phenomena)
- Measurement of the Dielectric Recovery Strength and Reignition of AC Contactors(Contactors & Circuit Breakers, IS-EMD2004-Recent Development of Electro-Mechanical Devices)
- Measurement of the Dielectric Recovery Strength and Reignition of AC Contactors(Session 5 : Contactactors & Circuit Breakers)
- Experimental Investigation of the Influence of Several Factors on the Arc Motion of a Model Quenching Chamber with Gas-Driven Arc(Contactor and Relay)(IS-EMD2003 : Recent Technical Trend of Electro-Mechanical Devices)
- Thermal Simulation of a Contactor with Feedback Controlled Magnet System
- Calculation and Analysis of Dynamic Characteristics of Multilink Permanent Magnetic Actuator in Vacuum Circuit Breaker
- A Method to Predict the Spring Parameters of the Adjustable Magnetic Release for Molded Case Circuit Breakers
- Effect of Magnetic Field of Arc Chamber and Operating Mechanism on Current Limiting Characteristics of Low-Voltage Circuit Breakers(Recent Development of Electro-Mechanical Devices (IS-EMD 2002))
- Effect of magnetic field of arc chamber and operating mechanism on current limiting characteristics of low-voltage circuit breakers (国際セッションIS-EMD2002〔英文〕)
- Effect of Different Vent Configurations on the Interruption Performance of Arc Chamber
- A Novel Optical Fiber Measurement System of Arc Motion in Molded Case Circuit Breakers(Contactor and Relay)(IS-EMD2003 : Recent Technical Trend of Electro-Mechanical Devices)
- The Influence of Back Gas Flow on the Interruption Performance of Low-Voltage Circuit Breaker (Electromechanical Devices)
- Analysis of the Characteristics of an AC Solenoid Magnetic Release with Permanent Magnet (Electromechanical Devices)
- Environmentally-friendly Switches : Arcing Phenomena in Vacuum and SF_6 Substitutes
- Experimental Study of the Arc Plasma Characteristics in SF_6, N_2, and CO_2
- The Static and Dynamic Analyses of actuator with Branch Magnetic circuit for Electronic trip of Low-Voltage Circuit Breaker
- Analysis of the Characteristics of an AC Solenoid Magnetic Release with Permanent Magnet
- The Influence of Back Gas Flow on the Interruption Performance of Low-Voltage Circuit Breaker
- Environmentally-Friendly Switches: Arcing Phenomena in Vacuum and SF6 Substitutes
- Study of the Interruption Process of the Selective Miniature Circuit Breaker (Electromechanical Devices)
- Study of the Optimization Design of Low Voltage Circuit Breakers : A Systematic Review
- Study of the Interruption Process of the Selective Miniature Circuit Breaker