Oxygen Distribution in Titanium Single Crystal Fabricated by Optical Floating-Zone Method under Extremely Low Oxygen Partial Pressure
スポンサーリンク
概要
- 論文の詳細を見る
- Japan Institute of Metalsの論文
- 2009-12-01
著者
-
NARUSHIMA Takayuki
Department of Materials Processing, Tohoku University
-
NAKANO Takayoshi
Division of Materials and Manufacturing Sciences, Graduate School of Engineering, Osaka University
-
Narushima Takayuki
Department Of Materials Processing Graduate School Of Engineering Tohoku University
-
SHIRAKAWA Naoki
Nanoelectronics Research Institute, AIST
-
YOSHIDA Yoshiyuki
Nanoelectronics Research Institute, AIST
-
Shirakawa Naoki
Nanoelectronics Research Institute Aist
-
Shirakawa Naoki
Nanoelectronics Research Institute National Institute Of Advanced Industrial Science And Technology
-
Nakano Takayoshi
Division Of Materials & Manufacturing Science Graduate School Of Engineering Osaka University
-
Tachibana Takahiro
Division Of Materials And Manufacturing Science Graduate School Of Engineering Osaka University
-
Yoshida Yoshiyuki
Nanoelectronics Research Institute (neri) National Institute Of Advanced Industrial Science And Tech
-
HAGIHARA Koji
Division of Materials and Manufacturing Science, Graduate School of Engineering, Osaka University
-
SASAKI Keita
Division of Materials and Manufacturing Science, Graduate School of Engineering, Osaka University
-
NAGASAWA Tohru
Canon Machinery INC
-
Hagihara Koji
Dep. Of Adaptive Machine Systems Graduate School Of Engineering Osaka Univ.
-
Sasaki Keita
Division Of Materials And Manufacturing Science Graduate School Of Engineering Osaka University
-
Yoshida Yoshiyuki
Nanoelectronics Research Institute National Institute Of Advanced Industrial Science And Technology
-
Shirakawa Naoki
Nanoelectronics Research Institute
関連論文
- Apatite formation behavior on bio-ceramic films prepared by MOCVD
- Precipitation Behavior in a Hanks' Solution on Ca-P-O Films Prepared by Laser CVD
- Calcium Phosphate Films with/without Heat Treatments Fabricated Using RF Magnetron Sputtering
- Hydroxyapatite Formation on Ca-P-O Coating Prepared by MOCVD
- Precipitation Behavior in a Hanks' Solution on Ca-P-O Films Prepared by Laser CVD
- Surface Hardening Treatment for Titanium Materials Using Ar-5%CO Gas in Combination with Post Heat Treatment under Vacuum
- Orbital-Degenerate Paramagnetic Metal Sr_2MoO_4:An Electronic Analogue to Sr_2RuO_4 : Condensed Matter: Electronic Properties, etc.
- Boron and Nitrogen in GaAs and InP Melts Equilibrated with B_2O_3 Flux
- Behavior of Oxygen in Ga-As Melts with the Range of As Content up to 5 mass % Equilibrated with B_2O_3 Flux
- Activity of Ga_2O_3 in B_2O_3 Flux and Standard Free Energies of Formation of CaBO_3 and InBO_3
- Fabrication of Beta-Ti-Type Ti-Nb-Ta-Zr (TNTZ) Wire with High-Ductility by Arc-Melt-Type Melt-Extraction Method
- Alkali Hydrothermal Synthesis of Zeolite A Using Oxide By-products
- Formation of New Bone with Preferentially Oriented Biological Apatite Crystals Using a Novel Cylindrical Implant Containing Anisotropic Open Pores Fabricated by the Electron Beam Melting (EBM) Method
- Chemical-Hydrothermal Synthesis of Bioinert ZrO_2-TiO_2 Films on Pure Ti Substrates and Proliferation of Osteoblast-Like Cells
- Structural Distortion and Physical Properties in Double-Layered Ruthenate Sr_Ca_xRu_2O_7(Condensed matter: electronic structure and electrical, magnetic, and optical properties)
- Areal Distribution of Preferential Alignment of Biological Apatite (BAp) Crystallite on Cross-Section of Center of Femoral Diaphysis in Osteopetrotic (op/op) Mouse
- Texture of Biological Apatite Crystallites and the Related Mechanical Function in Regenerated and Pathological Hard Tissues(International Symposium of Maxillofacial & Oral Regenerative Biology in OKAYAMA 2005)
- Texture of Biological Apatite Crystallites and the Related Mechanical Function in Regenerated and Pathological Hard Tissues(International Symposium of Maxillofacial and Oral Regenerative Biology in Okayama 2005)
- Dynamic and Static Restoration Behaviors of Pure Lead and Tin in the Ambient Temperature Range
- Switching Dynamics of Bi_2Sr_2CaCu_2O_ Intrinsic Josephson Junctions : Macroscopic Quantum Tunneling and Self-Heating Effect(Condensed matter: electronic structure and electrical, magnetic, and optical properties)
- The Effect of Solute Elements on Hardness and Grain Size in Platinum Based Binary Alloys
- Development of a New Method for Manufacturing Iron Foam Using Gases Generated by Reduction of Iron Oxide
- Evidence for Unconventional Superconductivity of Sr_2RuO_4 from Specific-Heat Measurements
- Uniaxial-Pressure Induced Ferromagnetism of Enhanced Paramagnetic Sr_3Ru_2O_7 (Condensed Matter : Electronic Structure, Electrical, Magnetic and Optical Properties)
- Magnetic Properties of Ca_3Ru_2O_7 under Uniaxial Pressures(Condensed matter: electronic structure and electrical, magnetic, and optical properties)
