FORMATION OF CALCIUM-ALGINATE GEL COATING ON BIOCATALYST IMMOBILIZATION CARRIER
スポンサーリンク
概要
- 論文の詳細を見る
Biocatalyst immobilization carrier was coated with calcium alginate gel by a two-step preparation procedure for prevention of leakage of the biocatalyst from the carrier. A uniform gel coating film could be formed around not only calcium alginate get beads but also chitosan beads. The thickness of calcium alginate gel coating increased with decreasing sodium alginate concentration and stirring rate, and with increasing concentration of calcium ion and diameter of the core bead. The volume of gel coating film was shown to be proportional to the mass of calcium ion initially contained in the core bead. It was also found that the thickness of gel coating film could be controlled by adjusting the calcium concentration in the core bead.
- 社団法人 化学工学会の論文
- 1992-12-01
著者
-
YAMAGIWA KAZUAKI
Department of Chemistry and Chemical Engineering, Niigata University
-
Yamagiwa K
Niigata Univ. Niigata Jpn
-
Yamagiwa Kazuaki
Department Of Chemical Engineering Faculty Of Engineering Niigata University
-
ONODERA Masayuki
Department of Applied Chemistry and Biotechnology, Niigata Institute of Technology
-
KOZAWA Taro
Department of Chemistry and Chemical Engineering, Niigata university
-
Kozawa Taro
Graduate School Of Science And Technology Department Of Chemistry And Chemical Engineering Niigata U
-
Ohkawa A
Niigata Univ. Niigata Jpn
-
Ohkawa Akira
Department Of Chemistry And Chemical Engineering Niigata University
-
Ohkawa Akira
Department Of Chemical Engineering Faculty Of Engineering Niigata University
-
Ohkawa A
Department Of Chemistry And Chemical Engineering Niigata University
-
Ohkawa Akira
Department Of Chemistry And Chemical Engineering Faculty Of Engineering Niigata University
-
Onodera Masayuki
Department Of Biosystem Science Graduate School Of Science And Technology Niigata University
-
Onodera Masayuki
Faculty Of Engineering Niigata Institute Of Technology
-
Onodera Masayuki
Department Of Agricultural Chemistry Faculty Of Agriculture Niigata Unirersity
-
SHIMIZU Yukari
Department of Material and Chemical Engineering, Graduate School of Natural Science and Technology,
-
Shimizu Yukari
Department Of Material And Chemical Engineering Graduate School Of Natural Science And Technology Ni
関連論文
- Simultaneous Reduction of No_x, N_2O, SO_2 Emissions from a Fluidized Bed Coal Combustor Using Alternative Bed Material
- Enhancement of Gas-Liquid Mass Transfer with Unsteadily Forward-Reverse Rotating Multiple Delta Blade Impellers in an Unbaffled Agitated Vessel
- Movement of Solid Particles on and off Bottom of an Unbaffled Vessel Agitated by Unsteadily Forward-Reverse Rotating Impeller
- Foam Breaking Characteristics of a Mechanical Foam-Breaker Using Shear Force Fitted to a Stirred-Tank Reactor
- Performance Characteristics of a Stirred-Tank Reactor with a Mechanical Foam-Breaker Utilizing Shear Force
- Nitrification Performance of Membrane-Attached Nitrifying Biofilm
- Photo-Crosslinked Copolymer Gel as an Adsorbent for Temperature-Swing Adsorption Process
- Effect of Perforated Plate on Concentration of Poly(vinyl Alcohol) by Foam Fractionation with External Reflux
- Temperature-Swing Column Adsorption of Nonionic Surfactant with Poly(vinylmethylether) Gel
- Temperature-Swing Adsorption of Nonionic Surfactant with Photo-Crosslinked Polymeric Gel
- Disinfection Kinetics of Legionella pneumophila by Hydrogen Peroxide
