Steam Oxidation Studies on 50Ni-50Cr HVOF Coatings on 9Cr-1Mo Steel : Change in Structure and Morphology across the Coating/Substrate Interface
スポンサーリンク
概要
- 論文の詳細を見る
- Japan Institute of Metalsの論文
- 2004-04-20
著者
-
Abe F
National Institute For Materials Science
-
ABE Fujio
National Institute for Materials Science
-
Abe F
Steel Research Center National Institute For Materials Seienee
-
Abe Fujio
National Institute Of Materials Science
-
Abe Fujio
Frontier Research Center For Structural Materials National Research Institute For Metals
-
Abe Fujio
Steel Research Center (src) National Institute For Materials Science
-
Kuroda S
Steel Research Center National Institute For Materials Science
-
Kuroda Seiji
National Inst. Materials Sci.
-
Kuroda Seiji
National Institute For Materials Science
-
Sundararajan Thiyagarajan
National Institute For Materials Science
-
Abe Fujio
Structural Metals Center National Institute For Materials Science
-
Kuroda Seiji
Hybrid Materials Center National Institute For Materials Science
-
Kuroda Seiji
Department Of Instrumentation Engineering Faculty Of Science And Techonology Keio University
-
Kuroda Seiji
Advanced Materials Processing Division National Research Institute For Metals
-
Abe Fujio
Steel Research Center National Institute For Materials Science
-
Abe Fujio
Tsukuba Laboratories National Research Institute For Metals
-
Kuroda Seiji
Composites & Coatings Center National Inst. For Materials Sci.
-
Kuroda Seiji
Composites & Coatings Center National Institute For Materials Science
-
Kuroda Seiji
Thermal Spray Group Materials Engineering Laboratory National Institute For Materials Science (nims)
-
Kuroda Seiji
Coating Materials Group Composites And Coatings Center National Institute For Materials Science
-
Seiji Kuroda
National Institute For Materials Science
関連論文
- Comparison of microstructures of warm sprayed and cold sprayed titanium coatings and powder particles
- Creep Fracture Analysis of W Strengthened High Cr Steel Weldment
- Effects of Zr Addition on the Microstructure of 14%Cr4%Al ODS Ferritic Steels
- Coating Fabrication of Nano-Sized Oxides/Metal Composite by Warm Spray and its Photo-Cathodic Protection Behaviour
- SB-07-2(070) Assessment of Material Degradation Based on Microstructural Evolution in Type 304H Stainless Steel During Long-Term Creep(Changes in Microstructure 2)
- Effects of Ni and Heat Treatment on Long-term Creep Strength of Precipitation Strengthened 15Cr Ferritic Heat Resistant Steels
- Influence of Chemical Composition and Heat Treatment Condition on Impact Toughness of 15Cr Ferritic Creep Resistant Steel
- Improvement in Creep Strength of Precipitation Strengthened 15Cr Ferritic Steel by Controlling Carbon and Nitrogen Contents
- Effects of W and Co on Long-term Creep Strength of Precipitation Strengthened 15Cr Ferritic Heat Resistant Steels
- D311 IMPROVEMENT IN CREEP STRENGTH OF PRECIPITATION STRENGTHENED 15CR FERRITIC STEEL BY CONTROLLING OF CARBON AND NITROGEN CONTENTS
- Development of high strength 15Cr creep resistant steel for low emission power plant
- Effects of W and Co on the Microstructure and Creep Strength of the Precipitation Strengthened 15Cr Ferritic Steels(Special Issue on Creep and Fatigue at Elevated Temperatures)
- SB-08-3(037) Effects of W and Co on the Microstructure and Creep Strength of the Precipitation Strengthened 15Cr Ferritic Steels(Advanced Heat Resistant Steels)
- SB-08-2(034) Development of Precipitation Strengthened 15Cr Ferritic Creep Resistant Steel(Advanced Heat Resistant Steels)
- SB-06-4(038) Changes in Precipitates of Modified 9Cr-1Mo Steel During Long-term Creep Deformation at 873K and 923K(Changes in Microstructure 1)
- Development of High Strengh 15Cr Ferritic Creep Resistant Steel with Addition of Tungsten and Cobalt
- Development of High Strength 15Cr Ferritic Creep Resistant Steel
- Fabrication and Mechanical Properties of Composite Structure by Warm Spraying of Zr-Base Metallic Glass
- Effects of Alloying Elements on Creep Properties of 9Cr-3.3W-0.5Pd-V, Nb, N, B Steels
- Microstructural Evaluation of C-free Martensitic Alloys at High Temperatures
- OS0805 残留応力の耐熱コーティング材の非線形挙動に及ぼす影響(ガスタービン材料の各種力学特性,オーガナイズドセッション)
- Effect of Hf Addition on Oxidation Properties of Pt-Ir Modified Aluminide Coating
- Role of Iridium in Hot Corrosion Resistance of Pt-Ir Modified Aluminide Coatings with Na_2SO_4-NaCl Salt at 1173K
- Multi-scale Phenomena and Structures Observed in Fabrication of Thermal Barrier Coatings by Using Plasma Spraying
- Behaviour of Mn and Si in the Spray Powders during Steam Oxidation of Ni-Cr Thermal Spray Coatings
- REMAINING LIFE PREDICTION BY THE ISO-STRESS METHOD OF BOILER TUBES AFTER PROLONGED SERVICE
- Measurement of Temperature and Velocity of Thermally Sprayed Particles using Thermal Radiation
- Degradation of Creep Strength in Welded Joint of 9%Cr Steel
