Characteristics of Electromagnetic Radiation from a Surface Microstrip Line Structure at High Frequency(Session 4 : Signal Transmission)
スポンサーリンク
概要
- 論文の詳細を見る
It has been demonstrated that a common-mode (CM) can dominate an entire radiation up to 1 GHz, despite the fact that a CM current is smaller than a differential-mode (DM) current. In this paper, the characteristics of electromagnetic radiation from a surface microstrip line structure at high frequency (a few gigahertz) are newly studied experimentally and with finite-difference time-domain modeling. Several different configurations are prepared to compare CM to DM component. The results show that the entire radiation up to 1 GHz is related to CM component. The increase in entire radiation at higher frequencies could not be predicted from only the frequency response of CM current. At the higher frequencies, DM component may be more significant relative to the CM component.
- 社団法人電子情報通信学会の論文
- 2004-10-14
著者
-
KAYANO Yoshiki
Department of Electrical and Electronic Engineering, Akita University
-
Tanaka M
Department Of Electronics & Computer Engineering Gifu-university
-
Kayano Yoshiki
Akita Univ. Jpn
-
Kayano Yoshiki
Faculty Of Engineering And Resource Science Akita University
-
INOUE Hiroshi
Faculty of Engineering, Himeji Institute of Technology
-
Tanaka M
Department Of Electrical And Electronic Engineering Akita University
-
Inoue H
Faculty Of Engineering And Resource Science Akita University
-
TANAKA Motoshi
Faculty of Engineering and Resource Science, Akita University
-
Tanaka Motoshi
Faculty Of Engineering And Resource Science Akita University
-
Inoue Hiroshi
Faculty Of Eng. Osaka Univ.
関連論文
- Left Hand Mode Transmission Line Characteristics Made by F-SIR Structure on PCB
- An Equivalent Circuit Model for Predicting EM Radiation from Stripline Structure with a Thin Wire
- An Equivalent Circuit Model for Predicting EM Radiation from Stripline Structure with a Thin Wire
- Physics-Based Equivalent Circuit Model for Predicting EM Radiation from Stripline Structure with One Gapped Reference Plane (Part 2)
- Physics-based equivalent circuit model for predicting EM radiation from stripline structure with one gapped reference plane (part 2) (マイクロ波)
- Physics-based equivalent circuit model for predicting EM radiation from stripline structure with one gapped reference plane (part 2) (環境電磁工学)
- B-4-57 Physics-Based Equivalent Circuit Model for Predicting EM Radiation from Stripline Structure with One Gapped Reference Plane
- A Study on Generation and Break of Bridge at Different Material Contact Pairs
- Prediction of EM Radiation from a PCB Driven by a Connected Feed Cable
- B-4-48 A Study on EM Radiation from Stripline Structure with a Thin Wire
- Computation of Electromagnetic Field Distribution in a Cross-Section of Connector with Contact Failure
- Relationship Between the Liquidus Surface and Structures of Zr-Cu-Al Bulk Amorphous Alloys
- A Measurement of Wave form at Slowly Separating Silver-Based Contacts with Heated Holder
- Circuit-Simulation Model of C_ Changes in Small-Size MOSFETs Due to High Channel-Field Gradients(the IEEE International Conference on SISPAD '02)
- Quantum Effect in Sub-0.1μm MOSFET with Pocket Technologies and Its Relevance for the On-Current Condition
- Current Fluctuation Measurement for Breaking Contact at Transient Period from Bridge to Arc
- A Study on Length and Diameter of Bridge Related with Holder Heat Capacity
- Effect of Heating Value on Contact Diameter at Low Speed Breaking Contact
- A Measurement on Contact Voltage and Shape of Bridge at Low Speed Breaking Contacts
- A Study on Relationship between Opening Velocity and Short-Time Arc for Silver Contact
- The Relationship between Voltage and Duration of Short-Time Arc Generated by Slowly Breaking Silver Contact
- A Study on Heat Analysis for Breaking Contact with Low Velocity (Part 2) : Influence of Holder Structure on Temperature Rise of Electrode (Part 2)(Session 7 -Modeling-)