- Effects of Liquid Property on Air Entrainment and Oxygen Transfer Rates of a Plunging Jet Reactor
- Effect of Salt on Temperature-Swing Adsorption of Nonionic Surfactant with Poly(Vinylmethyl Ether) Gel
- Effect of External Reflux on Foam Fractionation of Poly(Vinyl Alcohol)
- Maximum Penetration Depth of Air Bubbles Entrained by Vertical Liquid Jet
- Effect of Nozzle Contraction Angle on Air Entrainment Rate of a Vertical Plunging Liquid Jet
- PREPARATION OF IMMOBILIZATION MATRIX WITH LOW OXYGEN PERMEABILITY AND ITS APPLICATION TO BIOLOGICAL DENITRIFICATION
- SIMULTANEOUS REMOVAL OF ORGANIC CARBON AND NITROGEN BY A PLUNGING LIQUID JET BIOREACTOR WITH CROSSFLOW FILTRATION OPERATED UNDER ZONE-LIMITED AERATION
- ADSORPTION OF TRITON X-100, TRYPTOPHAN AND BSA ON TEMPERATURE-SENSITIVE POLY(VINYLMETHYLETHER)GEL
- EFFECTS OF ALGINATE COMPOSITION AND GELLING CONDITIONS ON DIFFUSIONAL AND MECHANICAL PROPERTIES OF CALCIUM-ALGINATE GEL BEADS
- RELATIONSHIP BETWEEN MANNURONIC TO GULURONIC ACID RATIO OF ALGINATE AND CHARGE DENSITY OF Ca-ALGINATE COMPLEX
- SIMULTANEOUS ORGANIC CARBON REMOVAL AND NITRIFICATION BY BIOFILM FORMED ON OXYGEN ENRICHMENT MEMBRANE
- ADSORPTION OF HYDROPHOBIC NONIONIC SURFACTANT ON POLY (VINYLMETHYLETHER) GEL
- Production of α-Amylase by Immobilized Cells of Aspergillus oryzae in a Bubble Column Bioreactor
- Relationship between the Foam-breaking Performance and the Hydraulic Behavior of Liquid Dispersed from Mechanical Foam-breakers : Studies on the Mechanical Control of Fermentation Foams (V)
- Performance Evaluation of Mechanical Foam-breakers Utilizing the Impact Force of Dispersed Liquid Particles : Studies on the Mechanical Control of Fermentation Foams (IV)
- Some Characteristics of a Double-column Gas-liquid Contactor with Gas Entrainment and Its Application to an Aerator for Activated Sludge Treatment : Development of the Double-column Gas-liquid Contactor with a Gas Entrainment Process and Its Application t
- Some Factors Affecting the Performance of a Mechanical Foam-breaker with a Rotating Disk
- The Performance of a Mechanical Foam Breaker witha Rotaing Disk
- Production of Amylase by immobilized Aspergillus oryzae in an anaerobic vessel
- New Tuning Method for IMC Controller
- EFFECT OF LIQUID PROPERTY ON GAS ENTRAINMENT BEHAVIOR IN A PLUNGING LIQUID JET AERATION SYSTEM USING INCLINED NOZZLES
- Removal of Trichloroethylene from Water by Aeration, Pervaporation and Membrane Distillation
- PERFORMANCE CHARACTERISTICS OF NOZZLE FOAM-BREAKERS FITTED TO TOWER AERATOR
- Foaming in an Aerated Stirred Tank and Its Mechanical Control
- A Technique for Measuring Gas Holdup in a Downflow Bubble Column with Gas Entrainment by a Liquid Jet
- Recovery of Hexavalent Chromium Ion from Methanol with Ion Exchange Resin
- Effect of Liquid Disintegration Pattern from the Disk on the Performance of a Mechanical Foam-Breaker with a Rotating Disk
- Effect of Disk Diameter on the Foam-Breaking Capacity of a Mechanical Foam-Breaker with a Rotation Disk
- Elution Phenomena of Acidic Ions from Granular Snow and Spherical Ice
- Behavior of Impurities during the Formation of an Ice Sphere
- Separation of Aromatic Hydrocarbons from Gasoline Vapor by Vapor Permeation through Triethylene Glycol Liquid Membrane
- Separation of Benzene/Cyclohexane by Vapor Permeation through Triethylene Glycol Liquid Membrane
- The expression of matrix metalloproteinase-13 is increased in vessels with blood-brain barrier impairment in a stroke-prone hypertensive model
