Radiative Heat Transfer through Mold Flux Film during Initial Solidification in Continuous Casting of Steel

スポンサーリンク

概要

• 論文の詳細を見る

• Absorption coefficient and extinction coefficient for various commercial mold fluxes have been determined to quantify the radiative and the total heat transfer through the flux film in continuous casting mold. The absorption coefficient is found to be less than 1000 m-1 for glassy specimens whereas the extinction coefficient is <I>ca</I>. 3000-30000 m-1 for crystalline ones. Comparison of observed with calculated radiative heat flux from the absorption coefficient has shown that gray gas approximation is valid for evaluating the radiative heat flux across the mold flux film. Numerical calculation for both radiative and conductive heat transfer has been carried out for a given total thickness of the flux film. Despite little difference in optical properties among various mold fluxes, the radiative heat flux through molten layer of the flux films for low carbon and ultra low carbon steel is found larger than that for medium carbon steel. This is due to increasing thickness ratio of molten layer to crystalline layer of flux films. Solidifying and crystallizing behavior of mold fluxes is a key factor to control the radiative heat transfer in continuous casting mold, accordingly.

• 社団法人 日本鉄鋼協会の論文
• 1998-03-15

著者

• SHIBATA Hiroyuki

  Institute of Multidisciplinary Research for Advanced Materials (IMRAM), Tohoku University

