SAW Sensors of Organophosphorous Compound with No Humidity Interference
スポンサーリンク
概要
- 論文の詳細を見る
Surface acoustic wave (SAW) sensors of organophosphorous compounds with no humidity interference are designed. ST-cutX quartz and fluoropolyol (FPOL) film in glassy–rubbery phase are the substrate and chemical interface of the sensors, respectively. The velocity shift and attenuation change increase with the thickness of FPOL. The velocity shift linearly varies with operating frequency when FPOL film is less than 0.02 μm. The operating frequency of the SAW sensor is chosen to be less than 180 MHz for oscillation of sensors. The operating frequency of the SAW sensor can be chosen carefully to induce negligible interference due to humidity. The optimum operating frequency with negligible humidity interference declines as the relative humidity increases in a common environment.
- INSTITUTE OF PURE AND APPLIED PHYSICSの論文
- 2003-03-15
著者
-
Wu Long
Department Of Electrical Enggineering National Cheng-kung University
-
Shen Yu-tang
Department Of Electrical Engineering I-shou University
-
Shen Chi-yen
Department Of Electrical Engineering I-shou University
-
Huang Cheng-liang
Department Of Electrical Enggineering National Cheng-kung University
-
Wu Long
Department of Electrical Engineering, National Cheng Kung University, Tainan, 701, R.O.C.
-
Huang Cheng-Liang
Department of Electrical Engineering, National Cheng Kung University, Tainan, 701, R.O.C.
関連論文
- The Characterization of Surface Acoustic Wave Modes on Rotated Y-Cut Quartz (ST-X Quartz) with Different AIN Film Thickness
- Temperature Compensation With AlN Film on Y-128° LiNbO_3 : Surfaces, Interfaces, and Films
- Crystalline Structure and Surface Morphology of AIN Films Sputtered on Rotated Y-Cut Quartz (ST-Quartz)
- Influence of Manganese on Lanthanum-Doped BaTiO_3
- The Microstructure of ZnO Varistor Doped with Antimony Oxide
- Effect of Cr_2O_3 Additives on Microstructure and Electrical Properties of Nd-Modified PbTiO_3 Ceramics
- Sputtering Highly C-Axis-Oriented AIN Films on Y-128° LiNbO_3
- Influence of Substrate Temperature to Prepare C-Axis-Oriented AlN Films on Rotated Y-cut Quartz(ST-Quartz)
- Effect of Additions on Conduction Properties of ZnO Varistors
- The Effect of Antimony Oxide on the Electrical Properties and Stability of ZnO Varistors
- The Effects of Valence States of Manganese on Electrical Properties of ZnO Varistors
- Grain Growth and Electrical Properties in ZnO Varistors with Various Valence States of Additions
- New Dielectric Material System of La(Mg_Ti_)O_3-CaTiO_3 at Microwave Frequencies
- Liquid Phase Sintering and Microwave Dielectric Properties of NdAlO_3 Ceramics
- Pb(Mg_Nb_)O_3 Ceramics Produced by Modified Two-Stage Calcination Process
- Influence of Calcining Temperature on CuO-Modified (Ba_Sr_)(Ti_Zr_)O_3 Ceramics
- Effect of B_2O_3 Additives on Sintering and Microwave Dielectric Behaviors of CuO-Doped ZnNb_2O_6 Ceramics
- The Dielectric and Piezoelectric Properties of 0.125PMN-0.875PZT Ceramics Doped with 4PbO・B_2O_3
- Analysis and Simulation of Stacked-Segment Electromechanical Transducers with Partial Electrical Excitation by PSPICE
- The Equivalent Circuit of an AT-Cut Quartz Resonator and Its Application
- Ba(Ti,Zr)O_3 Ceramics Sintered with Lead Borate Glass
- 4PbO・B_2O_3 : A New Sintering Agent For Pb(Zr,Ti)O_3 Ceramics
- Anisotropy in Piezoelectric Properties of Calcium-Modified Lead Titanate Ceramics
- Lead Borate Glass : A New Sintering Agent for BaTiO_3 Ceramics
- Optical Properties of Proton-Exchanged LiNbO_3 Using Capric Acid
- The Effect of Hydrogen on Refractive Index Profiles of Annealed Proton-Exchanged Z-Cut LiNbO_3
- Proton-Exchanged LiNbO_3 Optical Waveguides Using Toluic Acid
- Computer Simulation of Direct-Current Field Dependence of the Dielectric Constant of Al_2O_3-Doped Barium Stronium Titanate in the Paraelectric State
- Preparation and Microwave Characterization of Ba_xSr_TiO_3 Ceramics
- SAW Sensors of Organophosphorous Compound with No Humidity Interference
- Piezoceramic HF Resonator with Zero Temperature Coefficient
- Effect of Drying Temperature on the Characteristics of the Lead Zirconium Titanate Powders Prepared by Sol-Gel Process
- Evaluation of Low-Temperature Processing of Lead Zirconate Titanate (53/47) Ceramics Derived from 1-Propanol-Based Sol-Gel Stock Solutions
