GDS-04 Measurement of Contact Stress on Tooth Flank of Spur Gear Subject to Static Load : Comparison of analysis with Tooth Flank Film Element(DESIGN AND SYNTHESIS OF A PAIR OF GEARS OR OF GEAR TRAINS)
スポンサーリンク
概要
- 論文の詳細を見る
Contact stress between meshing gear tooth flanks is one of the most important factors for the load capacity evaluation of a gear pair. A gear design system was developed using Tooth Flank Film Elements (TFFEs). The TFFEs enable boundary conditions for a contact problem in meshing teeth to be easily dealt with. In order to confirm the reliability of the gear design system, contact stresses between meshing gear flanks of spur gear pair subject to a static load were measured using pressure measurement film, and were compared with calculated ones. In the present paper, contact stresses of a gear pair with some parallel and crossed misalignments were measured, and were com-pared with calculated ones. As a result, even for a gear pair with some parallel misalignments, the Tooth Flank Film Elements can work well, and can yield reasonable contact stresses.
- 一般社団法人日本機械学会の論文
- 2009-05-13
著者
-
NAKAMURA Morimasa
Kyoto Institute of Technology
-
MORIWAKI Ichiro
Kyoto Institute of Technology
-
Ueda Akio
Amtec Inc.
-
HASHIMOTO Tatsuya
Graduate School of KIT
-
HIRATA Natsuki
Graduate School of KIT
関連論文
- Effects of Deposition Conditions on Adhesion of DLC Films Prepared by UBM Sputtering
- PG-05 COMPUTER SIMULATION ON THE HEAT GENERATION IN MESHING OF PLASTIC SPUR GEARS : EFFECT OF MODULE AND GEAR SPEED ON HEAT RADIATION(PLASTIC GEAR TECHNOLOGY)
- GDS-04 Measurement of Contact Stress on Tooth Flank of Spur Gear Subject to Static Load : Comparison of analysis with Tooth Flank Film Element(DESIGN AND SYNTHESIS OF A PAIR OF GEARS OR OF GEAR TRAINS)
- Roll-finishing of Involute Helical Gears in Crossed Axes System : 3 rd Report, Tip Relieving of die-Wheel : Series C : Vibration Control Engineering Engineering for Industry
- On Tooth form Accuracy of Roll-finished Involute Helical Gears : 4th Report, Use of Die-wheel with Longitudinal Tooth from correction (Crowning)
- Roll-finishing of Involute Helical Gears in Crossed Axes System : 2nd Report, Computer Simulation
- Roll-finishing of Involute Helical Gears in crossed Axes System : 1st Report, Fundamental Investigation
- J-8 DEVELOPMENT OF SIMULATION FOR HOT FORGING OF GEARS : Constitutive Equation in Considering Visco-Plasticity(Session: Simulation)
- J-7 REDUCTION OF CALCULATION TIME IN GEAR SHAVING SIMULATION(Session: Simulation)
- IP-B3 TOOTH FORM ANALYSIS SIMULATION OF THE WORM GEARS : THE UTILIZATION OF THE SOFTWARE FOR GETTING PROPER MESHING(PAPERS FOR INDUSTRIAL PANELS)