- Effect of Feedstock Particles' Strength on the Structure and Some Mechanical Properties of Warm-Sprayed WC-Co Coatings
- Hydrogen Entry in Crevice Region : Evaluation by Hydrogen Permeation Technique
- Simulation of Solid Particle Impact Behavior for Spray Processes
- Effect of Pyrocarbon Pre-Coating on the Mechanical Properties of CVI Carbon Fiber/Sic Composites
- Crack Monitoring during Plasma Spraying of Ceramic Coatings by Non-Contact Acoustic Emission Method
- Influence of Heat Treatment on Formation Behavior of Boron Nitride Inclusions in P122 Heat Resistant Steel
- Characterization of Mechanically Alloyed Powders for High-Cr Oxide Dispersion Strengthened Ferritic Steel
- SB-06-3(057) Change in Tensile and Creep Properties of 2.25Cr-1Mo Steel by Prolonged Exposure in Plant(Changes in Microstructure 1)
- Prediction of Precipitation Sequences within Grains in 18Cr-8Ni Austenitic Steel by Using System Free Energy Method
- Creep Deformation and the Corresponding Microstructural Evolution in High-Cr Ferritic Steels
- Creep Deformation and the Corresponding Microstructural Evolution in High-Cr Ferritic Steels
- Creep properties affected by morphology of MX in high-Cr ferritic steels
- Effect of Co Addition on Microstructure in High Cr Ferritic Steels
- Effect of Heat Treatment on Precipitation Kinetics in High-Cr Ferritic Steels
- SB-09-1(051) An Improvement on Creep Characteristics in Carbon Free Martensitic Alloys(Advanced Heat Resistant Steels)
- Creep Properties affected by Morphology of MX in High-Cr Ferritic Steels
- Improved Utilization of Added B in 9Cr Heat-Resistant Steels Containing W
- Improved Utilization of Added B in 9Cr Heat-Resistant Steels Containing W
- Importance of the Adhesion of HVOF Sprayed Coatings for Aqueous Corrosion Resistance
- Steam Oxidation Studies on 50Ni-50Cr HVOF Coatings on 9Cr-1Mo Steel : Change in Structure and Morphology across the Coating/Substrate Interface
- Characterization of Electroplated Platinum-Iridium Alloys on the Nickel-Base Single Crystal Superalloy
- Observation of High Resolution Microstructures in Thermal Sprayed Coatings and Single Deposited Splats Using Ion Beam Milling
- Effects of Silicon and Boron on Oxidation Behavior of Air Plasma Sprayed Fe-based alloy Coatings
- Gas Contamination due to Milling Atmospheres of Mechanical Alloying and Its Effect on Impact Strength
- In-Situ Densification of Ti Coatings by the Warm Spray (Two-Stage HVOF) Process
- Corrosion Resistance of HastelloyC Coatings Formed by an Improved HVOF Thermal Spraying Process
- Microstructure and Corrosion Resistance of HVOF Sprayed 316L Stainless Steel and Hastelloy C Coatings
- Steam Oxidation Resistance of Ni-Cr Thermal Spray Coatings on 9Cr-1Mo Steel. Part 2 : 50Ni-50Cr
- Steam Oxidation Resistance of Ni-Cr Thermal Spray Coatings on 9Cr-1Mo Steel. Part 1 : 80Ni-20Cr
- Effect of Nitrogen Content on Microstructural Aspects and Creep Behavior in Extremely low Carbon 9Cr Heat-resistant Steel
- Comparison of Microstructure and Oxidation Behavior of CoNiCrAlY Bond Coatings Prepared by Different Thermal Spray Processes
- Effect of Spray Condition and Heat Treatment on the Structure and Adhesive Wear Properties of WC Cermet Coatings
- Oxidation Restriction of In-flight Particles upon GS-HVOF Spraying by Nitrogen Addition to Combustion Gas
- Thermal Cycling Behavior of Plasma Sprayed Segmented Thermal Barrier Coatings
- Effects of Heat Treatment on Microstructures and Physical Properties of Segmented Thermal Barrier Coatings
- Microstructural Investigation of CoNiCrAlY Coated Ni-Based Single Crystal Superalloy Prepared by LPPS
- Torsion and Tensile Properties of Thin Wires of Nickel-Free Stainless Steel with Nitrogen Absorption Treatment
- Mechanical Properties of Thin Wires of Nickel-Free Austenintic Stainless Steel with Nitrogen Absorption Treatment
- Mechanical Properties and Microstructures of a Thin Plate of Nickel-Free Stainless Steel with Nitrogen Absorption Treatment
- New Manufacturing Process of Nickel-Free Austenitic Stainless Steel with Nitrogen Absorption Treatment
- Effects of Corona Discharge on the Formation of Electrically-Extracted Liquid Jets
- Effect of Surface Treatment and Crystal Orientation on Microstructural Changes in Aluminized Ni-Based Single-Crystal Superalloy
- Development of Reduced-Activation Martensitic 9Cr Steels for Fusion Reactor
- Kinetics of Carbide Precipitation during Creep and Its Effect on Creep Rate of 10Cr-30Mn Austenitic Steels (Special Issue on Current Topics in Diffusional Phase Transformations)
- Precipitation of Carbides and Alpha-Tungsten in Ni-Cr-W Superalloys at 1,000℃
- Detection of AE Events due to Cracks in TBC during Spraying Process
- Growth Mechanism of Polypyrrole through Electrochemical Polymerization
- Impurities and Evaluation of Induced Activity of SiC Composites Prepared with Chemical Vapor Infiltration.