330 BTA深穴加工におけるライフリングマーク発生現象の防止対策に関する検討
スポンサーリンク
概要
- 論文の詳細を見る
BTA deep hole drilling is used for producing holes of high aspect ratio. In this process, a chatter vibration sometimes occurs and a rifling mark is formed on the surface of a hole. The generation mechanism of a rifling mark in BTA deep hole drilling process is considered as a self-excited vibration caused by time delay. In this paper, a countermeasure against a rifling mark using an additional guide pad is proposed. According to the numerical results, it is confirmed that the perfect prevention of a rifling mark is possible by appropriate location of the guide pads.
- 一般社団法人日本機械学会の論文
- 2009-08-03
著者
-
松崎 健一郎
九州大学大学院工学研究院
-
末岡 淳男
九州大学水素エネルギー国際研究センター
-
劉 孝宏
大分大学工学部
-
森田 英俊
佐世保工業高等専門学校
-
松崎 健一郎
九州大
-
森田 英俊
佐世保高専
-
末岡 淳男
九州大学
-
末岡 淳男
九大
-
Sueoka Atsuo
International Res. Center For Hydrogen Energy Kyushu Univ.
-
Sueoka Atsuo
Department Of Mechanical Engineering Science. Kyushu University
-
Sueoka Atsuo
Department Of Mechanical Engineering Faculty Of Engineering Kyushu University
-
松崎 健一郎
九大 大学院工学研究院
-
森田 秀俊
佐世保工業高等専門学校
-
劉 孝宏
大分大 工
-
劉 孝宏
大分大
-
末岡 淳男
九州大
関連論文
- 集中系モデルによる非線形圧力波の解析 : 第3報,急拡大・急縮小要素のモデル化(機械力学,計測,自動制御)
- Nonlinear Analysis of Chatter Phenomena Generated in a Bicycle Disc Brake
- Analytical Investigation on Squeal Phenomena Generated in Bicycle Disc Brakes
- BTA深穴加工におけるライフリングマーク発生現象の防止対策(機械力学,計測,自動制御)
- 機械力学・計測制御
- 集中系モデルによる非線形圧力波の解析 : 第3報, 急拡大・急縮小要素のモデル化
- BTA深穴加工におけるライフリングマーク発生現象に関する基礎的研究(機械力学,計測,自動制御)
- 自転車のトライボロジー
- 摩擦自励振動の発生メカニズムとその対策 (特集欄 振動--古くて新しい技術フロンティア) -- (Theories and Applications)
- 443 摩耗によるパターン形成現象 : 多角形摩耗の成長過程