A Novel Primer on Dentin Bonding of 4-META/MMA-TBB to Collagen-depleted Dentin
スポンサーリンク
概要
- 論文の詳細を見る
The purpose of this study was to investigate the efficacy of an experimental dentin primer consisting of ascorbic acid (AA) and ferric chloride (Fe). Three exprimental primers - 10wt%AA and 0.075wt%Fe (i.e., 10AA-0.075Fe), 10AA-0Fe, and OAA-0.075Fe - were prepared. Flattened dentin surfaces were first treated with phosphoric acid and NaClO, and subsequently primed using each experimental solution. Besides the experimental solutions, 10wt% citric acid and 3wt% ferric chroride (10CA-3Fe) was also used. A stainless steel rod was bonded to the dentin surface with Super-Bond C&B. 10CA-3Fe/Super-Bond C&B was then used as a control. Tensile bond strengths were evaluated after 24-hour immersion in water. 10AA-0.075Fe showed significantly high bond strength compared to 10AA-0Fe, 0AA-0.075Fe, 0AA-0Fe, and 10CA-3Fe. No significant differences were found between 10AA-0.075Fe and Super-Bond C&B system. The experimental primer consisting of 10wt% ascorbic acid and 0.075wt% ferric chloride improved the bonding between Super-Bond C&B and dentin conditioned with phosphoric acid and NaClO.
- 日本歯科理工学会の論文
著者
-
ATSUTA Mitsuru
Division of Fixed Prosthodontics and Oral Rehabilitation, Nagasaki University Graduate School of Bio
-
SUZUKI Shiro
Department of Prosthodontics, University of Alabama at Birmingham, School of Dentistry
-
Taira Yohsuke
Department Of Applied Prosthodontics Graduate School Of Biomedical Sciences Nagasaki University
-
Taira Yohsuke
Division Of Applied Prosthodontics Graduate School Of Biomedical Sciences Nagasaki University
-
Taira Y
Nagasaki Univ. Nagasaki Jpn
-
Taira Yohsuke
長崎大学 医歯薬学総合研究科健美補綴学
-
Taira Yohsuke
長崎大学 医歯薬学総合研究科摂食機能回復診断治療学
-
Taira Yohsuke
Nagasaki University Graduate School Of Biomedical Sciences Course Of Medical And Dental Sciences Dep
-
Taira Yohsuke
Division Of Fixed Prosthodontics And Oral Rehabilitation Nagasaki University Graduate School Of Biom
-
SOENO Kohyoh
Division of Fixed Prosthodontics and Oral Rehabilitation, Nagasaki University Graduate School of Bio
-
Taira Yohsuke
Division Of Fixed Prosthodontics And Oral Rehabilitation Nagasaki University Graduate School Of Biom
-
Soeno Kohyoh
Nagasaki University Graduate School Of Biomedical Sciences Course Of Medical And Dental Sciences Dep
-
Suzuki Shiro
Department Of Prosthodontics University Of Alabama At Birmingham School Of Dentistry
-
Suzuki Shiro
Department Of Gastroenterology And Hepatology Tokyo Medical University
-
Suzuki Shiro
Materials Science & Advanced Devices Nhk Science & Technical Research Laboratories
-
Suzuki Shiro
鹿児島大学 医歯学総合研究科咬合機能補綴学
-
Atsuta Mitsuru
Division Of Applied Prosthodontics Graduate School Of Biomedical Sciences Nagasaki University
関連論文
- Shear Bond Strengths of Four Resin Bonding Systems to Two Silica-based Machinable Ceramic Materials
- Effects of Monomer Composition and Original Filler Content on Filler Loading in the Resulting Centrifuged Composites
- Effect of fiber-premixed indirect resin composite substructure on fracture resistance of MOD composite inlays adhered with two different adhesive resin cements
- Effects of metal primers on bonding of adhesive resin cement to noble alloys for porcelain fusing
- Color Stability of Acrylic Resin Adhesives with Different Initiation Modes
- Bond Strength between Four Luting Systems and Enamel Modified with Phosphoric Acid
- Influence of Mechanical Properties of Two Resin Cements on Durability of Bond Strength to Dentin after Cyclic Loading
- Influence of Acid-base Conditioning on the Bond Strength of Five Luting Agents Employing Self-etching Primer to Enamel and Dentin
- A Novel Primer on Dentin Bonding of 4-META/MMA-TBB to Collagen-depleted Dentin
- Adhesion of 4-META/MMA-TBB Resin to Collagen-depleted Dentin : Effect of Conditioner with Ascorbic Acid/Ferric Chloride
