D-T neutron measurements on Gekko XII laser inertial fusion plasmas by multi-activation foil method.
スポンサーリンク
概要
著者
-
Iguchi Tetsuo
Department Of Nuclear Engineering Faculty Of Engineering The University Of Tokyo
-
Nakazawa Masaharu
Department Of Electrical Engineering University Of Tokyo:(present Address) Nuclear Engineering Resea
-
Miyanaga Noriaki
Institute Laser Engineering Osaka University
-
Yamanaka Masanobu
Institute Of Laser Engineering Osaka University
-
Takada Eiji
Department Of Electric Engineering Toyama National College Of Technology
-
Shimizu Yasuyuki
Department Of Civil Engineering Hokkaido University
-
Yamanaka Chiyoe
Institute For Laser Technology
-
Nakai Sadao
Institute Of Laser Engineering Faculty Of Engineering Osaka University
-
SHIMIZU Yasuyuki
Department of Nuclear Engineering, Faculty of Engineering, University of Tokyo
関連論文
- Development of Trace Isotope Analysis using Resonance Ionization Mass Spectrometry based on Isotope Selection with Doppler Shift of Laser Ablated Atoms
- Development of TOF-PET using Cherenkov Radiation
- Development of the Isotope Analysis Technique for Inorganic Trace Elements using Laser Ablation Assisted Resonance Ionization Mass Spectrometry (LA-RIMS)
- Rapid-Swept CW Cavity Ring-down Laser Spectroscopy for Carbon Isotope Analysis
- Development of High Dose Rate Sensing Method Based on Cavity Ring-Down Laser Spectroscopy
- Optimum Design of Exploding Pusher Target to Produce Maximum Neutrons
- Efficient Spherical Compression of Cannonball Targets with 1.052-μm Laser Beams
- Application of General Purpose Fiber Optic Data Links to Radiation Measurements
- Mechanical-Stress Induced Nd:YAG Active Quarter-Wave Plate
- Generation of Super-Fast Ions due to Nonlinear Processes near the Quarter Critical Density in Laser-Produced Plasmas
- Debris-Free Laser-Assisted Low-Stress Dicing for Multi-Layered MEMS : Separation Method of Glass Layer
- Performance of Plasma Erosion Opening Switches in High Voltage Pulsed Power Compression
- Jet Formation and Application for Inertial Confinement Fusion Target
- Experimental Study of Alternative Implosion Concepts for Particle Beam ICF
- Performance of a Diverged Electron Beam Ion Diode
- Characteristics of Transported Ion Beam in Laser-Initiated Plasma Channels
- CO_2 Laser Guided Plasma Channel for Light Ion Beam Transport
- Momentum Transfer and Related Interaction Phenomena of a High Power CO_2 Laser
- Influence of X-ray Beam Angulation in the Detection of Proximal Caries : Interobserver Agreement in the CCD System
- High-Resolution Penumbral Imaging of 14-MeV Neutrons
- Observation of Burn and Pusher Regions of Laser-Driven Large-High-Aspect-Ratio Target by α-Particle Imaging
- Debris-free Low-stress High-speed Laser-assisted Dicing for Multi-layered MEMS
- Debris-Free High-Speed Laser-Assisted Low-Stress Dicing for Multi-Layered MEMS
- Spectrum-Resolved Absolute Energy Measurement of X-Ray Emission in 0.17-1.6 keV Range from a 0.53 μm Laser-Irradiated Au Target
- Ablative Acceleration of Pellet Shells Irradiated by External Soft X-ray Sources
- Soft X-Ray Driven Ablation and Its Positive Use for a New Efficient Acceleration
- Ablation Nonuniformity on Laser Irradiated Pellet and Collisional Hot Electron Filamentation
- Performance of Radial Focus Applied-B Ion Diode on a Coaxial Pulse Power Machine
- New Scheme of Cannonball Target Driven by Ion Beam
- Light Ion Beam Transport in a Multi-Plasma Channel System
- Development of HALNA DPSSL for the inertial fusion energy
- Diode-Pumped Glass Laser (10J x 10Hz) Development
- Quasi-CW 110kW AlGaAs Laser Diode Array Module for Inertial Fusion Energy Laser Driver : Optics and Quantum Electronics
- Design and Performance of a Diode-Pumped Nd:Silica-Phosphate Glass Zig-Zag Slab Laser Amplffier for Inertial Fusion Energy : Optics and Quantum Electronics
- Thermal- and Spectral-Characteristics of High-Power Quasi-Continuous Wave 940-nm InGaAs Diode Laser Arrays
- Bandwidth Narrowing of an All-Solid-State Optical Parametric Oscillator Amplifier System
- Conceptual Design Studies of a Laser Diode Pumped Solid State Laser System for the Laser Fusion Reactor Driver
- Thermal Birefringence Effect on the Performance of a Laser-Diode Pumped Solid-State Laser
- Temperature Dependence of Emission Cross-section of Yb:glass
- High-Sensitivity Two-Dimensional Observation of Thermal Birefringence Compensation in Laser-Diode Pumped Nd:Glass Laser Rods
- Model for Cannonball-Like Acceleration of Laser-Irradiated Targets
- Bunch-Shape Monitor for a Picosecond Single-Bunch Beam of a 35 MeV Electron Linear Accelerator
- Neutron Yield in a Repetitive Dense Plasma Focus
- A Digital Waveform Analysis System with a Fast Digitizer and VXIbus System
- Spatial Distribution Measurement of Ions Surrounding an Alpha Source using a New Micro-ionization Chamber
- New Techniques to Apply Optical Fiber Image Guide to Nuclear Facilities
- Development of a Micro-beam Monitor Using Taperd Quartz Image Guide
- Radiation Distribution Sensor with Optical Fibers for High Radiation Fields