- Measurement of Current Noise up to GHz from Slowly Breaking AgSnO_2 Contact with External Magnetic Field(Session 3 -Arc Interruption-)
- Current and Radiation Noise up to GHz Band Generated by Slowly Breaking Silver-Compound Contacts(Signal Transmission & Sensing,Recent Development of Electromechanical Devices (Selected Papers from ICEC2006))
- Effect of the Thermal Constant on Temperature Rise of Silver Palladium Alloy Contacts(Contact Phenomena,Recent Development of Electromechanical Devices (Selected Papers from ICEC2006))
- A Study on Separation of Heat Generation and Heat Transfer Related to Temperature Rise of Silver Palladium Contact(Contact Phenomena,Recent Development of Electromechanical Devices (Selected Papers from IS-EMD2005))
- A study on Contact Temperature of Silver Palladium Compounds Related to Opening Condition (国際セッション IS-EMD2005) -- (Contact Phenomena)
- Transmission Characteristics and Radiated Noise of the Parallel Transmission Lines with Angled Pattern(Signal Transmission,Recent Development of Electromechanical Devices (Selected Papers from IS-EMD2005))
- Electromagnetic Radiation Resulting from Two Signal Traces on a Printed Circuit Board(Signal Transmission,Recent Development of Electromechanical Devices (Selected Papers from IS-EMD2005))
- A Study on the Effect of Grounded Conductive Sheet Placed over PCB for Electromagnetic Noise Shielding(Near-/Far-Field EM Absorption and Shielding)
- Electromagnetic Radiation Resulting from Plural Signal Traces on a Printed Circuit Board (国際セッションIS-EMD2005) -- (Signal Transmission and Optical Connectors)
- B-4-41 A Study on the EMI Resulting from Plural Signal Traces on a PCB
- PCB Structure with a Guard Band for Suppressing Electromagnetic Radiation(Printed Circuit Boards, 2004 International Symposium on Electromagnetic Compatibility)
- Correspondence of Common- and Differential-Mode Components on EM Radiation from Surface Microstrip Line Structure(Signal Transmission, IS-EMD2004-Recent Development of Electro-Mechanical Devices)
- B-4-45 Frequency Response of Radiated Emission Resulting from a Nonzero Impedance(B-4. 環境電磁工学, 通信1)
- Characteristics of Electromagnetic Radiation from a Surface Microstrip Line Structure at High Frequency(Session 4 : Signal Transmission)
- A Study on Transmission Characteristics and EM Field Distributions on the Transmission Lines with Difference of Structure(IS-EMD2003 : Recent Technical Trend of Electro-Mechanical Devices)
- Identifying the Frequency Response of Common-Mode Current on a Cable Attached to a PCB(Measurement and Evaluation)(IS-EMD2003 : Recent Technical Trend of Electro-Mechanical Devices)
- B-4-114 Common-Mode Current due to a Trace on a PCB with a Slit in the Ground Plane
- B-4-113 A Study on Electromagnetic Radiation from a PCB with a Guard-Band
- A Study on Transmission Characteristics and EM Field Distributions on the Transmission Lines with Difference of Structure (国際セッションIS--EMD 2003) -- (Session 2 Measurements and evaluation)
- Identifying the Frequency Response of Common-Mode Current on a Semi-rigid Cable Attached to a PCB (国際セッションIS--EMD 2003) -- (Session 2 Measurements and evaluation)
- A Study on Transmission Characteristics and EM Field Distributions on the Transmission Lines with Difference of Structure
- Identifying the Frequency Response of Common-Mode Current on a Semi-rigid Cable Attached to a PCB
- B-4-27 A Study on the Comparison between Common-Mode Current and Electromagnetic Radiation from a PCB with a Guard-Band
- Estimation of Spatial Distribution of Wideband Electromagnetic Noise around a Printed Circuit Board(Electromagnetic Compatibility(EMC))
- An Experimental Study on New Ag Coated Fabrics as Shielding Material for Electromagnetic Radiation from PCB(Recent Development of Electro-Mechanical Devices (IS-EMD 2002))
- A Study on Suppression of Common-Mode Current due to a Trace on a PCB (国際セッションIS-EMD2002〔英文〕)
