J-7 REDUCTION OF CALCULATION TIME IN GEAR SHAVING SIMULATION(Session: Simulation)

スポンサーリンク

概要

• 論文の詳細を見る

• The present paper describes a new method for tooth contact analysis in plunge cut shaving process. A computer simulation program has been developed to reduce trial-and-error pro-cesses that are required to improve of a shaved gear tooth forms. In the simulation, stock removals of shaved gear tooth flanks are evaluated from depth of cut of cutting edge. The depths of cut are calculated at all of referred points on the cal-culating tooth flanks. In order to shorten a calculation time, the depth of cut was calculated only for positions near geo-metrical contact area. As a result, the calculation time is remarkably reduced.

• 一般社団法人日本機械学会の論文
• 2006-11-08

著者

• MORIWAKI Ichiro

  Kyoto Institute of Technology

• Nakada Shimpei

  Mitsubishi Materials Kobe Tools Corporation

関連論文

• Effects of Deposition Conditions on Adhesion of DLC Films Prepared by UBM Sputtering
• PG-05 COMPUTER SIMULATION ON THE HEAT GENERATION IN MESHING OF PLASTIC SPUR GEARS : EFFECT OF MODULE AND GEAR SPEED ON HEAT RADIATION(PLASTIC GEAR TECHNOLOGY)
• GDS-04 Measurement of Contact Stress on Tooth Flank of Spur Gear Subject to Static Load : Comparison of analysis with Tooth Flank Film Element(DESIGN AND SYNTHESIS OF A PAIR OF GEARS OR OF GEAR TRAINS)
• Roll-finishing of Involute Helical Gears in Crossed Axes System : 3 rd Report, Tip Relieving of die-Wheel : Series C : Vibration Control Engineering Engineering for Industry
• On Tooth form Accuracy of Roll-finished Involute Helical Gears : 4th Report, Use of Die-wheel with Longitudinal Tooth from correction (Crowning)
• Roll-finishing of Involute Helical Gears in Crossed Axes System : 2nd Report, Computer Simulation
• Roll-finishing of Involute Helical Gears in crossed Axes System : 1st Report, Fundamental Investigation
• J-8 DEVELOPMENT OF SIMULATION FOR HOT FORGING OF GEARS : Constitutive Equation in Considering Visco-Plasticity(Session: Simulation)
• J-7 REDUCTION OF CALCULATION TIME IN GEAR SHAVING SIMULATION(Session: Simulation)

スポンサーリンク