On the Anisotropy of Low-Cycle Fatigue Properties of Rolled Plates
スポンサーリンク
概要
- 論文の詳細を見る
In order to gather information relating to the low-cycle fatigue behavior of anisotropic materials, the low-cycle fatigue prorerties of thick rolled steel plates were investigated in several directions under the condition of uniaxial tension-compression. The steel plates used showed considerable anisotropy in fracture ductility in the thickness direction, while anisotropy in the yield and ultimate tensile strengths was observed to be very slight in any direction. The low-cycle fatigue behavior was also the most anisotropic in the thickness direction. The fracture life in a given direction, however, was found to follow the Manson-Coffin type relation, which is usually applied to isotropic materials, if the fracture ductility determined from the tensile test in that direction was used. The crack initiation life also exhibited a similar trend, although in a more exaggerated manner. Differences were found in fracture mode depending on the directions relative to the rolling direction.
- 一般社団法人日本機械学会の論文
著者
-
HARADA Shoji
Faculty of Engineering, Osaka University
-
Ohji Kiyotsugu
Faculty Of Engineering Osaka University
-
Harada Shoji
Faculty Of Engineering Osaka University
関連論文
- Fatigue Behavior of Anisotropic Rolled Steel Plates under Cyclic Torsion
- Observation of Low-Cycle Fatigue Crack Initiation and Propagation in Anisotropic Rolled Steel under Biaxial Stressing
- The Effect of Torsional Prestrain on the Tensile and Low-Cycle Fatigue Properties of Mild Steel
- Biaxial Low-Cycle Fatigue of Anisotropic Rolled Steel Plates
- Estimation of Stress and Strain at the Notch Root in the Elastic-plastic Range using the J-integral
- Simple Methods of Estimating the Stress and Strain at the Notch Root
- A Simple J-Integral Formula for Mode III Cracks Emanating from Notches : Solid-Mechanics, Strength of Materials
- Thermal Residual Stresses in Bonded Dissimilar Materials and Their Singularities
- Numerical Investigation of Three-Dimensional Crack Measurement by the Electric Potential CT Method : Solid-Mechanics, Strength of Materials
- Effect of Stress Reduction of Secondary Creep of Mild Steel
- On the Anisotropy of Low-Cycle Fatigue Properties of Rolled Plates
- A Comparison of the Axial and Reversed-Torsional Strain Cycling Low-Cycle Fatigue Strength of Several Structural Materials
- Creep of Mild Steel under Periodic Stresses of Rectangular Wave : (III) Prediction of the Creep Deformation under Periodic Stresses
- Creep of Mild Steel under Periodic Stresses of Rectangular Wave : (II) Creep Deformation under Unsymmetrical Periodic Stress Waves
- Creep of Mild Steel under Periodic Stresses of Rectangular Wave
- The Elastic Analogue in Creep Stress Analysis
- Micellar catalytic effect on the base dissociation of methylamine studied by the ultrasonic absorption method.