- B-4-39 FDTD Modeling of Common-Mode Current due to a Trace on a PCB with a Guard-Band
- B-4-5 FDTD Modeling of Common-Mode Current on a Cable due to a Trace near a PCB Edge
- Application of Error Diagnosis Technique to Incremental Synthesis(Design Methodology)(VLSI Design and CAD Algorithms)
- B-4-53 A Study on Imbalance Component and EM Radiation from an Asymmetrical Differential-Paired Line driven by LVDS
- Optimum Design of Power Coupling between Two Dielectric Slab Waveguides by the Boundary-Element Method Based on Guided-Mode Extracted Integral Equations(Analytical and Simulation Methods for Electromagnetic Wave Problems)
- Optimum Design of Power Coupling between Two Dielectric Slab Waveguides by the Boundary-Element Method Based on Guided-Mode Extracted Integral Equations
- A Simulation of Near-Field Optics: Optical Waves Through an Aperture in 3D Thick Metallic Screen by Volume Integral Equation Method (特集:平成13年電磁界理論シンポジウム(その2))
- 3D Simulations of Optical Near-Field Distributions of Planar Objects by Volume Integral Equation(Special Issue on Near-Field Optics and Its Applications)
- Simulated Output Images of Near-Field Optics by Volume Integral Equation : Object Placed on the Dielectric Substrate
- A Simuration of Near Field Optics by Three Dimensional Volume Integral Equation of Classical Electromagnetic Theory
- B-4-2 A Study on EM Radiation from Stripline Structure with Gapped Plane
- A Study on Transmission and Undesired Radiation Characteristics of Mount Model for High Frequency Element(Session 4 : Signal Transmission)
- Experimental Study for Near Magnetic Field Radiation from Resistors Mounted on PCB(2nd Pan-Pacific EMC Joint Meeting-PPEMC'06-)
- Experiments on Crosstalk between Parallel Transmission Lines (国際セッションIS-EMD2005) -- (Signal Transmission and Optical Connectors)
- FDTD Modeling for PCB Model with a Switching Transister
- FDTD Simulation and Experimental Study on Line Impedance and Magnetic Near Field Noise for a Simple Printed Line Model(Special Issue on Recent Progress in Electromagnetic Compatibility Technology)
- Effect of Holder Heat Capacity on Bridge Shape at Low Speed Breaking Contact
- Diagnostic Procedure for EMI Resulting from High-Speed Routing between Power and Ground Planes
- Metal Flow in Molten Pool by Defocused Electron Beam : Minor element effect on weld penetration (2nd report)
- Influence of Film Characteristics on the Sputtering Rate of MgO (Special Issue on Electronic Displays)
- Shielding Effect Measurement of Ag Coated Fabrics Put near PCB
- Effect of Conductive Sheet Placed over PCB on Electromagnetic Noise Shielding
- Turbulence Modification and Interface Deformation in Turbulent Liquid Plane Couette Flow with an Immiscible Droplet
- Programmable Composite Noise Generator (P-CNG) : As Class A Noise Simulator and Its Application to Opinion Test on TV Picture Degradation
- An Experimental Study on Subjective Evaluation of TV Picture Degradation by Electromagnetic Noise : Opinion Tests on Still and Motion Pictures
- Estimation for Wideband Electromagnetic Field Distribution from PCB with Switching Transistor (国際セッションIS-EMD2002〔英文〕)
- CS-5-5 A Study on EMI Resulting from Interconnected Printed Circuit Boards by a Cable
- Effect of Heat Conductivity on Bridge Break at Different Material Contact Pairs
- Contact Conditions in Connectors that Cause Common Mode Radiation
- Voltage Fluctuation of Arc Discharge Affected by Pressure in Relay Housing
- Arc Discharge Affected by Pressure in Relay Housing
- The Polymerization Reaction of Sodium Phosphate
- B-4-9 An Equivalent Circuit Model for Predicting EM Radiation from a Surface-Microstrip Line Structure
- Estimation for Wideband Electromagnetic Field Distribution from Printed Circuit Board with Switching Transistor(Recent Development of Electro-Mechanical Devices (IS-EMD 2002))
- B-4-17 A Study on EMI from Printed Circuit Boards with Interconnection Coaxial Cable