Simple Methods of Estimating the Stress and Strain at the Notch Root
スポンサーリンク
概要
- 論文の詳細を見る
An elastic-plastic analysis of notched plates subjected to tension force or bending moment was made. Based on this analysis, methods of evaluating approximately the stress and strain at the notch root were proposed. Dimensionless master curves were proposed for estimating the stress and strain concentration factors under small-scale yielding condition and the stress and strain at the notch root under large-scale yielding condition. This master-curve approach was found valid in all the cases analysed in this study. A simple formula was further developed by which the stress and strain at the notch root could approximately be calculated under load conditions below and above the gross yield stress by using the J-integral, together with a formula for estimating the J-integral. The estimated values of the notch stress and strain by this set of the approximation formulae agreed well with the results of numerical analysis.
- 一般社団法人日本機械学会の論文
著者
-
OHJI Kiyotsugu
Faculty of Engineering, Osaka University
-
OGURA Keiji
Faculty of Engineering, Osaka University
-
Ogura Keiji
Faculty Of Engineering Science Osaka University
-
MIKI Noriyuki
Faculty of Engineering Ehime University
-
Ohji Kiyotsugu
Faculty Of Engineering Osaka University
関連論文
- Fatigue Behavior of Anisotropic Rolled Steel Plates under Cyclic Torsion
- Observation of Low-Cycle Fatigue Crack Initiation and Propagation in Anisotropic Rolled Steel under Biaxial Stressing
- The Effect of Torsional Prestrain on the Tensile and Low-Cycle Fatigue Properties of Mild Steel
- Biaxial Low-Cycle Fatigue of Anisotropic Rolled Steel Plates
- Estimation of Stress and Strain at the Notch Root in the Elastic-plastic Range using the J-integral
- Simple Methods of Estimating the Stress and Strain at the Notch Root
- Crack Growth Behavior of Hydrogenated Austenitic Stainless Steel by High Temperature Cathodic Charging : Solid-Mechanics, Strength of Materials
- A Simple J-Integral Formula for Mode III Cracks Emanating from Notches : Solid-Mechanics, Strength of Materials
- Thermal Residual Stresses in Bonded Dissimilar Materials and Their Singularities
- Numerical Investigation of Three-Dimensional Crack Measurement by the Electric Potential CT Method : Solid-Mechanics, Strength of Materials
- New Flaw Inspection Technique Based on Infrared Thermal Images under Joule Effect Heating
- Effect of Stress Reduction of Secondary Creep of Mild Steel
- New Developments in Fracture Surface Analysis Using X-Ray and Laser
- The Role of Crack Closure on Fatigue Threshold at Elevated Temperatures
- Effect of Oxide and Roughness on Fatigue Crack Growth Threshold in Low Carbon Steel at Elevated Temperature : Solid-Mechanics, Strength of Materials
- On the Anisotropy of Low-Cycle Fatigue Properties of Rolled Plates
- A Comparison of the Axial and Reversed-Torsional Strain Cycling Low-Cycle Fatigue Strength of Several Structural Materials
- Creep of Mild Steel under Periodic Stresses of Rectangular Wave : (III) Prediction of the Creep Deformation under Periodic Stresses
- Creep of Mild Steel under Periodic Stresses of Rectangular Wave : (II) Creep Deformation under Unsymmetrical Periodic Stress Waves
- Creep of Mild Steel under Periodic Stresses of Rectangular Wave
- The Elastic Analogue in Creep Stress Analysis