- Effects of Antifoam Agents on Cultivation of Baker's Yeast
- Accumulation of S-2-Hydroxyethyl Derivatives of L-Cysteine and L-Homocysteine by a Methionine Auxotroph of Escherichia coli with the Addition of 2-Mercaptoethanol to the Culture(MICROBIAL PHYSIOLOGY AND BIOTECHNOLOGY)
- Accumulation of _L-Cystathionine by an Escherichia coli Mutant Deficient in Cystathionine Beta-Lyase
- EFFECT OF CELL LOADING ON ENCAPSULATION OF IMMOBILIZED YEAST BY TWO-STEP PREAPARATION PROCEDURE
- FORMATION OF CALCIUM-ALGINATE GEL COATING ON BIOCATALYST IMMOBILIZATION CARRIER
- Relation between Critical Disk Speed for Foam-Breaking of Rotating-Disk Mechanical Foam-Breakers and Foaming Characteristics of Solutions
- Relation between Mechanical Foam-Breaking Difficulty and the Forming Characterisitcs of Solutions
- MEMBRANE FOULING IN ULTRAFILTRATION OF HYDROPHOBIC NONIONIC SURFACTANT
- EFFECT OF ANTIFOAM FOULING ON SOLUTE REJECTION BY ULTRAFILTRATION MEMBRANE
- Oxidation of Short-chain iso-Alkanes by Gaseous Hydrocarbon Assimilating Mold, Scedosporium sp. A-4(Microbiology & Fermentation Industry)
- Oxidation of Gaseous Hydrocarbons by a Gaseous Hydrocarbon Assimilating Mold, Scedospovium sp. A-4(Microbiology & Fermentation Industry)
- Utilization of Short-chain Hydrocarbons and Accumulation of Methylketones by a Gaseous Hydrocarbon Assimilating Mold, Scedosporium sp. A-4(Microbiology & Fermentation Industry)
- Oxidation of Secondary Alcohols to Methylketones by a Gaseous Hydrocarbon Assimilating Mold, Scedosporium sp. A-4(Microbiology & Fermentation Industry)
- Oxidation of n-Pentane by a Gaseous Hydrocarbon Assimilating Mold, Scedosporium sp. A-4(Microbiology & Fermentation Industry)
- Effects of Antifoam with Inverted Cloud Point on Permeation and Solute Rejection in Membrane Filtration Process
- Sterol Biosynthesis by a Prokaryote : First in Vitro Identification of the Genes Encoding Squalene Epoxidase and Lanosterol Synthase from Methylococcus capsulatus
- Propane Oxidation Activity and Its Induction in a Gaseous Hydrocarbon Assimilating Mold, Scedosporium sp. A-4(Microbiology & Fermentation Industry)
- Medulloblastoma with myogenic differentiation showing double immunopositivity for synaptophysin and myoglobin
- Effect of Ultrasonication on Excess Sludge Bioavailability for Methane Production
- Plasma B-Type Natriuretic Peptide Is Useful for Cardiovascular Risk Assessment in Community-Based Diabetes Subjects
- Gas holdup and gas entrainment rate in downflow bubble column with gas entrainment by a liquid jet operating at high liquid throughput.
- Operational Characteristics of Aerated Agitated Vessels under Mechanical Foam Control
- Foam ratio as a measure for mechanical foam-breaking in gas bubbling systems.
- Gas entrainment rate and flow pattern in a plunging liquid jet aeration system using inclined nozzles.
- Dynamic formation of polyion and polyion complex membranes, and their solute rejection.
- Electrochemical activity of fluidized bed electrodes (FBEs) inserted electro-conductive partition plates.
- Gas holdup in downflow bubble columns with gas entrainment by a liquid jet.
- Flow characteristics of downflow bubble columns with gas entrainment by a liquid jet.
- Power requirement in an aerated agitated vessel under foaming.
- Effect of polyion composition on solute rejection by dynamic polyion complex membranes.
- EFFECT OF NOZZLE LENGTH ON GAS EN-TRAINMENT CHARACTERISTICS OF VERTI-CAL LIQUID JETS