高温ガスを照射した窒化ケイ素表面の光学顕微鏡観察

概要

論文の詳細を見る
Hot-gas corrosion behavior of Si_3N_4 against high speed combustion gas was investigated by optical microscopy observation. A city gas (13A) with the composition of CH_4 : 88.60, C_3H_8 : 3.20, C_2H_6 : 5.09 and C_4H_<10> : 2.86 in vol%, was used as fuel. Three Si_3N_4 test bars with the size of 4mm×4mm×80mm were used for each exposing run. The exposure was carried out in combustion gas temperature of around 1400℃ with the current velocity of about 190m/s. The exposing time was totally 60h (7-8h in a day). At the earlier stage, after 8-16h exposure, thin and glassy oxide layer was formed on the surface of Si_3N_4. The oxide layer changed to a powdery substance with elapsing exposure time and the surface was fully covered by powdery oxide after ≈24h. The powdery oxide was only attached on the surface very loosely and it was easily removed by soft touch. White spots on particles from the burner side which consisted of a larger amount of glassy phase, also changed to powder and fade away with elapsing time. At an earlier stage, after 8-16h exposure, the specimens showed relatively lower weight loss compared to that detected after around 24h exposure. It is considered that the decreasing weight may be divided into two stages according to the change of ratio in weight loss before and after each exposure. Thus, in the earlier stage, it can be assumed that vaporizing of Si, O and N_2 from the surface grassy phase mainly takes place, while in the later stage, the main process is the removment of powdery oxide in addition to vaporization of Si, O and N_2.
社団法人日本セラミックス協会の論文
2005-05-01

高温ガスを照射した窒化ケイ素表面の光学顕微鏡観察

スポンサーリンク

概要

著者

関連論文

スポンサーリンク