Cold-Rolled Zr_<50>Cu_<30>Ni_<10>Al_<10> Bulk Amorphous Alloys with Tensile Plastic Elongation at Room Temperature
スポンサーリンク
概要
- 論文の詳細を見る
- Japan Institute of Metalsの論文
- 2002-12-01
著者
-
YOKOYAMA Yoshihiko
Institute for Materials Research, Tohoku University
-
Yokoyama Y
Inst. For Materials Res. Tohoku Univ.
-
Yokoyama Yoshihiko
Faculty Of Engineering Himeji Institute Of Technology
-
INOUE Kiyohiro
Faculty of Engineering, Himeji Institute of Technology
-
FUKAURA Kenzo
Faculty of Engineering, Himeji Institute of Technology
-
Yamada Y
Department Of Quantum Science And Energy Engineering Tohoku University
-
Yamamoto Yuichi
Division Of Electronic And Information Engineering Faculty Of Technology Tokyo University Of Agricul
-
Yamamoto Y
Nara Inst. Sci. And Technol. Nara Jpn
-
Fukaura K
Faculty Of Engineering Himeji Institute Of Technology
-
Yokoyama Y
Himeji Inst. Technol. Himeji Jpn
-
Inoue Koichiro
Shibaura Institute Of Technology Faculty Of Engineering Material Engineering Dept.
-
Yamamoto Yasufumi
Research And Technical Service Laboratory Du Pont-mitsui Polychemicals Co. Ltd.
-
Yamamoto Yukio
Department Of Electrical Engineering Fukui National College Of Technology
-
Yamamoto Y
Material Science Japan Advanced Institute Of Science And Technology
-
YAMAMOTO Yujiroh
Department of Physics, School of Science and Engineering, Waseda University
関連論文
- Enhanced Tensile Strength and Plasticity of Zr-Cu-Al Bulk Glassy Alloys at Cryogenic Temperatures
- Heterogeneous Process of Disordering and Structural Refinement in Ni_3Al during Severe Plastic Deformation by High-Pressure Torsion
- Effect of Nanocrystallization and Twinning on Hardness in Ni_3Al Deformed by High-Pressure Torsion
- Nucleation and Growth in Undercooled Melts of Bulk-Metallic-Glass Forming Zr_Ni_Al_ Alloy
- Cold-Rolled Zr_Cu_Ni_Al_ Bulk Amorphous Alloys with Tensile Plastic Elongation at Room Temperature
- Pseudo Float Melting State in Ladle Arc-Melt-Type Furnace for Preparing Crystalline Inclusion-Free Bulk Amorphous Alloy
- Measurement of Absolute Densities of Si, SiH and SiH_3 in Electron Cyclotron Resonance SiH_4/H_2 Plasma ( Plasma Processing)
- INTERFACE STRUCTURE AND MECCHANICAL PROPERTIES OF POWDER METALLURGICAL 6061 ALUMINUM MATRIX COMPOSITES REINFORCED WITH VARIOUS KINDS OF OXIDE WHISKERS
- Measurement of Terrace Width Distribution on an Si(110) Surface Using High-Temperature Scanning Tunneling Microscopy
- High-Temperature Scanning Tunneling Microscopy Observation of a (15, 17, 1) Facet Structure on a Si(110) Surface
- High-Temperature Scanning Tunneling Microscopy Study of the Phase Transition of 16-Structure Appearing on a Si(110) Surface
- High-Critical-Current-Density Epitaxial Films of SmBa_2Cu_3O_ in High Fields
- Reduction of Surface Resistance of ErBa_2Cu_3O_ Films by BaZrO_3 Nano-Particle Inclusion
- Correlation between Film Thickness and Critical Current Density of Sm_Ba_Cu_3O_ Films Deposited by Pulsed Laser Deposition : Superconductors
- A new method for preparing plan-view TEM specimen of multilayered films using focused ion beam
- Effect of Hydrogen-Radical Annealing for SiO_2 Passivation
- Fabrication of Fe-Te-S Superconducting Epitaxial Thin Films by Pulsed Laser Deposition
- Effect of c-Axis-Correlated Disorders on the Vortex Diagram of the Pinning State
- Critical Current Density Enhancement around a Matching Field in ErBa_2Cu_3O_ Films with BaZrO_3 Nano-Rods
- Characteristics of Hall Accelerator with He, H_2, CH_4, O_2 and Ar Gases
- Characteristics of Hall Accelerator for Helium-Ion Beam Extraction
- Application of a Hall Accelerator to Diamondlike Carbon Film Coatings
- Red-to-Yellow Electroluminescence from CdSe Microcrystal-Doped Indium Tin Oxide Thin Films
- Second-Harmonic Generation from Thermally Poled Mixed Alkali Silicate Glasses Containing Various Alkaline-Earth Oxides
