Creep of Mild Steel under Periodic Stresses of Rectangular Wave : (II) Creep Deformation under Unsymmetrical Periodic Stress Waves
スポンサーリンク
概要
- 論文の詳細を見る
Creep of mild steel was studied at a temperature of 450℃ under unsymmetrical periodic stresses such that in a stress cycle the time under stresses higher than the mean stress was shorter than the time under stresses lower than the mean stress. It was found that in this case the mechanical equation of state in solid predicted a smaller deformation as compared with the one obtained by experiment, while it had been applicable without any appreciable error in the case of a symmetrical stress wave. It was also ascertained that the smaller the ratio of the loading time of the higher stress to that of the lower stress and the shorter the period of a stress cycle, the more the tendency was accentuated, although the lower stress affected little the total deformation under a given stress wave provided that the higher stress was constant.
- 一般社団法人日本機械学会の論文
著者
-
Ohji Kiyotsugu
Department Of Mechanical Engineering Faculty Of Engineering Osaka University
-
Ohji Kiyotsugu
Faculty Of Engineering Osaka University
-
Taira Shuji
Department Of Mechanical Engineering Faculty Of Engineering Kyoto University.
-
Taira Shuji
Faculty Of Engineering Kyoto University
-
Tanaka Kichinosuke
Department Of Aeronautical Engineering Faculty Of Engineering Kyoto University.
-
Tanaka Kichinosuke
Faculty Of Engiineering Kyoto University
関連論文
- Fatigue Behavior of Anisotropic Rolled Steel Plates under Cyclic Torsion
- Observation of Low-Cycle Fatigue Crack Initiation and Propagation in Anisotropic Rolled Steel under Biaxial Stressing
- The Effect of Torsional Prestrain on the Tensile and Low-Cycle Fatigue Properties of Mild Steel
- Biaxial Low-Cycle Fatigue of Anisotropic Rolled Steel Plates
- Estimation of Stress and Strain at the Notch Root in the Elastic-plastic Range using the J-integral
- Simple Methods of Estimating the Stress and Strain at the Notch Root
- Thermal Fatigue and Cyclic Mechanical Strain Fatigue at Elevated Temperature of 18-8 Cb Stainless Steel and 2.25 Cr-1 Mo Steel
- X-Ray Investigation on the Residual Stress of Metallic Materials : On the Residual Stress in Carbon Steel Caused by Thermal Stress
- Prediction of Growth Rate of Short Fatigue Cracks : Series A : Solid-Mechanics, Strength of Materials
- Near-Threshold Fatigue Crack Growth Behavior of SUS304 Steel at High Temperatures Using Interferometric Strain/Displacement Gage : 2nd Report, Fatigue Crack Growth Behavior
- Near-Threshold Fatigue Crack Growth Behavior of SUS304 Steel at High Temperatures Using Interferometric Strain/Displacement Gage : 1st Report, Crack Closure Behavior
- Study on Fatigue Fracture in Quench-Tempered Carbon Steel : 3rd Report, On Propagation Process of Fatigue Crack
- Study on Fatigue Fracture in Quench-Tempered Carbon Steel : 2nd Report, Observation of Fatigue Crack Initiation Process by X-ray Microbeam Technique
- Study on Fatigue Fracture in Quench-Tempered Carbon Steel : 1st Report, Optical-Microscopic Observation of Fatigue Crack Initiation Process
- Creep Rupture of Internally Pressurized Cylinders at Elevated Temperatures
- SA-07-2(099) Loading Frequency Effect on Near-Threshold and Sub-Threshold Fatigue Crack Growth in SUS304 Steel at an Elevated Temperature(Flaw Assessment at Elevated Temperature 2)
- IDENTIFICATION OF AN INTERFACE CRACK IN BONDED DISSIMILAR MATERIALS FROM ELECTRIC POTENTIAL DISTRIBUTION
- Evaluation of the J-Integral Range of Fatigue Crack Emanating from Notches by Simple Estimation Formulae
- Investigation on Path-Integral Expression of the J-Integral Range Using Numerical Simulations of Fatigue Crack Growth
- INVERSE PROBLEMS IN SOLID MECHANICS AND RELEVANT FIELDS
- X-Ray Investigation on Fatigue of Polycrystalline Metals : On the Relation between Crystal Orientation and Deformation in fcc Crystal
- A Simple J-Integral Formula for Mode III Cracks Emanating from Notches : Solid-Mechanics, Strength of Materials
- Harmonic Viscoelastic Waves Propagating Normal to the Layer of Laminated Media
