ドライ切削の被削性及び経済性評価 : 第2報, 中炭素鋼と合金工具鋼のエンドミル及びドリル加工

概要

論文の詳細を見る
This paper deals with the elimination of water-based cutting fluid based on machinability tests and economical considerations when plain medium carbon steels and an alloy steel are machined with a coated carbide end mill or a carbide drill. In end milling, no remarkable difference between dry and wet machining is recognized in terms of chip disposability, machining accuracy, cutting force, tool life and production cost. Besides, dry machining yields a low production cost at low cutting speeds of less than 90 m/min for S 45 C steel and 20 m/min for SKD 61. In drilling, dry machining is not as good as wet machining with respect to machinability, but the cost analysis shows that dry machining is preferable at low cutting feeds of less than 200 mm/min for S 50 C steel. From an environmental point of view we should take a positive attitude to introduce dry machining as far as its advantages on machinability and economics are recognized.
一般社団法人日本機械学会の論文
2001-09-25