Fabrication of Capacity-Equalized Mold for Homogenizing Residual Layer Thickness in Imprint Lithography
スポンサーリンク
概要
- 論文の詳細を見る
Residual layer control is the key issue in imprint lithography. A thin and uniform residual layer is easily realized for uniform pattern density but it is hardly realizable for nonuniform pattern densities where the moldable materials are supplied by spin coating. The author proposes a new type of mold called capacity-equalized mold that homogenizes the residual layer for a variety of pattern densities and is even suitable for spin-coated films. The capacity-equalized mold was fabricated by introducing an additional lithography step to the conventional mold fabrication process by employing a supplementary mask for modulating the cavity depths in molds. The uniform residual layer for a variety of pattern densities was confirmed by UV nanoimprint using a capacity-equalized mold.
- 2008-10-25
著者
-
HIROSHIMA Hiroshi
National Institute of Advanced Industrial Science and Technology
-
Hiroshima Hiroshi
National Institute of Advanced Industrial Science and Technology (AIST), AIST East, 1-2-1 Namiki, Tsukuba, Ibaraki 305-8564, Japan
関連論文
- Close Observation of the Geometrical Features of an Ultranarrow Silicon Nanowire Device
- UV Nanoimprint in Pentafluoropropane at a Minimal Imprint Pressure
- Fabrication processes for capacity-equalized mold with fine patterns (Special issue: Microprocesses and nanotechnology)
- Simulation of Resist Filling Properties under Condensable Gas Ambient in Ultraviolet Nanoimprint Lithography (Special Issue : Microprocesses and Nanotechnology)
- Effective Linewidth Measurement of 45-nm-Half-Pitch Ultraviolet Nanoimprint Lithography Patterns by Scanning Electron Microscope Inspection and Extremely Shallow Si Etching (Special Issue : Microprocesses and Nanotechnology)
- Effects of Environmental Gas in UV Nanoimprint on the Characteristics of UV-Curable Resin
- Evaluation of Viscosity Characteristics of Spin-Coated UV Nanoimprint Resin
- Fabrication of Capacity-Equalized Mold for Homogenizing Residual Layer Thickness in Imprint Lithography
- Quick Cavity Filling in UV Nanoimprint Using Pentafluoropropane
- Step and Repeat Ultraviolet Nanoimprinting under Pentafluoropropane Gas Ambient
- Study on Quartz Multitier Mold Fabrication Using Gray Scale Laser Beam Lithography
- In-situ Evaluation of Air/Oxygen Percentage Variation by Introducing 1,1,1,3,3-Pentafluoropropane in Ultraviolet Nanoimprint Lithography
- Study on Change in UV Nanoimprint Pattern by Altering Shrinkage of UV Curable Resin
- Effects of Granularity of Complementary Patterns in a Capacity-Equalized Mold Used for UV Nanoimprint Lithography
- Fabrication of Ultrasmooth Mirrors by UV-Nanoimprint
- Evaluation of UV-Nanoimprinted Surface Roughness Using Si Mold with Atomically Flat Terraces
- Uniform Residual Layer Creation in Ultraviolet Nanoimprint Using Spin Coat Films for Sub-100-nm Patterns with Various Pattern Densities
- Control of Resin Filling and Pattern Quality of Ultraviolet Nanoimprint Lithography in Pentafluoropropane and Helium Ambient
- Study of Demolding Characteristics in Step-and-Repeat Ultraviolet Nanoimprinting
- Uniform Residual Layer Creation in Ultraviolet Nanoimprint Using Spin Coat Films for Sub-100-nm Patterns with Various Pattern Densities (Special Issue : Microprocesses and Nanotechnology)
- Control of Bubble Defects in UV Nanoimprint