Simulations on Generating Long Flat-Top Laser Pulses for Fast Ignition of Laser Fusion
スポンサーリンク
概要
- 論文の詳細を見る
A modified input–output algorithm is first applied to generate long flat-top pulses using a phase-only pulse shaper for fast ignition of laser fusion. More accurate long (10–20 ps) flat-top pulses can be obtained within several hundred iterations that take much shorter simulation time compared with “trial-and-error” algorithms. Also the flat-top pulses generated by the input–output algorithm are free from noise in the wings of the main pulse, thus higher pulse contrast with reduced pedestal can be obtained, which is very important for the fast ignition of laser fusion. Simulations also show that flatness on the flat-top of the pulse is fairly insensitive to perturbations of input signals.
- 2006-09-15
著者
-
Miyanaga Noriaki
Institute Laser Engineering Osaka University
-
Lu Jianren
Institute For Laser Science University Of Electro-communications
-
Lu Jianren
Institute of Laser Engineering, Osaka University, 2-6 Yamada-oka, Suita, Osaka 565-0871, Japan
-
Miyanaga Noriaki
Institute of Laser Engineering, Osaka University, 2-6 Yamada-Oka, Suita, Osaka 565-0871, Japan
関連論文
- Optimum Design of Exploding Pusher Target to Produce Maximum Neutrons
- Efficient Spherical Compression of Cannonball Targets with 1.052-μm Laser Beams
- Yb^:Y_2O_3 Ceramics : a Novel Solid-State Laser Material : Optics and Quantum Electronics
- Chromium Doped Y_3Al_5O_ Ceramics : a Novel Saturable Absorber for Passively Self-Q-Switched One-Micron Solid State Lasers
- Nd^:Y_2O_3 Ceramic Laser
- Highly Efficient Nd:Y_3Al_5O_ Ceramic Laser : Optics and Quantum Electronics
- Generation of Super-Fast Ions due to Nonlinear Processes near the Quarter Critical Density in Laser-Produced Plasmas
- Debris-Free Laser-Assisted Low-Stress Dicing for Multi-Layered MEMS : Separation Method of Glass Layer
- High-Resolution Penumbral Imaging of 14-MeV Neutrons
- Observation of Burn and Pusher Regions of Laser-Driven Large-High-Aspect-Ratio Target by α-Particle Imaging
- Debris-free Low-stress High-speed Laser-assisted Dicing for Multi-layered MEMS
- Debris-Free High-Speed Laser-Assisted Low-Stress Dicing for Multi-Layered MEMS
- Laser Damage Threshold of Ceramic YAG
- Model for Cannonball-Like Acceleration of Laser-Irradiated Targets
- High-Power Nd : Y_3Al_5O_ Ceramic Laser
- Ultra-Broadband Supercontinuum Generation and Characterization of Brillouin/Raman Fiber Laser (「ファイバレーザーの新展開」解説小特集)
- Output Characteristics of High-Power Continuous Wave Raman Fiber Laser at 1484 nm Using Phosphosilicate Fiber
- Neutral Debris Mitigation in Laser Produced Extreme Ultraviolet Light Source by the Use of Minimum-Mass Tin Target
- Energetic Proton Generation in a Thin Plastic Foil Irradiated by Intense Femtosecond Lasers
- Generation of ultrashort UV laser pulse and its application to ream-time vibrational spectroscopy
- Two-Dimensional Multi-Lens Array with Circular Aperture Spherical Lens for Flat-Top Irradiation of Inertial Confinement Fusion Target
- Fine Structures of Laser-Driven Punched-Out Tin Fuels Observed with Extreme Ultraviolet Backlight Imaging
- Study of Thermal Smoothing by Shock Speed Measurement
- Analysis of Spherical Target Illumination with Partially Coherent Light through Random Phase Plate
- Fabrication of Low-Density Solid Xenon as Laser-Produced Plasma Extreme Ultraviolet Source
- Advanced Target Design for the FIREX-I Project
- Laser Production of Extreme Ultraviolet Light Source for the Next Generation Lithography Application
- Simulations on Generating Long Flat-Top Laser Pulses for Fast Ignition of Laser Fusion
- Laguerre-Gaussian Modes Selection in Diode-Pumped Solid-State Lasers
- Analysis of Parasitic Oscillation and Evaluation of Amplifier Module of Zig-Zag Slab Laser System
- Coupling from Laser Diode Bar to Single-mode Fiber Using a Stubbed Waveguide
- Extreme Ultraviolet Emission from Laser-Irradiated Low-Density Xe Targets
- Interfering Ultraviolet Femtosecond Laser Processing of Gold Thin Film and Prospect of Shortest Period
- High-Gain Regenerative Chirped-Pulse Amplifier Using Photonic Crystal Rod Fiber
- D-T neutron measurements on Gekko XII laser inertial fusion plasmas by multi-activation foil method.
- Gain Spectral Filtering for Spectral Enhancement of Mode-Locked Fiber Oscillators