- Effects of metal primers on bonding of adhesive resin cement to noble alloys for porcelain fusing
- Depth of cure and hardness of an indirect composite polymerized with three laboratory curing units
- A New Laboratory Polymerizing Apparatus Equipped with Halogen and Metal Halide Light Sources
- Effect of noble metal adhesive systems on bonding between an indirect composite material and a gold alloy
- A Nine-year Follow-up of a Porcelain Laminate Veneer Restoration Applied to an Adolescent with Traumatized Dentition : A Clinical Report
- Influence of Centrifugal Force on Filler Loading of Resin Composites
- Twenty-four Hour Bond Strength Between Layers of a Highly Loaded Indirect Composite
- Effectiveness of Bonding Systems on Bonding Durability of a Prefabricated Porcelain Material
- Dentin bond strength of a new adhesive system containing calcium phosphate experimentally developed for direct pulp capping
- Effects of attrition, prior acid-etching, and cyclic loading on the bond strength of a self-etching adhesive system to dentin
- In Vitro Evaluation of Bond Strength and Surface Roughness of a Resin-Paint Material
- Effect of the concentrations of calcium chloride and synthetic peptides in primers on dentin bond strength of an experimental adhesive system
- Construction and Performance of a Large-Aperture Wire-Chamber Spectrometer for Pion Scattering Experiments at KEK
- Comparison of Four Fluoride Etchants in Bonding between Titanium and a Self-curing Luting Agent
- Cytotoxicity of Dental Resin Monomers in the Presence of S9 mix Enzymes
- Effect of Ceramic Coating by Aerosol Deposition on Abrasion Resistance of a Resin Composite Material
- A Test of Lead Glass Shower Counters
- The effect of magnesium oxide supplementation to aluminum oxide slip on the jointing of aluminum oxide bars
- Bond strength between luting materials and a fiber-reinforced resin composite for indirect restorations.
- The Physical Properties of a Machinable Resin Composite for Esthetic Restorations
- Influence of Laboratory Light-curing Unit Variation on Properties of Prosthetic Composites
- Effect of light intensity for adhesives on shear bond strength to dentin
- Effect of Air-blowing Variables on Bond Strength of All-in-one Adhesives to Bovine Dentin
- Effect of filler size on wear resistance of resin cement
- Effects of Primers Containing Thiouracil and Phosphate Monomers on Bonding of Resin to Ag-Pd-Au Alloy
- Effect of Four Silane Coupling Agents on Bonding of Two Resin-modified Glass Ionomer Cements to a Machinable Ceramic
- Decrease in accumulation of ultrasound contrast microbubbles in non-alcoholic steatohepatitis
- Dynamic US contrast study of the liver : Vascular and delayed parenchymal phase
- Usefulness of contrast-enhanced ultrasonography with a new contrast mode, Agent Detection Imaging, in evaluating therapeutic response in hepatocellular carcinoma treated with radio-frequency ablation therapy
- Differential diagnosis of hepatic nodules using delayed parenchymal phase imaging of levovist contrast ultrasound : comparative study with SPIO-MRI
- A study of self-adhesive resin cements for bonding to silver-palladium-copper-gold alloy — Effect of including primer components in cement base
- Photoconductive Properties of Organic Films Based on Porphine Complex Evaluated with Image Pickup Tubes
- Ultra-High-Sensitivity New Super-HARP Pickup Tube and Its Camera(Recent Progress in Photon Detection Technology)
- Image Pickup from Zinc Phthalocyanine/Bathocuproine Double-Layer Film Using Pickup Tube
- Ultrahigh-Sensitivity Pickup Tube Using 35-μm-Thick HARP Photoconductive Film
- Effect of the concentrations of calcium chloride synthetic and peptides in primers on dentin bond strength of an experimental adhesive system
- Evaluation of Wear and Subsequent Dye Penetration of Endodontic Temporary Restorative Materials