- Hall Effect in Ca_3Ru_2O_7
- Deoxidization of Cu Oxide under Extremely Low Oxygen Pressure Ambient
- Field-induced Magnetic Anisotropy of Single-Crystal GeNi_2O_4(Condensed Matter : Electronic Structure, Electrical, Magnetic and Optical Properties)
- Anisotropic Flux Pinning in a Layered Superconductor Sr_2RuO_4
- Thermopower of a Layered Perovskite Superconductor,Sr_2RuO_4
- Novel Hall-Coefficient Behavior in Superconducting Sr_2RuO_4
- Scaling of Negative Magnetoresistance and Extraordinary Hall Effect in CaVO_
- Effect of Annealing on the Superconductivity of Sr_2RuO_4
- Fatigue Behaviors of Ultra Fine Wires of β-Type and α-Type Titanium Alloys
- Grain Refinement of As Cast Austenite by Dynamic Recrystallization in HSLA Steels
- Solubilities and Equilibrium Distribution Coefficients of Oxygen and Carbon in Silicon
- Fabrication of Ultrasmall High-Quality Bi_2Sr_2CaCu_2O_ Intrinsic Josephson Junctions
- Deoxidation of NiTi Alloy Melts Using Metallic Barium
- PREFACE
- Special Issue on New Functions and Properties of Engineering Materials Created by Designing and Processing
- PREFACE
- Special Issue on Medical, Healthcare, Sport and Leisure Materials
- An Improved Method for Obtaining Single-Phase Sr_2MoO_4 under Controlled Ultralow Oxygen Partial Pressure : Superconductors
- Two-Dimensional Quantitative Analysis of Preferential Alignment of BAp c-axis for Isolated Human Trabecular Bone Using Microbeam X-ray Diffractometer with a Transmission Optical System
- Evaluation of Bone Quality near Metallic Implants with and without Lotus-Type Pores for Optimal Biomaterial Design
- Alloy Design and Properties of New α+β Titanium Alloy with Excellent Cold Workability, Superplasticity and Cytocompatibility
- Removing focused ion-beam damages on transmission electron microscopy specimens by using a plasma cleaner
- Oxygen Distribution in Titanium Single Crystal Fabricated by Optical Floating-Zone Method under Extremely Low Oxygen Partial Pressure
- Evaluation of Sliding Wear Resistant Property of C. P. Titanium and SP-700 Titanium Alloy Surface-hardened by Ar-5%CO Gas
- Variations in the Microstructure and Hardness with Solution Treating and Aging Conditions in New α+β Titanium Alloy Ti-4.5%Al-6%Nb-2%Fe-2%Mo
- The Synthesis and Characterization of Double-Layered Perovskite Sr_3Mo_2O_7(Condensed matter: electronic structure and electrical, magnetic, and optical properties)
- Austenitic Grain Growth behavior Immediately after Dynamic Recrystallization in HSLA Steels and Austenitic Stainless Steel
- Analysis of Biological Apatite Orientation in Rat Mandibles
- Multi-Junction Switching in Bi_2Sr_La_CuO_ Intrinsic Josephson Junctions
- Fabrication of Ti-Zr Binary Metallic Wire by Arc-Melt-Type Melt-Extraction Method
- Determination of Free Lime Contents in Slags by Solution Calorimetry
- New Technique for Evaluation of Preferential Alignment of Biological Apatite (BAp) Crystallites in Bone Using Transmission X-ray Diffractometry
- Effect of Alloying Elements on Carbon Solubility in Liquid Silicon Equilibrated with Silicon Carbide
- Alendronate treatment promotes bone formation with a less anisotropic microstructure during intramembranous ossification in rats
- Numerical Study on the Morphology and Mechanical Role of Healthy and Osteoporotic Vertebral Trabecular Bone
- Formation of New Bone with Preferentially Oriented Biological Apatite Crystals Using a Novel Cylindrical Implant Containing Anisotropic Open Pores Fabricated by the Electron Beam Melting (EBM) Method
- Alkali Hydrothermal Synthesis of Zeolite A Using Oxide By-products
- Oxidation of Boron Carbide-Silicon Carbide Composite at 1073 to 1773K
- Effects of Zinc Insert and Al Content in Mg Alloy on the Bondability in Dissimilar Joints of Steel and Magnesium Alloys
- Bone Loss and Reduced Bone Quality of the Human Femur after Total Hip Arthroplasty under Stress-Shielding Effects by Titanium-Based Implant
- Analysis of Biological Apatite Crystal Orientation in Anterior Cortical Bone of Human Mandible Using Microbeam X-ray Diffractometry
- Recovery of Calcium from BF Slag and Synthesis of Zeolite A Using Its Residue
- Biomechanical Evaluation of Amorphous Calcium Phosphate Coated TNTZ Implants Prepared Using a Radiofrequency Magnetron Sputtering System
- Field-induced Magnetic Anisotropy of Single-Crystal GeNi_2O_4(Condensed Matter : Electronic Structure, Electrical, Magnetic and Optical Properties)
- β-Grain Refinement of α+β-Type Ti-4.5Al-6Nb-2Fe-2Mo Alloy by Using Rare-Earth-Oxide Precipitates
- β-Phase Instability in Binary Ti-xNb Biomaterial Single Crystals
- Formation of Anatase on Commercially Pure Ti by Two-Step Thermal Oxidation Using N_2-CO Gas
- Chronological histological changes during bone regeneration on a non-crosslinked atelocollagen matrix