Impurities and Evaluation of Induced Activity of SiC Composites Prepared with Chemical Vapor Infiltration.
スポンサーリンク
概要
- 論文の詳細を見る
Carbon fiber reinforced SiC (C/SiC) and SiC fiber reinforced SiC (SiC/SiC) composites were fabricated by a chemical vapor infiltration (CVI) method to obtain the composites with minimized impurity contamination. The neutron activation analysis showed that 30 elements were detected as impurities. However total impurity concentrations in the C/SiC and SiC/SiC were lower than 14.5 wt ppm and 9.80 wt ppm, respectively.<BR>The evaluation of induced activity under the simulation of fusion neutron irradiation of 10 MW•y/m<SUP>2</SUP> was made based on the impurity concentration. The dose rates of both composites were assumed to decrease by about 6 orders of magnitude in one day cooling and by 9 orders of magnitude in several ten years. The results indicate that the present composites behave excellent in terms of low activation and the CVI is a potential process to obtain high-purity composites.
- 一般社団法人 日本原子力学会の論文
著者
-
ABE Fujio
National Institute for Materials Science
-
ARAKI Hiroshi
National Institute for Materials Science
-
SUZUKI Hiroshi
National Research Center for Profozoan Diseases, Obihiro University of Agriculture and Veterinary Me
-
Noda Tetsuji
National Inst. For Materials Sci. Tsukuba Jpn
-
OKADA Masatoshi
National Research Institute for Metals
-
ABE Fujio
National Research Institute for Metals, Tsukuba Laboratories
関連論文
- Creep Fracture Analysis of W Strengthened High Cr Steel Weldment
- Effects of Zr Addition on the Microstructure of 14%Cr4%Al ODS Ferritic Steels
- In Situ Studies on X-Ray Diffraction and Resistance of Graphitelike Film during the First Redox Cycle and the Effect of 12 Crown 4
- In Situ Measurements of Drastic Change of Electrical Conductivity and Structure upon Electrochemical Lithium Intercalation in Pyrolyzed Poly(hydrazocarbonyl-1-4-phenylenecarbonyl) Film
- Effects of Ni and Heat Treatment on Long-term Creep Strength of Precipitation Strengthened 15Cr Ferritic Heat Resistant Steels
- Influence of Chemical Composition and Heat Treatment Condition on Impact Toughness of 15Cr Ferritic Creep Resistant Steel
- Improvement in Creep Strength of Precipitation Strengthened 15Cr Ferritic Steel by Controlling Carbon and Nitrogen Contents
- Effects of W and Co on Long-term Creep Strength of Precipitation Strengthened 15Cr Ferritic Heat Resistant Steels
- D311 IMPROVEMENT IN CREEP STRENGTH OF PRECIPITATION STRENGTHENED 15CR FERRITIC STEEL BY CONTROLLING OF CARBON AND NITROGEN CONTENTS
- Development of high strength 15Cr creep resistant steel for low emission power plant
- SB-08-3(037) Effects of W and Co on the Microstructure and Creep Strength of the Precipitation Strengthened 15Cr Ferritic Steels(Advanced Heat Resistant Steels)
- SB-08-2(034) Development of Precipitation Strengthened 15Cr Ferritic Creep Resistant Steel(Advanced Heat Resistant Steels)
- Ferromagnetic Tendency of TDAE-Fullerene-Conducting Polymer System
- Superconductivity in Conducting Polymer/Fullerence Composite Doped by Alkali Metal
- Anomalous Ferromagnetic and Antiferromagnetic Properties of Polyaniline Derivatives Depending on Acidic Treatment
- Hi-Nicalon^ Fiber-Reinforced CVI-SiC Matrix Composites : I Effects of PyC and PyC-SiC Multilayers on the Fracture Behaviors and Flexural Properties
- Macrophage Scavenger Receptor(SR-A I/ll) Deficiency Reduced Diet-induced Atherosclerosis in C57BL/6J Mice
- Measurements of Absolute Cross Sections for Electron-Impact Ionization of Doubly Charged Rare Gas Ions:Ne^,Ar^,Kr^,andXe^
- Flexural Strength of a Plain-Woven Tyranno-SA Fiber-Reinforced SiC Matrix Composite
- Hi-Nicalon^ Fiber-Reinforced CVI-SiC Matrix Composites : II Interfacial Shear Strength and Its Effects on the Flexural Properties
- Effects of Alloying Elements on Creep Properties of 9Cr-3.3W-0.5Pd-V, Nb, N, B Steels
- Microstructural Evaluation of C-free Martensitic Alloys at High Temperatures
- Isotopic Effect on Thermal Physical Properties of Isotopically Modified Boron Single Crystals