- Relaxation of Free Volume in Zr_Cu_Al_ Bulk Metallic Glasses Studied by Positron Annihilation Measurements
- Glassy Solidification Criterion of Zr_Cu_Al_ Alloy
- Drastic Increase in the Toughness of Structural Relaxed Hypoeutectic Zr_Cu_Al_ Bulk Glassy Alloy
- Relations between the thermal and mechanical properties of cast Zr-TM-Al (TM: Cu, Ni, or Co) bulk glassy alloys (Special issue on bulk metallic glasses: selected papers from the fifth international conference on bulk metallic glasses (BMGV))
- Fatigue-Strength Enhancement of Cast Zr_Cu_Al_ Glassy Alloys
- Relaxation and Crystallization Behavior of the Zr_Cu_Al_ Metallic Glass
- Evolution of Mechanical Properties of Cast Zr_Cu_Al_ Glassy Alloys by Structural Relaxation
- Characterization of Crystalline Inclusions in Cast Bulk Zr-Cu-Ni-Al Glassy Alloy
- Effect of Ni Addition on Fatigue Properties of Bulk Glassy Zr_Cu_Al_ Alloys
- Electron Beam Welding of Zr_Cu_Ni_Al_ Bulk Glassy Alloys
- Relationship Between the Liquidus Surface and Structures of Zr-Cu-Al Bulk Amorphous Alloys
- Oxygen Embrittlement and Effect of the Addition of Ni Element in a Bulk Amorphous Zr-Cu-Al Alloy
- Rotating-Beam Fatigue Properties of Pd_Cu_Ni_P_ Bulk Glassy Alloy
- Enhancement of Ductility and Plasticity of Zn_Cu_Al_Ni_5 Bulk Glassy Alloy by Cold Rolling
- Growth of a Single Al_Cu_Fe_ Icosahedral Quasicrystal Using the Czochralski Method and Annealing Removal of Strains
- Fatigue Properties and Microstructures of Zr_Cu_Al_Ni_5 Bulk Glassy Alloys
- Preparation of Large Grained AL_Cu_Fe_ Icosahedral Quasivrystal Directly from the Melt
- Growth of Icosahedral Single Quasicrystal and 1/1-Cubic Approximant Single Crystal in an Al-Li-Cu Alloy System by the Czodhralski Method
- Nanocrystalline Zr-Based Bulk Glassy Alloys with High Flexural Strength
- Rotating-Beam Fatigue Strength of Pd_ Cu_ Ni_ P_ Bulk Amorphous Alloy
- Study of Surface Processes in the Digital Etching of GaAs
- c-Axis-Correlated Vortex Pinning Center Induced by Dilute Co-doping in Pulsed-Laser-Deposition-ErBa_2Cu_3O_y Films
- Enhancement of Flux-Pinning in Epitaxial Sm_Ba_Cu_3O_y Films by Introduction of Low-T_c Nanoparticles
- High-Critical-Current-Density SmBa_2Cu_3O_ Films Induced by Surface Nanoparticle
- Modification Effect of a-Si_ N_x:H Surface by Hydrogen Radicals
- A 0.7-μm-Pitch Double Level Al Interconnection Technology for 1-Gbit DRAMs using SiO_2 Mask Al Etching and Plasma Enhanced Chemical Vapor Deposition SiOF
- A Reliable Double Level Interconnection Technology for Giga Bit DRAMs Using SiO_2 Mask Al Etching and PECVD SiOF
- Thermal Decompositiom of Ce0_2 in Ultra High Vacuum as a Cause of Polycrystalline Growth of Si Films on Epitaxial Ce0_2/Si
- Low-Temperature Epitaxial Growth of CeO_2(110)/Si(100) Structure by Evaporation under Substrate Bias
- Analysis of Misoriented Crystal Structure by Ion Channeling Observed Using Ion-Induced Secondary Electrons
- Highly Accurate CO_2 Gas Sensor Using a Modulation-Type Pyroelectric Infrared Detector
- Surface Morphology of YBa_2Cu_3O_ Films Prepared by Metalorganic Chemical Vapor Deposition Using Liquid Sources
- Preparation of YBa_2Cu_3O_ Thin Films by Metal-Organic Chemical Vapor Deposition Using Liquid Sources
- Rare Earth Substitution Effects and Magnetic Field Dependence of Critical Current in Y_RE_xBa_2Cu_3O_y Coated Conductors with Nanoparticles (RE = Sm, Gd)
- Enhancement of Flux Pinning in Y_Sm_xBa_Cu_3O_y Coated Conductors with Nanoparticles
- Specimen preparation for high-resolution transmission electron microscopy using focused ion beam and Ar ion milling
- Structural Characterization of High-Quality ZnS Epitaxial Layers Grown on GaAs Substrates by Low-Pressure Metalorganic Chemical Vapor Deposition : Surfaces, Interfaces, and Films
- Internal Quantum Efficiency of Nitride-based Light-Emitting Diodes
- Evaluation of Thermal Expansion Coefficient of Twinned YBa_2Cu_3O_7-δ Film for Prediction of Crack Formation of Various Substrates
