Activation of Electrode Surface on Silicon Solar Cell Using Dielectric Barrier Discharge
スポンサーリンク
概要
- 論文の詳細を見る
To yield an activated electrode surface on a silicon solar cell, a surface treatment was examined using a dielectric barrier discharge instead of a wet cleaning technique. After the dry cleaning process using the dielectric barrier discharge, the surface state and the fill factor of the solar cell were evaluated. The results showed that the dielectric barrier discharge plasma could effectively activate the electrode surface of the solar cell in a relatively short time. Additionally, it was found that the surface treatment on finger electrodes played an essential role in the improvement of the fill factor.
- Published by the Japan Society of Applied Physics through the Institute of Pure and Applied Physicsの論文
- 2004-06-15
著者
-
Sung Youl-moon
Department Of Electrical And Electronic Engineering Miyazaki University
-
Araki Ichiro
Power & Industrial Group Hitachi Ltd.
-
MATSUKUMA Kunihiro
Department of Electrical System and Computer Engineering, Sojo University
-
TERAKAWA Takeshi
Advanced Science and Technology Center for Cooperative Research, Kyushu University
-
Furukawa Katsuhiko
Advanced Science And Technology Center For Cooperative Research Kyushu University
-
Sakoda Tatsuya
Department Of Electrical And Electronic Engineering Faculty Of Engineering University Of Miyazaki
-
Furukawa Katsuhiko
Advanced Science and Technology Center for Cooperative Research, Kyushu University, 6-1 Kasuga-koen, Kasuga 816-8580, Japan
-
Matsukuma Kunihiro
Department of Electrical System and Computer Engineering, Sojo University, 4-22-1 Ikeda, Kumamoto 860-0082, Japan
-
Araki Ichiro
Power and Industrial Group, Hitachi Ltd., 3-1 Saiwai, Hitachi 317-8511, Japan
-
Sung Youl-Moon
Department of Electrical and Electronic Engineering, Miyazaki University, 1-1 Gakuenkibanadai Nishi, Miyazaki 889-2192, Japan
-
Terakawa Takeshi
Advanced Science and Technology Center for Cooperative Research, Kyushu University, 6-1 Kasuga-koen, Kasuga 816-8580, Japan
関連論文
- Experiments and Numerical Analyses of Charged Particle's Behavior in a Plasma Display Panel
- A Novel Sputter System with Dynamically Controlled Plasma
- Estimation of Position of On-line Partial Discharge on Hydrogenerator Stator Windings using Acoustic Emission Detection Techniques
- On-line Partial Discharge Measurement of Hydrogenerator Stator Windings using Acoustic Emission Detection Techniques
- Studies of a Reactive Sputter Ion Plating for Preparation of TiN Films Using a Facing Target Sputter and Immersed Inductive Coupled Plasma Source
- Optimum Discharge Condition of DC Bias Electron Cyclotron Resonance Plasma Sputtering for High Quality Si Epitaxial Growth
- Investigation of the Conditions Required for the Forlnation of a Magnetic Neutral Loop Discharge Plasma : Nuclear Science, Plasmas, and Electric Discharges
- Characteristics of the copper vapour from electrode material in a pseudo vacuum circuit breaker under DC discharge using laser induced flourescence
- Application of Thermal Analysis for Clarification of Degradation Characteristics of Silicone Rubber Exposed to Partial Arc Discharge
- Studies of Elastic Waves in Ethylene Propylene Rubber Using Acoustic Emission Sensor
- Visualization of sound field with uniform phase distribution using laser beam microphone coupled with computerized tomography method
- Effect of Substrate Bias on Si Epitaxial Growth Using Sputtering-Type Electron Cyclotron Resonance (ECR) Plasma
- Room Temperature Deposition of Silicon Nitride Films for Passivation of Organic Electroluminescence Device Using a Sputtering-Type Electron Cyclotron Resonance Plasma
- Growth of Epitaxial Silicon Film at Low Temperature by Using Sputtering-Type Electron Cyclotron Resonance Plasma
- Additional Plasma Surface Texturing for Single-Crystalline Silicon Solar Cells Using Dielectric Barrier Discharge
- Activation of Electrode Surface on Silicon Solar Cell Using Dielectric Barrier Discharge
- Deposition of High-Quality Silicon Oxynitride Film at Low Temperature by Using a Sputtering-Type Electron Cyclotron Resonance Plasma
- Studies on Acoustic Emission Signals Detected in an Oil-immersed Pole Transformer
- Etching Characteristics of Fabricated Grooves on Silicon Solar Cell using Surface Discharge Plasma
- Fabrication and Characterization of Dye-Sensitized Solar Cell Using TiO2-Nanotube Particles by Anodic Oxidation
- Examination of Maskless Etching Technique Using a Localized Surface Discharge Plasma
- Proposal of Multi-pass Laser Spectroscopic Technique for Diagnosing Atmospheric Pressure Discharge Plasmas
- Additional Plasma Surface Texturing for Single-Crystalline Silicon Solar Cells Using Dielectric Barrier Discharge
- Monitoring of an MgO Degradation in AC Plasma Display Panel Using Multivariate Analysis Method
- Development of Novel Ozonizer Using Micro-Barrier Discharges Formed in Water
- Maximum Output Power Control Using Short-Circuit Current and Open-Circuit Voltage of a Solar Panel
- Activation of Electrode Surface on Silicon Solar Cell Using Dielectric Barrier Discharge
- Localized Degradation of an MgO Layer in an Over-Frequency Accelerated Discharge of a Plasma Display Panel
- Plasma Surface Treatment of Carbonaceous Materials for Application in Electric Double Layer Capacitors
- Transmission and Detection of Light Diffraction Signal by Low-Frequency Ultrasonic Wave
- Study on Behavior of Sputtered Particles during Surface Discharges
- Selective Etching of Silicon Nitride Film on Single Crystalline Silicon Solar Cell Using Intensive Surface Discharge
- Low-Temperature Boron Gettering for Improving the Carrier Lifetime in Fe-Contaminated Bifacial Silicon Solar Cells with n+pp+ Back-Surface-Field Structure