• SUZUKI Mikio

  Institute for Advanced Materials Processing, Tohoku University

• EMI Toshihiko

  Institute for Advanced Materials Processing, Tohoku University

• Shibata H

  Institute For Advanced Materials Processing Tohoku University

• Shibata Hiroyuki

  Institute For Chemical Research Kyoto University

• Cho Jungwook

  Tohoku University

• Suzuki M

  Institute For Advanced Materials Processing Tohoku University

• Emi Toshihiko

  Institute For Advanced Materials Processing Tohoku University

• Shibata Hiroyuki

  Institute For Advanced Materials Processing Tohoku University

• Suzuki Mikio

  Institute For Advanced Materials Processing Tohoku University

関連論文

• High Thermal Conductivity of Gallium Nitride (GaN) Crystals Grown by HVPE Process
• Thermal and Optical Properties of Yb^-Doped Y_2O_3 Single Crystal Grown by the Micro-Pulling-Down Method
• Evaluation of Bubble Eye Area to Improve Gas/Liquid Reaction Rates at Bath Surfaces
• Electrical Resistivity Measurements of Pd_Cu_Ni_P_ Alloy in Supercooled Liquid and Liquid State
• Thermal Diffusivities and Conductivities of Molten Germanium and Silicon
• Measurement of Thermal Diffusivity of Steels at Elevated Temperature by a Laser Flash Method
• Interfacial Properties of Dilute Fe-O-S Melts on Alumina Substrates
• Applicability of Platinum and Molybdenum Coatings for Measuring Thermal Diffusivity of Transparent Glass Specimens by the Laser Flash Method at High Temperatures
• Natural Antioxidant, Chlorogenic Acid, Protects Against DNA Breakage Caused by Monochloramine
• In-situ Observation of Intragranular Ferrite Nucleation at Oxide Particles
• Molecular Properties and Enhancement of Thermostability by Random Mutagenesis of Glutamate Dehydrogenase from Bacillus subtilis
• 2-III-22 Intermolecular dimmer structure of Euglena ascorbate peroxidase
• Functional Characterization of D-Galacturonic Acid Reductase, a Key Enzyme of the Ascorbate Biosynthesis Pathway, from Euglena gracilis
• Characterization of Protein Phosphatase 2A Acting on Phosphorylated Plasma Membrane Aquaporin of Tulip Petals
• Phosphorylation of Plasma Membrane Aquaporin Regulates Temperature-Dependent Opening of Tulip Petals
• Generation of Reactive Oxygen Species from Hinokitiol under Near-UV Irradiation(Analytical Chemistry)
• Molecular Properties and Activity of Amino-Terminal Truncated Forms of Lipase Activator Protein
• Calcium Ion-Dependent Reactivation of a Pseudomonas Lipase by Its Specific Modulating Protein, LipB^1
• Analysis of Dephosphorization Reaction Using a Simulation Model of Hot Metal Dephosphorization by Multiphase Slag
• The Role of Metal Flows for Steel Processing and Casting Operations
• Modeling the Behavior of Al_2O_3 Inclusions during the Dendritic Solidification of Steel
• Distribution of P_2O_5 between Solid Dicalcium Silicate and Liquid Phases in CaO-SiO_2-Fe_2O_3 System
• Mass Transfer of P_2O_5 between Liquid Slag and Solid Solution of 2CaO・SiO_2 and 3CaO・P_2O_5
• Origin of Heat Transfer Anomaly and Solidifying Shell Deformation of Peritectic Steels in Continuous Casting
• Simulation of Crack Formation on Solidifying Steel Shell in Continuous Casting Mold
• Recovery of Hot Ductility by Improving Thermal Pattern of Continuously Cast Low Carbon and Ultra Low Carbon Steel Slabs for Hot Direct Rolling
• Distribution of P_2O_5 between Solid Solution of 2CaO・SiO_2-3CaO・P_2O_5 and Liquid Phase
• Precipitation Behavior of Copper, Tin and Manganese Sulfide at High Temperature in Fe-10%Cu-0.5%Sn Alloys
• Cysteine Uptake for Accumulation of Glutathione by the Cyanobacterium Synechocystis strain PCC 6803
• Repraesentins D, E and F, New Plant Growth Promoters from Lactarius repraesentaneus
• Anti-inflammatory Cyathane Diterpenoids from Sarcodon scabrosus
• New Plant Growth Promoters, Repraesentins A, B and C, from Lactarius repraesentaneus(Organic Chemistry)
• Hydroxyl Radical Generation Depending on O_2 or H_2O by a Photocatalyzed Reaction in an Aqueous Suspension of Titanium Dioxide
• Determination of Free Energy of δ-Ferrite/γ-Austenite Interphase Boundary of Low Carbon Steels by In-situ Observation
• In-situ Observation of Engulfment and Pushing of Nonmetallic Inclusions in Steel Melt by Advancing Melt/Solid Interface
• Characteristics of Agglomeration of Various Inclusion Particles on Molten Steel Surface
• "In-situ"Observation of Collision, Agglomeration and Cluster Formation of Alumina Inclusion Particles on Steel Melts
• Characterization of Four Plasma Membrane Aquaporins in Tulip Petals : A Putative Homolog is Regulated by Phosphorylation
• Cloning, Biochemical and Phylogenetic Characterizations of γ-Glutamylcysteine Synthetase from Anabaena sp. PCC 7120
• Cloning,Structural Analysis and Expression of the Gene Encoding Aspartate Aminotransferase from the Thermophilic Cyanobacterium Phormidium lapideum
• Characterization of Aspartate Aminotransferase from the Cyanobacterium Phormidium lapideum(Biochemistry & Molecular Biology)
• Oxidation and Reduction of Nitrite Ion in the TiO_2 Photo-induced Catalytic Reaction
• Effect of Intracellular Glutathione on Heat-induced Cell Death in the Cyanobacterium, Synechocystis PCC 6803
• In-Situ Measurement of Fracture Strength of Solidifying Steel Shells to Predict Upper Limit of Casting Speed in Continuous Caster with Oscillating Mold
• Criteria for Water Modeling of Melt Flow and Inclusion Removal in Continuous Casting Tundishes
• Heat Transfer across Mold Flux Film in Mold during Initial Solidification in Continuous Casting of Steel
• Thermal Resistance at the Interface between Mold Flux Film and Mold for Continuous Casting of Steels
• Radiative Heat Transfer through Mold Flux Film during Initial Solidification in Continuous Casting of Steel
• Heat Transfer from Shell across Flux Film to Continuous Casting Mold
• Measurement of Optical Properties of Continuous Casting Mold Fluxes at Elevated Temperatures
• Thermal Resistance between Solidifying Steel Shell and Continuous Casting Mold with Intervening Flux Film
• Anomaly in Melting Behavior and Mechanical Properties of Carbon Steels Near Their Solidus Temperature
• "In-situ"Real Time Observation of Planar to Cellular and Cellular to Dendritic Transition of Crystals Growing in Fe-C Alloy Melts
• Solubility of MnS in Fe-Ni Alloys as Determined by In-situ Observation of Precipitation of MnS with a Confocal Scanning Laser Microscope
• Chemical State of Chromium in CaO-SiO_2 Base Oxides Annealed under Different Conditions
• 1-III-3 Vitamin C Biosynthesis and Translocation in Tomato (Lycopersicum esculentum) Fruits
• On the Nuclear Interaction of Mu-Mesons
• Influence of Bottom Bubbling Condition on Metal Emulsion Formation in Lead-Salt System
• Degree of Undercooling and Contact Angle of Pure Iron at 1933K on Single-crystal Al_2O_3, MgO, and MgAl_2O_4 under Argon Atmosphere with Controlled Oxygen Partial Pressure
• Evaluation of Bubble Eye Area to Improve Gas/Liquid Reaction Rates at Bath Surfaces
• Expression Analysis of the VTC2 and VTC5 Genes Encoding GDP-L-Galactose Phosphorylase, an Enzyme Involved in Ascorbate Biosynthesis, in Arabidopsis thaliana
• Estimation of Heat Transfer of a Front-heating Front-detection Laser Flash Method Measuring Thermal Conductivity for Silicate Melts at High Temperatures
• Thermal and Optical Properties of Yb3+-Doped Y2O3 Single Crystal Grown by the Micro-Pulling-Down Method
• A Non-NadB Type L-Aspartate Dehydrogenase from Ralstonia eutropha Strain JMP134 : Molecular Characterization and Physiological Functions
• Expression Analysis of the VTC2 and VTC5 Genes Encoding GDP-L-Galactose Phosphorylase, an Enzyme Involved in Ascorbate Biosynthesis, in Arabidopsis thaliana
• (6) High Speed Slab Caster (Miscellany)
• Behavior of Vanadium and Niobium during Hot Metal Dephosphorization by CaO-SiO_2-Fe_tO Slag
• Influence of Solid CaO and Liquid Slag on Hot Metal Desulfurization
• Mechanism of Change in Chemical Composition of Oxide Inclusions in Fe-Cr Alloys Deoxidized with Mn and Si by Heat Treatment at 1473 K
• Influence of Bottom Bubbling Rate on Formation of Metal Emulsion in Al–Cu Alloy and Molten Salt System
• Influence of Bottom Bubbling Rate on Formation of Metal Emulsion in Al-Cu Alloy and Molten Salt System
• Influence of Slag Basicity and Temperature on Fe and Mn Distribution between Liquid Fe–Mn–Ca–O–S Matte and Molten Slag
• Equilibrium Distribution Ratio of Phosphorus between Solid Iron and Magnesiowustite-saturated Al2O3–CaO–FetO–MgO–SiO2 Slag at 1623 K

もっと見る 閉じる

スポンサーリンク