- Evaluation of Temporary Restorative Materials for Endodontic Treatments
- Influence of Light Irradiation Condition on Microshear Bond Strength of Dual-cured Resin Luting Agents
- Hardness Development of Dual-cured Resin Cements through Different Thicknesses of Ceramics
- Production of Monochromatic γ Rays from Thin Crystal of Silicon
- Improvement of Bonding to Bleached Bovine Tooth Surfaces by Ascorbic Acid Treatment
- Monochromatization of Collimated Coherent Bremsstrahlung from a Thin Silicon Crystal
- Study of dE/dx in a Drift Chamber with He-C_2H_6 Gas Mixture
- A study of self-adhesive resin cements for bonding to silver-palladium-copper-gold alloy-Effect of including primer components in cement base
- Identification and characterization of cancer stem cells in ovarian yolk sac tumors
- Examination of T/CP Invariance in the e^+e^-τ^+τ^- Reaction
- Dentin bond strength of an experimental adhesive system containing calcium chloride, synthetic peptides derived from dentin matrix protein 1 (pA and pB), and hydroxyapatite for direct pulp capping and as a bonding agent
- Effects of Alumina-blasting and Adhesive Primers on Bonding between Resin Luting Agent and Zirconia Ceramics
- RADIOPHARMACOLOGICAL STUDIES ON THE CADMIUM POISONING
- Silane primers rather than heat treatment contribute to adhesive bonding between tri-n-butylborane resin and a machinable leucite-reinforced ceramic
- Clinical Evaluation of Intramuscular Administration of Natural Interferon-γ in the Treatment of Chronic Hepatitis B
- Effect of experimental acid/base conditioner on microtensile bond strength of 4-META/MMA-TBB resin to dentin after long-term water immersion
- EXPERIMENTAL STUDIES ON THE CARBONIC ANHYDRASE ACTIVITY IX. THE MODE OF ACTION OF ADRENOCORTICAL STEROIDS, ESPECIALLY ALDOSTERONE, ON THE CARBONIC ANHYDRASE IN MICE AND RATS
- BASAL STUDY ON EARLY DIAGNOSIS OF CADMIUM POISONING : CHANGE IN CARBONIC ANHYDRASE ACTIVITY
- Effect of adherend temperature on bond strengths of resin bonding systems to denture base resin and a semi-precious alloy
- Effect of adhesion promoting monomer addition to MMA-TBBO resin on bonding to pure palladium
- Evaluation of fracture resistance of indirect composite resin crowns by cyclic impact test: Influence of crown and abutment materials
- Effects of sandblasting, H2SO4/HCl etching, and phosphate primer application on bond strength of veneering resin composite to commercially pure titanium grade 4
- Comparative study between laser sintering and casting for retention of resin composite veneers to cobalt-chromium alloy
- Disintegration of sulfonated poly(1,4-piperazinediylterephthaloyl) microcapsules by 1-dodecylpyridinium chloride.
- Cell growth-inhibitory action of SAGP, an antitumor glycoprotein from Streptococcus pyogenes (Su strain).
- Effect of adhesion promoting monomer addition to MMA-TBBO resin on bonding to pure palladium
- Thickness and surface structure of a ceramic layer created on three indirect resin composites with aerosol deposition
- Comparison of four silane primers and an isocyanate primer for bonding of tri-n-butylborane resin to a leucite-reinforced glass ceramic
- Evaluation of fracture resistance of indirect composite resin crowns by cyclic impact test : Influence of crown and abutment materials
- Effect of adherend temperature on bond strengths of resin bonding systems to denture base resin and a semi-precious alloy
- Effects of sandblasting, H_2SO_4/HCl etching, and phosphate primer application on bond strength of veneering resin composite to commercially pure titanium grade 4
- Effects of a fluoride etchant and a phosphate primer on bonding of veneering composite to Ti–6Al–4V alloy for CAD/CAM restorations
- Comparative study between laser sintering and casting for retention of resin composite veneers to cobalt-chromium alloy