PG-05 COMPUTER SIMULATION ON THE HEAT GENERATION IN MESHING OF PLASTIC SPUR GEARS : EFFECT OF MODULE AND GEAR SPEED ON HEAT RADIATION(PLASTIC GEAR TECHNOLOGY)
スポンサーリンク
概要
- 論文の詳細を見る
The heat generation due to friction between tooth flanks and hysteresis of plastic material greatly affects the load capacity of plastic gear pair, especially in operation without lubricants. And, the bending strength is not proportional for module size and facewidth, because the plastic gear generation of heat. In addition, when the gear speed quickens, the possibility of generation of heat increases and the tooth temperature rise. However, as for the faster speed, the generation heat potential decreases and the tooth temperature falls. Therefore, The bending strength formula of plastic gear must consider for the generation heat by the module size, facewidth and gear speed. Then, the temperature should be the critical section of the tooth profile. It was analyzed by special heat software of the gear that developed by us. In the present paper, an effect with module and gear speed to the radiation was analyzed for the gear by various modules.
- 一般社団法人日本機械学会の論文
- 2009-05-13
著者
-
TAKAHASHI Hideo
Department of Electronics Engineering, Faculty of Engineering, Shibaura Institute of Technology
-
NAKAMURA Morimasa
Kyoto Institute of Technology
-
MORIWAKI Ichiro
Kyoto Institute of Technology
-
Ueda Akio
Amtec Inc.
-
NAKAMURA Morimasa
Department of Mechanical and System Engineering, Kyoto Institute of Technology
-
MORIWAKI Ichiro
Department of Mechanical and System Engineering, Kyoto Institute of Technology
-
Moriwaki Ichiro
Department Of Mechanical & System Engineering Kyoto Institute Of Technology
-
Nakamura Morimasa
Department Of Mechanical And System Engineering Kyoto Institute Of Technology
-
Takahashi Hideo
Department Of Anatomy Dokkyo Medical University School Of Medicine
関連論文
- Light transmittance characteristics and refractive indices of light-activated pit and fissure sealants
- Effects of HMGB1 on Ischemia-Reperfusion Injury in the Rat Heart
- OJ-186 The Effects of HMGB1 on Ischemia-Reperfusion Injury in the Rat Heart(Myocardial ischemia / reperfusion, basic / clinical(02)(IHD),Oral Presentation (Japanese),The 72nd Annual Scientific Meeting of the Japanese Circulation Society)
- Effect of various visible light photoinitiators on the polymerization and color of light-activated resins
- Effects of Deposition Conditions on Adhesion of DLC Films Prepared by UBM Sputtering
- Effect of Inhomogeneity of Light from Light Curing Units on the Surface Hardness of Composite Resin
- Effect of Filler Properties in Composite Resins on Light Transmittance Characteristics and Color
- Light-attenuating Effect of Dentin on the Polymerization of Light-activated Restorative Resins
- Optical and Color Stabilities of Paint-on Resins for Shade Modification of Restorative Resins
- Adenosine A2A-Receptor Stimulation Inhibits Lipopolysaccharide-Induced Interleukin-18 Production in Monocytes
- Three-dimensional Solution Structure of Calcium Channel Activator : Impreratoxin A Determined by NMR Spectroscopy
- PG-05 COMPUTER SIMULATION ON THE HEAT GENERATION IN MESHING OF PLASTIC SPUR GEARS : EFFECT OF MODULE AND GEAR SPEED ON HEAT RADIATION(PLASTIC GEAR TECHNOLOGY)
- GDS-04 Measurement of Contact Stress on Tooth Flank of Spur Gear Subject to Static Load : Comparison of analysis with Tooth Flank Film Element(DESIGN AND SYNTHESIS OF A PAIR OF GEARS OR OF GEAR TRAINS)
- What prevents Japan from establishing a clinical service of sleep medicine : Experience gained at a local hospital
- A Method for Evaluating Color Stability of Light-cured Composite Resing Using an Experimental Filter
- Influence of parental obesity on the physical constitution of preschool children in Japan
- Thermo-Optic Switch using Fluorinated Silicon Oxide and Organic Spin-on-Glass Films
- Properties of a Thin-Film Optical Waveguide Using Fluorinated Silicon Oxide and Organic Spin-on-Glass Films