- Thermal Conductivity of Isotopically Enriched β-Rhombohedral Boron
- Behaviour of Mn and Si in the Spray Powders during Steam Oxidation of Ni-Cr Thermal Spray Coatings
- Preparation of Quinoline Hexose Analogs as Novel Chloroquine-Resistant Malaria Treatments (1). Synthesis of 4-Hydroxyquinoline-β-glucosides
- Formation of Silicon Nanowires by CVD Using Gold Catalysts at Low Temperatures
- Isotopic Effect on Thermal Conductivity of Diamond Thin Films
- TEM Observation of Interfaces between Particles in Al-Mg Alloy Powder Compacts Prepared by Pulse Electric Current Sintering
- 625 Effect of Magnesium on Properties of Aluminum-Magnesium Alloy Powder Compacts by Spark Plasma Sintering
- Effect of Interface Behavior between Particles on Properties of Pure Al Powder Compacts by Spark Plasma Sintering
- High-resolution electron microscopy study of defect structures in γ-TiAl irradiated with 15 keV He ions in a high-voltage transmission electron microscope
- Influence of Silicon Dioxide Doping on Morphology of Silicon Nanowires Grown by Floating Zone Method
- Delayed growth of EL4 lymphoma in SR-A-deficient mice is due to upregulation of nitric oxide and interferon-γ production by tumor-associated macrophages
- In Situ Growth of Isotopically Enriched ^Si Nanowires Using the Floating-Zone(FZ) Melting Method : Semiconductors
- Effect of Pyrocarbon Pre-Coating on the Mechanical Properties of CVI Carbon Fiber/Sic Composites
- Effect of Incident Direction of ArF Laser to Graphite Substrates on the Formation of Photo-Chemical Vapor Depositiom SiC Film
- Influence of Heat Treatment on Formation Behavior of Boron Nitride Inclusions in P122 Heat Resistant Steel
- Characterization of Mechanically Alloyed Powders for High-Cr Oxide Dispersion Strengthened Ferritic Steel
- Prediction of Precipitation Sequences within Grains in 18Cr-8Ni Austenitic Steel by Using System Free Energy Method
- Effect of Co Addition on Microstructure in High Cr Ferritic Steels
- Effect of Heat Treatment on Precipitation Kinetics in High-Cr Ferritic Steels
- Creep Properties affected by Morphology of MX in High-Cr Ferritic Steels
- Improved Utilization of Added B in 9Cr Heat-Resistant Steels Containing W
- Evaluation of Structure and Gas Response in Porphyrin Langmuir-Blodgett Films by Attenuated Total Reflection Measurements
- Evaluation of Structure and Gas Response in Porphyrin Langmuir-Blodgett Films by Attenuated Total Reflection Measurements
- Effects of Substrate Materials on Growth of Carbon Nanotubes by Chemical Vapor Deposition Using Metal-Phthalocyanines
- Growth of Carbon Nanotubes on Quartz Plates by Chemical Vapor Deposition Using (Ni, Fe)- Phthalocyanines
- Photoluminescence of ZnS_Se_x:Te Prepared by Solution Growth Using Sb-Chalcogenides as Solvent
- Steam Oxidation Studies on 50Ni-50Cr HVOF Coatings on 9Cr-1Mo Steel : Change in Structure and Morphology across the Coating/Substrate Interface
- Impairment in S-phase entry of splenocytes of Parp-1 knockout mice
- Gas Contamination due to Milling Atmospheres of Mechanical Alloying and Its Effect on Impact Strength
- Expression Patterns of the Implantation-associated Genes in the Uterus during the Estrous Cycle in Mice
- Steam Oxidation Resistance of Ni-Cr Thermal Spray Coatings on 9Cr-1Mo Steel. Part 2 : 50Ni-50Cr
- Steam Oxidation Resistance of Ni-Cr Thermal Spray Coatings on 9Cr-1Mo Steel. Part 1 : 80Ni-20Cr
- Circuit and System for Quantum Functional Devices
- Effect of Nitrogen Content on Microstructural Aspects and Creep Behavior in Extremely low Carbon 9Cr Heat-resistant Steel
- マウスの発情周期における着床関連遺伝子の発現について
- Comparison of Macrophage Scavenger Receptor-A Knockout Mice with Wild Type Ones in the Immune Response against Repeated Infestation with Haemaphysalis longicornis
- Behavior of Oxide Film at Interface between Particles of Al-Mg Alloy Powder Compacts Prepared by Pulse Electric Current Sintering
- Corrosion behaviors of iron-base alloy, nickel-base alloy and refractory metal alloys in high-temperature impure helium gas.
- Impurities and Evaluation of Induced Activity of SiC Composites Prepared with Chemical Vapor Infiltration.