- Harmonic Viscoelastic Waves Propagating Parallel to the Layers of Laminated Media
- Harmonic Waves in a Linear Viscoelastic Plate
- Thermal Residual Stresses in Bonded Dissimilar Materials and Their Singularities
- Numerical Investigation of Three-Dimensional Crack Measurement by the Electric Potential CT Method : Solid-Mechanics, Strength of Materials
- Crystallographic Study of Yield Condition of Polycrystalline Metals : 1st Report, bcc Metal
- Propagation of Plastic Wave in Lead Bar
- An Energetic Consideration of Fatigue Mechanism of Metal under Mean Stress
- X-ray Investigation on the Fatigue Damage of Metals
- X-Ray Investigation on Fatigue Damage of Metals under Mean Stress : 2nd Report, Torsional Fatigue
- X-Ray Investigation on Fatigue Damage of Metals under Mean Stress : (1st Report, Plane Bending Fatigue)
- X-Ray Investigation on the Prediction of Fatigue Life : On the Changes in Half-Value Breadth of Carbon Steel under Varying Stress Amplitudes
- Stress Wave Propagation in a Bar of Variable Cross-Section
- Viscous Property of Steel and Its Effect on Strain Wave Front
- Thermoelastic Effect Caused by Longitudinal Collision of Two Bars
- Thermal Fatigue under Pulsating Thermal Stress Cycling
- Effect of Stress Reduction of Secondary Creep of Mild Steel
- Residual Stresses Produced by Plastic Tension in Notched Plate Specimens and Fatigue Strength
- Influence of Rest in Stress Alternation on the Fatigue Properties of a Low Carbon Steel at Elevated Temperatures
- On the Residual Stresses Due to Alternating Stressing of Annealed Steels
- Strength of Mild Steel at High Strain Rate
- Impact Bending Test on Steel at Low Temperatures Using a Split Hopkinson Bar
- Temperature and Strain Rate Effects upon the Strength of Zinc Single Crystals
- Fatigue and Dynamic Creep Properties of 13 Cr Steel at Elevated Temperature under Combined Stresses of Static Tension and Alternating Bending
- Dynamic Creep and Fatigue of 13 Chromium Steel at Elevated Temperature
- X-Ray Investigation on Fatigue Fracture of Notched Steel Specimen : Observation of Fatigue Phenomena of Annealed Low-Carbon Steel by X-Ray Microbeam Technique
- X-ray Investigation of Stress Measurement : On the Method of Measurement, the Effect of Radiation Area and Resolving Power
- On the Anisotropy of Low-Cycle Fatigue Properties of Rolled Plates
- The Behaviour of an Infinite Circular Bar subjected to Impulsive Bending Load
- Crystallographic Study of Yield Condition of Polycrystalline Metals : (3rd Report, Relation between Slip in Crystals and Yield Condition)
- A Comparison of the Axial and Reversed-Torsional Strain Cycling Low-Cycle Fatigue Strength of Several Structural Materials
- Creep of Mild Steel under Periodic Stresses of Rectangular Wave : (III) Prediction of the Creep Deformation under Periodic Stresses
- Creep of Mild Steel under Periodic Stresses of Rectangular Wave : (II) Creep Deformation under Unsymmetrical Periodic Stress Waves
- A Mechanism of Deformation of Metals at High Temperatures with Special Reference to the Creep after a Sudden Change in Stress
- A Mechanism of Deformation of Metals at High Temperatures with Special Reference to the Tension Test and the Creep Test
- Creep of Mild Steel under Periodic Stresses of Rectangular Wave
- Compressive Strength of Mild Steel at High Strain Rate and at High Temperature
- Thermal Recovery and Stress-Strain Relation of Polycrystalline Zinc
- Relaxation of 2^1/4 Cr-1 Mo Steel
- The Propagation of Longitudinal Wave in a Visco-Elastic Circular Bar with Consideration of the Lateral Inertia
- Crystallographic Study of Yield Condition of Polycrystalline Metals : 2nd Report, hcp Metal
- X-Ray Study of Surface Residual Stress Produced in Fatigue Process of Annealed Metals
- Influence of Frequency of Stress Cycles on Fatigue at Elevated Temperatures
- The Elastic Analogue in Creep Stress Analysis
- Investigation on Dynamic Creep and Rupture of a Low Carbon Steel
- The Effects of Temperature and Strain Rate on the Strength of Polycrystalline Zinc