Formation of Anatase on Commercially Pure Ti by Two-Step Thermal Oxidation Using N_2-CO Gas
スポンサーリンク
概要
- 論文の詳細を見る
- 2013-08-01
著者
-
NARUSHIMA Takayuki
Department of Materials Processing, Tohoku University
-
Ueda Kyosuke
Department Of Materials Processing Tohoku University
-
Narushima Takayuki
Department Of Materials Processing Graduate School Of Engineering Tohoku University
-
UMETSU Nobuyuki
Department of Applied Physics, Tohoku University, Sendai 980-8579, Japan
-
Tajima Kazuki
Material Research Institute for Sustainable Development, National Institute of Advanced Industrial Science and Technology
-
SADO Shota
Department of Materials Processing, Tohoku University
関連論文
- Apatite formation behavior on bio-ceramic films prepared by MOCVD
- Precipitation Behavior in a Hanks' Solution on Ca-P-O Films Prepared by Laser CVD
- Calcium Phosphate Films with/without Heat Treatments Fabricated Using RF Magnetron Sputtering
- Hydroxyapatite Formation on Ca-P-O Coating Prepared by MOCVD
- Hydroxyapatite Formation on CaTiO_3 Film Prepared by Metal-Organic Chemical Vapor Deposition
- Evaluation of Calcium Phosphate Coating Films on Titanium Fabricated Using RF Magnetron Sputtering
- Precipitation Behavior in a Hanks' Solution on Ca-P-O Films Prepared by Laser CVD
- Surface Hardening Treatment for Titanium Materials Using Ar-5%CO Gas in Combination with Post Heat Treatment under Vacuum
- Polytetrafluoroethylene (PTFE) Top-Covered Mg-Ni Switchable Mirror Thin Films
- High Durability of Clear Transparency All-Solid-State Switchable Mirror Based on Magnesium-Titanium Thin Film
- Boron and Nitrogen in GaAs and InP Melts Equilibrated with B_2O_3 Flux
- Behavior of Oxygen in Ga-As Melts with the Range of As Content up to 5 mass % Equilibrated with B_2O_3 Flux
- Activity of Ga_2O_3 in B_2O_3 Flux and Standard Free Energies of Formation of CaBO_3 and InBO_3
- Alkali Hydrothermal Synthesis of Zeolite A Using Oxide By-products
- Fabrication of solid electrolyte Ta2O5 thin film by reactive dc magnetron sputtering suitable for electrochromic all-solid-state switchable mirror glass
- Dynamic and Static Restoration Behaviors of Pure Lead and Tin in the Ambient Temperature Range
- The Effect of Solute Elements on Hardness and Grain Size in Platinum Based Binary Alloys
- Development of a New Method for Manufacturing Iron Foam Using Gases Generated by Reduction of Iron Oxide
- Fatigue Behaviors of Ultra Fine Wires of β-Type and α-Type Titanium Alloys
- Preparation of Calcium Phosphate Films by Radiofrequency Magnetron Sputtering
- Grain Refinement of As Cast Austenite by Dynamic Recrystallization in HSLA Steels
- Solubilities and Equilibrium Distribution Coefficients of Oxygen and Carbon in Silicon
- Deoxidation of NiTi Alloy Melts Using Metallic Barium
- PREFACE
- Special Issue on New Functions and Properties of Engineering Materials Created by Designing and Processing
- PREFACE
- Special Issue on Medical, Healthcare, Sport and Leisure Materials
- Alloy Design and Properties of New α+β Titanium Alloy with Excellent Cold Workability, Superplasticity and Cytocompatibility
- Structural control of polyvinyl chloride sealant layer for electrochromic switchable mirror glass based on Mg–Ni thin film
- Oxygen Distribution in Titanium Single Crystal Fabricated by Optical Floating-Zone Method under Extremely Low Oxygen Partial Pressure
- Evaluation of Sliding Wear Resistant Property of C. P. Titanium and SP-700 Titanium Alloy Surface-hardened by Ar-5%CO Gas
- Variations in the Microstructure and Hardness with Solution Treating and Aging Conditions in New α+β Titanium Alloy Ti-4.5%Al-6%Nb-2%Fe-2%Mo
- Austenitic Grain Growth behavior Immediately after Dynamic Recrystallization in HSLA Steels and Austenitic Stainless Steel
- Determination of Free Lime Contents in Slags by Solution Calorimetry
- Effect of Alloying Elements on Carbon Solubility in Liquid Silicon Equilibrated with Silicon Carbide
- Surface Coating of Electrochromic Switchable Mirror Glass Based on Mg--Ni Thin Film for High Durability in the Environment
- Surface Analysis of Electrochromic Switchable Mirror Glass Based on Magnesium-Nickel Thin Film in Accelerated Degradation Test
- Analysis of Degradation of Flexible All-Solid-State Switchable Mirror Based on Mg–Ni Thin Film
- Alkali Hydrothermal Synthesis of Zeolite A Using Oxide By-products
- Oxidation of Boron Carbide-Silicon Carbide Composite at 1073 to 1773K
- Degradation analysis of electrochromic switchable mirror glass based on Mg-Ni thin film at constant temperature and relative humidity
- Stress in Switchable Mirror Thin Film Resulting from Gasochromic Switching
- Gasochromic Properties of Mg–Ni Switchable Mirror Thin Films on Flexible Sheets
- Solution-Based Electrolyte Layer Suitable for Electrochromic Switchable Mirror
- Composition Dependence of Pd-Ag Alloy Proton Injection Layer on Optical Switching Properties of Electrochromic Switchable Mirror
- Recovery of Calcium from BF Slag and Synthesis of Zeolite A Using Its Residue
- Theoretical Study on Gilbert Damping of Nonuniform Magnetization Precession in Ferromagnetic Metals
- Biomechanical Evaluation of Amorphous Calcium Phosphate Coated TNTZ Implants Prepared Using a Radiofrequency Magnetron Sputtering System
- Solution-Based Electrolyte Layer Suitable for Electrochromic Switchable Mirror
- New Switchable Mirror Based on Magnesium–Niobium Thin Film
- β-Grain Refinement of α+β-Type Ti-4.5Al-6Nb-2Fe-2Mo Alloy by Using Rare-Earth-Oxide Precipitates
- Formation of Anatase on Commercially Pure Ti by Two-Step Thermal Oxidation Using N_2-CO Gas