- Correction Techniques of Radiation Induced Errors for Raman Distributed Temperature Sensor and Experiment at the Experimental Fast Reactor : JOYO
- Clustering Method to Process Signals from a CdZnTe Detector
- Numerical Simulation of a Nuclear Pumped ^3He-Ne-Ar Gas Laser for its Optimization
- High-Power Operation of 1cm Laser Diode Bars on Funryu Heat Sink Cooled by Fluorocarbons
- Single-Wavelength 5.6kW Direct Diode Laser with a High-Efficiency Beam Combination
- Recovery of (411)A Superflat Interfaces in GaAs/Al_Ga_As Quantum Wells Grown on (411)A GaAs Substrate by Molecular Beam Epitaxy
- Parametric Studies on the Laser-Diode-Pumped, Thermal-Lensing-Compensated, Mode-Locked, Q-Switched Nd:YAG Laser
- New Potential of a Direct Laser-Diode-Pumped Yb:YAG Laser
- Localization of Neutrons Generated in a Dense Plasma Focus
- Anamorphic Focusing Optical System for Laser-Diode-Array
- A Simple Method for Measurement of Wavelength Chirping of a High-Peak-Power Laser Diode Array during Pulsed Operation
- Direct Numerical Simulation of Turbulence Over Two-Dimensional Dunes Using CIP Method
- Mecanism and Time Behavior of the 538 μm Laser Emission from ICN
- Spatially Resolved Measurement of Plasma Density Using a 337 μm Cyanide Laser
- Experiments on a Far Infrared CN Laser
- Safety Shutdown of the High Temperature Engineering Test Reactor during Loss of Off-site Electric Power Simulation Test
- Development of Failed Fuel Detection and Location Technique Using Resonance Ionization Mass Spectrometry
- Neutral Debris Mitigation in Laser Produced Extreme Ultraviolet Light Source by the Use of Minimum-Mass Tin Target
- Pulse Shape Analysis on Mixed Beta Particle and Gamma-ray Source Measured by CdZnTe Semiconductor Detector by means of Digital-Analog Hybrid Signal Processing Method
- Energy Spectrum Improvement for CdZnTe Semiconductor Detector Based on Euclidian Distance with Digital-Analog Hybrid Signal Processing System
- Energetic Proton Generation in a Thin Plastic Foil Irradiated by Intense Femtosecond Lasers
- Generation of ultrashort UV laser pulse and its application to ream-time vibrational spectroscopy
- Imaging Characteristics of a Replicated Wolter Type. : I. X-Ray Mirror Designed for Laser Plasma Diagnostics
- Two-Dimensional Multi-Lens Array with Circular Aperture Spherical Lens for Flat-Top Irradiation of Inertial Confinement Fusion Target
- Fine Structures of Laser-Driven Punched-Out Tin Fuels Observed with Extreme Ultraviolet Backlight Imaging
- Study of Thermal Smoothing by Shock Speed Measurement
- Analysis of Spherical Target Illumination with Partially Coherent Light through Random Phase Plate
- Nuclear Analysis of GEKKO XII ICF Experiment Facility
- Analysis of Birefringence Compensation Using a Quarter-Wave Plate in Solid-State Lasers
- Fabrication of Low-Density Solid Xenon as Laser-Produced Plasma Extreme Ultraviolet Source
- Trace Element Analysis using Resonant Laser Ablation
- Waveform Analysis of Bilayer Iridium/Gold Superconducting Transition Edge Sensor Microcalorimeter
- Comparison of Superconducting Transition Characteristics of Two Iridium/Gold Bilayer Transition Edge Sensor Devices
- Advanced Target Design for the FIREX-I Project
- Laser Production of Extreme Ultraviolet Light Source for the Next Generation Lithography Application
- Simulations on Generating Long Flat-Top Laser Pulses for Fast Ignition of Laser Fusion
- Characteristics of Laser Diode Bar and Stack with Jet-Type, Water-Cooled Heatsink
- Development of Trace Isotope Analysis using Resonance Ionization Mass Spectrometry based on Isotope Selection with Doppler Shift of Laser Ablated Atoms
- Analysis of Parasitic Oscillation and Evaluation of Amplifier Module of Zig-Zag Slab Laser System
- Extreme Ultraviolet Emission from Laser-Irradiated Low-Density Xe Targets
- Tunable Near-Infrared and Visible All-Solid-State Optical Parametric Oscillator Amplifier System Based on Potassium Titanyl Phosphate Crystal
- Gain and Spectral Characteristics of Broadband Optical Parametric Amplification
- Development of Proton Detection System with Thin Ruby Scintillator Insensitive to Neutrons and Gamma Rays for Neutron Lifetime Measurement
- Interfering Ultraviolet Femtosecond Laser Processing of Gold Thin Film and Prospect of Shortest Period
- High-Gain Regenerative Chirped-Pulse Amplifier Using Photonic Crystal Rod Fiber
- Properties of Shell-Confined Long Life Plasmas Produced by Lasers
- D-T neutron measurements on Gekko XII laser inertial fusion plasmas by multi-activation foil method.
- Gain Spectral Filtering for Spectral Enhancement of Mode-Locked Fiber Oscillators
- Radioactive Carbon Isotope Monitoring System Based on Cavity Ring-down Laser Spectroscopy for Decommissioning Process of Nuclear Facilities
- Fission spectrum averaged cross sections of some threshold reactions measured with fast reactor "YAYOI".
- Some New Applications of Neutron Slowing Down Time Spectrometry
- Improvement of Accuracy of Zr/Nb Activation-Rate Ratio Method for D-T Neutron Source Energy Determination