- -0912-LOCALIZATION DIAGNOSIS AND TREATMENT OF WPW SYNDROME WITH MULTIPLE ACCESSORY PATHWAYS : THE 54th ANNUAL SCIENTIFIC MEETING OF THE JAPANESE CIRCULATION SOCIETY
- Changes in Purine Metabolism and Production of Oxygen Free Radicals by Intermittent Partial Umbilical Cord Occlusion in Chronically Instrumented Fetal Lambs
- Deformation Mechanism of Hot Finish Rolling of Plastic Gears
- GLE-09 EVALUATION OF SURFACE DURABILITY OF DLC FILMS DEPOSITED BY UBM SPUTTERING(GEAR LUBRICATION AND EFFICIENCY)
- Roll-Finishing of a Quenched Gear
- Numerical Analysis of Tooth Forms of Shaved Gears
- Profile and Longitudinal Modification of a Roll-Finishing Die-Wheel
- Roll-finishing of Involute Helical Gears in Crossed Axes System : 3 rd Report, Tip Relieving of die-Wheel : Series C : Vibration Control Engineering Engineering for Industry
- On Tooth form Accuracy of Roll-finished Involute Helical Gears : 4th Report, Use of Die-wheel with Longitudinal Tooth from correction (Crowning)
- Roll-finishing of Involute Helical Gears in Crossed Axes System : 2nd Report, Computer Simulation
- Roll-finishing of Involute Helical Gears in crossed Axes System : 1st Report, Fundamental Investigation
- GSD-5 FACE GEAR DEVELOPMENT AND ENDURANCE TEST FOR AIRCRAFT APPLICATION(GEAR STRENGTH AND DURABILITY)
- J-8 DEVELOPMENT OF SIMULATION FOR HOT FORGING OF GEARS : Constitutive Equation in Considering Visco-Plasticity(Session: Simulation)
- J-7 REDUCTION OF CALCULATION TIME IN GEAR SHAVING SIMULATION(Session: Simulation)
- Optical Properties of Paint-on Resins for Shade Modification of Crown and Bridge Resins : Light Transmittance Characteristics
- Nafamostat Mesilate Induces Production of Interleukin-12 and -18 in Human Peripheral Blood Mononuclear Cells
- IP-B3 TOOTH FORM ANALYSIS SIMULATION OF THE WORM GEARS : THE UTILIZATION OF THE SOFTWARE FOR GETTING PROPER MESHING(PAPERS FOR INDUSTRIAL PANELS)
- Cranial photographs of mammals on the web : the Mammalian Crania Photographic Archive (MCPA2) and a comparison of bone image databases
- Shifts in the Optimum pH of Rhizopus Glucoamylase Depending on the Reaction Temperatures.
- Expression of type 1 plasminogen activator inhibitor and nitric oxide generation in ischemic preconditioning of rat liver
- Mast Cell Tryptase Stimulates DLD-1 Carcinoma Through Prostaglandin- and MAP Kinase-Dependent Manners
- A method for improving the light intensity distribution in dental light-curing units
- Effect of Antibodies Against Intercellular Adhesion Molecule-1, B7, and CD40 on Interleukin-18-Treated Human Mixed Lymphocyte Reaction
- Neuronal Activities of the Red Nucleus during Rhythmic Jaw Movements in the Rat
- Physiology and Pathophysiology of Proteinase-Activated Receptors (PARs) : PAR-2-Mediated Proliferation of Colon Cancer Cell
- Individual TW2 Skeletal Maturity in Tokyo Girls
- Effects of Interferon-γand Rapamycin on Transforming Growth Factor-β-induced Liver Fibrosis in an Organotypic Slice Culture
- Effects of erect bipedal standing on the morphology of rat vertebral bodies
- Rotation culture with a newly developed holder enables long-term liver slice culture for study of liver fibrosis
- PG-03 A STUDY ON LOAD CARRYING CHARACTERISTICS OF PLASTIC CROSSED HELICAL GEAR(PLASTIC GEAR TECHNOLOGY)
- The Course of Study which Links "Microcomputer" with "Electric Engineering Experiments" for the Purpose of Double PBL
- The Regulation of ICAM-1 and LFA-1 Interaction by Autacoids and Statins : a Novel Strategy for Controlling Inflammation and Immune Responses
- BCD-19 REDUCTION OF EXTENSIONAL STRENGTH OF SYNCHRONOUS BELT CORDS(BELT AND CHAIN DRIVES)
- Self Maps of Suspension of Sphere Bundles over Spheres
- SELF MAPS OF Σ^2HP^3 AND THE SUSPENSION : Σ : [ΣHP^3, ΣHP^3]→[Σ^2HP^3, Σ^2HP^3]
- Note on Homotopy Classes of Self Maps; [ΣHP³, ΣHP³]
- Effects of erect bipedal standing on the morphology of rat vertebral bodies
- Intramolecular [2+2] photocycloaddition. 5. Synthetic methods toward [2.n]-, [3.n]-, and [4.n]naphthalenophane skeletons by using .ALPHA.,.OMEGA.-bis(vinylnaphthyl)alkanes.