- Optical characterization of high-quality ZnS epitaxial films grown by low-pressure metalorganic chemical vapor deposition
- Intense Ultraviolet Electroluminescence Properties of the High-Power InGaN-Based Light-Emitting Diodes Fabricated on Patterned Sapphire Substrates
- Fabrication of REBa_2Cu_3O_x (RE=Y, Nd) Films on Yttria-Stabilized Zirconia by Liquid Phase Epitaxial Method with Ba-Cu-O-F Flux
- Intense Ultraviolet Electroluminescence Properties of the High-Power InGaN-Based LEDs Fabricated on Patterned Sapphire Substrates
- Recombination Dynamics of Self-Trapped Excitons in the High-Efficient Blue LEDs under Reverse Bias Condition
- Dependence of Exciton-Longitudinal-Optical-Phonon Interaction Energy on Well Width in Cd_Zn_Se/ZnSe Multiple-Quantum Wells
- Reduction of Inhomogeneous Broadening of Exciton Luminescence in Cd_xZn_Se Ternary Alloys and Cd_xZn_Se-ZnSe Multiple Quantum Wells Grown by Molecular-Beam Epitaxy under Se-Excess Supply
- Effect of High Current Injection on the Blue Radiative Recombination in InGaN Single Quantum Well Light Emitting Diodes
- Effect of Nd422 Addition on Jc in Nd123 Melt-Textured Bulk Superconductor
- Pulsed Field Magnetization of Melt-Processed Y-Ba-Cu-O Bulk Superconductor with No Weak Links
- High-Temperature Superconducting Motor Using Y-Ba-Cu-O Bulk Magnets
- Evidence of Mobile Ag and Growth Mechanism of YBa_2Cu_3O_7-y Films Deposited on Cube Textured Ag Tape by Chemical Vapor Deposition
- Spiral Growth of YBa_2Cu_3O_ Thin Films by Metalorganic Chemical Vapor Deposition Using Liquid-State Sources
- Fabrication of Tungsten-Carbon Multilayers for Soft X-Ray Optics Using Excimer-Laser-Induced Chemical Vapor Deposition Technique
- RBS/Channeling Study of the Crystallographic Correlation for Epitaxial CeO_2 on Si
- Growth Condition and X-ray Analysis of Single Al_Cu_Fe_ Icosahedral Quasicrystal by the Czochralski Method
- Creep Deformation of Single Al-Ni-Co Decagonal Quasicrystals
- Strain Affected Properties of Icosahedral Al-Pd-Mn Single Ingot
- Preparation of a Decagonal Al-Cu-Co Single Quasicrystal by the Czochralski Method
- Stable Decagonal Quasicrystal in an Al-Mn-Fe-Ge System
- High-Sensitivity Channeling Analysis of Lattice Disorder Near Surfaces Using Secondary Electrons Induced by Fast Ions
- Electrical Characteristics of Metal/Cerium Dioxide/Silicon Structures
- Quantitative Analysis of Oxygen Deficiency in Epitaxial CeO_2 Layers on Siby Detecting ^O Added for Stoichiometry
- Intermediate Amorphous Layer Formation Mechanism at the Interface of Epitaxial CeO_2 Layers and Si Substrates
- Nitriding of Evaporated-Ti Thin Films by Ion Implantation
- Epitaxial Growth of Vanadium Films Evaporated on NaCl Substrates
- Texture Structure Analysis and Crystalline Quality Improvement of CeO_2(110) Layers Grown on Si(100) Substrates
- Correlation between Anomalous Peak Effect in Magnetic Hysteresis Loop and Nanoscale Structure for NdBa_2Cu_3O_ Single-Crystal Superconductor
- Effects of Tempering Temperature and Stress Amplitude on Low-cycle Fatigue Behavior of a Cold-Work Tool Steel
- High Temperature Low Cycle Fatigue Property of P/M Hot Work Tool Steel
- Effect of the Quenching Temperature on the Mechanical Behavior of P/M Hot Work Tool Steels
- Effect of Testing Atmosphere on Low Cycle Fatigue of Hot Work Tool Steel at Elevated Temperature
- Ferromagnetic Decagonal Mn-Al-Ge-B-Fe Quasicrystals with High Coercive Force
- Anisotropic Diamagnetic Susceptibility of AlNiCo Quasi-crystal
- Phase Transition and Magnetic Properties of Supercooled Al-Ge-TM(TM=Cr, Fe, Co)Alloys
- Fabrication of Fe-Based Metallic Glass Particle Reinforced Al-Based Composite Materials by Friction Stir Processing
- Interface Microstructure and Mechanical Properties of Dissimilar Friction Stir Welded Joints between Zr_Cu_Ni_5Al_ Bulk Metallic Glass and Pure Al