Adaptive Circuits for the 0.5-V Nanoscale CMOS Era
スポンサーリンク
概要
- 論文の詳細を見る
The minimum operating voltage, Vmin, of nanoscale CMOS LSIs is investigated to breach the 1-V wall that we are facing in the 65-nm device generation, and open the door to the below 0.5-V era. A new method using speed variation is proposed to evaluate Vmin. It shows that Vmin is very sensitive to the lowest necessary threshold voltage, Vt0, of MOSFETs and to threshold-voltage variations, ΔVt, which become more significant with device scaling. There is thus a need for low-Vt0 circuits and ΔVt-immune MOSFETs to reduce Vmin. For memory-rich LSIs, the SRAM block is particularly problematic because it has the highest Vmin. Various techniques are thus proposed to reduce the Vmin: using RAM repair, shortening the data line, up-sizing, and using more relaxed MOSFET scaling. To effectively reduce Vmin of other circuit blocks, dual-Vt0 and dual-VDD circuits using gate-source reverse biasing, temporary activation, and series connection of another small low-Vt0 MOSFET are proposed. They are dynamic logic circuits enabling the power-delay product of the conventional static CMOS inverter to be reduced to 0.09 at a 0.2-V supply, and a DRAM dynamic sense amplifier and power switches operable at below 0.5V. In addition, a fully-depleted structure (FD-SOI) and fin-type structure (FinFET) for Vt-immune MOSFETs are discussed in terms of their low-voltage potential and challenges. As a result, the height up-scalable FinFETs turns out to be quite effective to reduce Vmin to less than 0.5V, if combined with the low-Vt0 circuits. For mixed-signal LSIs, investigation of low-voltage potential of analog circuits, especially for comparators and operational amplifiers, reveals that simple inverter op-amps, in which the low gain and nonlinearity are compensated for by digitally assisted analog designs, are crucial to 0.5-V operations. Finally, it is emphasized that the development of relevant devices and fabrication processes is the key to the achievement of 0.5-V nanoscale LSIs.
- 2010-03-01
著者
-
OSHIMA Takashi
Central Research Laboratory, Hitachi Ltd.
-
YAMAOKA Masanao
Central Research Laboratory, Hitachi, Ltd.
-
ITOH Kiyoo
Central Research Laboratory, Hitachi, Ltd.
-
Itoh Kiyoo
Central Research Lab. Hitachi Ltd.
-
Yamaoka Masanao
Central Research Laboratory Hitachi Ltd.
-
Oshima Takashi
Central Research Laboratory Hitachi Ltd.
-
OSHIMA Takashi
Central Research Laboratory, Hitachi, Ltd.
関連論文
- A Dual-Mode Bluetooth Transceiver with a Two-Point-Modulated Polar-Loop Transmitter and a Frequency-Offset-Compensated Receiver(Circuit Theory)
- A 4500 MIPS/W, 86μA Resume-Standby, 11μA Ultra-Standby Application Processor for 3G Cellular Phones(Digital, Low-Power LSI and Low-Power IP)
- Adaptive Circuits for the 0.5-V Nanoscale CMOS Era
- Long-Retention-Time, High-Speed DRAM Array with 12-F^2 Twin Cell for Sub 1-V Operation(Memory,Low-Power, High-Speed LSIs and Related Technologies)
- FOREWORD (Special Issue on ULSI Memory Technology)
- Sub 1V Swing Internal Bus Architecture for Future Low-Power ULSI's (Special Section on the 1992 VLSI Circuits Symposium)
- The Advantages of a DRAM-Based Digital Architecture for Low-Power, Large-Scale Neuro-Chips
- A Low-Vt Small-Offset Gated-Preamplifier for Sub-1-V DRAM Mid-Point Sensing
- 0.5-V 25-nm 6-T Cell with Boosted Word Voltage for 1-Gb SRAMs
- A Low-V_t Small-Offset Gated-Preamplifier for Sub-1-V DRAM Mid-Point Sensing
- Small-Sized Leakage-Controlled Gated Sense Amplifier for 0.5-V Multi-Gigabit DRAM Arrays