- The Microwave Dielectric Properties and the Microstructures of Bi(Nb, Ta)O_4 Ceramics
- Improved High-Q Dielectric Resonator Sintered at Low Firing Temperature
- Dielectric Properties of CaTiO_3-Ca(Mg_Nb_)O_3 Ceramic System at Microwave Frequency
- The Microwave Dielectric Properties and the Microstructures of La_2O_3-Modified BiNbO_4 Ceramics
- Microwave Dielectric Properties of MgNb_2O_6 Ceramics with Fe_2O_3 Additives
- Phase development and dielectric properties of BaAl_2Si_2O_8-based low temperature co-fire ceramic material
- Dielectric Properties of Al_2O_3-Doped Barium Strontium Titanate for Application in Phased Array Antennas
- Microwave Dielectric Properties and Microstructure of 0.85MgTiO3–0.15Ca0.6La0.8/3TiO3 Dielectric Ceramics with Added Sintering Aids
- Effect of Electrode Area on Equivalent Circuit of AT-Cut Quartz Resonator
- Surface Acoustic Wave Sensors on Proton-Exchanged Z-Cut LiNbO_3
- Single Phase Ba_2Ti_9O_ Microwave Dielectric Ceramics Prepared by Low Temperature Liquid Phase Sintering
- Liquid Phase Sintering and Microwave Dielectric Properties of Ba(Mg_Ta_)O_3 Ceramics
- The Effect of Additions on Admittance-Frequency Response of ZnO Varistors
- Analysis of Shear Horizontal Surface Acoustic Wave Sensors with the Coupling of Modes Theory
- Fabrication of Proton-Exchanged High-Index LiNbO_3 Waveguides Using m-Toluic Acid
- Microwave Dielectric Properties and Microstructures of Ca_Nd_TiO_3-Li_Nd_TiO_3 Ceramics
- Effect of RF Power and Substrate Temperature on Physical Properties of Zr_Sn_TiO_4 Films by RF Magnetron Sputtering : Electrical Properties of Condensed Matter
- Low-Temperature Sintering and Microwave Dielectric Properties of (1 - x)MgTiO_3-xCaTiO_3 Ceramics Using Bismuth Addition
- Sintering Behavior and Dielectric Properties of ZnNb2O6–TiO2 Ceramic System at Microwave Frequency
- Effect of B2O3 Addition to La(Co1/2Ti1/2)O3 Ceramics on Sintering Behavior and Microwave Dielectric Properties
- Microwave Dielectric Properties and Microstructures of 0.5La(Mg1/2Ti1/2)O3–0.5CaTiO3 Ceramics with B2O3 Addition
- Effect of Inner Electrode on Electrical Properties of (Zn,Mg)TiO3-Based Multilayer Ceramic Capacitor
- Dielectric Properties of a New Ceramic System (Mg0.95Zn0.05)2TiO4–CaTiO3 at Microwave Frequencies
- Microwave Dielectric Properties and Microstructures of CuO-Modified $(1-x)$(Mg0.95Co0.05)TiO3–$x$CaTiO3 Ceramic System
- Effect of B2O3 Additives on Sintering and Microwave Dielectric Behaviors of CuO-Doped ZnNb2O6 Ceramics
- Liquid Phase Sintering and Microwave Dielectric Properties of Ba(Mg1/3Ta2/3)O3 Ceramics
- Microwave Dielectric Properties of ($1-x$)Nd(Co1/2Ti1/2)O3–$x$SrTiO3 Ceramics with Near Zero Temperature Coefficient of Resonant Frequency
- Characterization of Extremely Low Loss Dielectrics (Mg0.95Zn0.05)TiO3 at Microwave Frequency
- Microwave Dielectric Properties of ($1-x$)(Mg0.95Zn0.05)TiO3–$x$Ca0.6La0.8/3TiO3 Ceramic System
- Microwave Dielectric Characteristics of Zr0.8Sn0.2TiO4 Ceramics with WO3 Additives
- Microwave Dielectric Properties of CuO-Doped La(Co1/2Ti1/2)O3 Ceramics
- Effect of CuO Additives on Sintering and Microwave Dielectric Behaviors of 0.95Ba(Zn1/3Nb2/3)O3–0.05BaZrO3 Ceramics
- Performance Characterization of Thin AlN Films deposited on Mo Electrode for Thin-Film Bulk Acoustic-Wave Resonators
- Using Shear Horizontal Surface Acoustic Wave with Polyaniline Film as Ammonia Sensor
- Effect of AlN Film Thickness and Top Electrode Materials on Characteristics of Thin-Film Bulk Acoustic-Wave Resonator Devices
- Influence of Piezoelectric Film and Electrode Materials on Film Bulk Acoustic-Wave Resonator Characteristics
- Curve Fitting of DC Field Dependence of Dielectric Constant of Barium Strontium Titanate Powder Prepared by Sol–Gel Process
- Microwave Dielectric Properties and Microstructures of V2O5-Modified Zr0.8Sn0.2TiO4 Ceramics
- Crystalline Structure and Surface Morphology of AlN Films Sputtered on Rotated Y-Cut Quartz (ST-Quartz)
- Evaluation of Low-Temperature Processing of Lead Zirconate Titanate (53/47) Ceramics Derived from 1-Propanol-Based Sol-Gel Stock Solutions
- Effect of RF Power on Physical Properties of MgTiO3 Films by RF Magnetron Sputtering
- SAW Sensors of Organophosphorous Compound with No Humidity Interference