B803 A STUDY OF ADHESION FORCE MODEL FOR WHEEL SLIDE PROTECTION CONTROL
スポンサーリンク
概要
- 論文の詳細を見る
In order to enhance the speed of wheel slide protection control for railway vehicles, modeling of adhesion characteristics after saturation of adhesion force, which had hitherto not been performed with trains, was performed via a beam model. The behavior of adhesive force between the wheel and rail in a wet condition was examined with a brake performance test stand for an actual vehicle. Results of comparing the model and test values indicated that the beam model represented test values well.
- 一般社団法人日本機械学会の論文
著者
-
Nagai Masao
Department Of Mechanical System Engineering Tokyo University Of Agriculture And Technology
-
Kamada Takayoshi
Department Of Mechanical Systems Engineering Tokyo Univ. Of Agriculture & Technology
-
Yamazaki Hiroo
Railway Technical Research Institute
-
Nagai Masao
Department Of Mechanical Systems Engineering Tokyo Univ. Of Agriculture & Technology
関連論文
- Analysis on Drivers' Decisions to Stop During Yellow Signals Using the Drive Recorder
- Study on automatic path tracking using virtual point regulator
- Using Steer-By-Wire Technology to Improve Motorcycle Handling and Stability
- Study of a Vehicle Dynamics Model for Improving Roll Stability
- Study on a vehicle dynamics model for improving roll stability
- Investigation of automatic path tracking using an extended Kalman filter
- Analysis of Driver Behavior in Various Traffic Circumstances Based on Forward Collision Near-Miss Incident Data in Vehicle-Following Situation
- D602 A STUDY OF COMBINED CONTROL OF PRIMARY AND SECONDARY SUSPENSION OF A MAGLEV VEHICLE
- A103 Study on the Vibration Control by the Modal Analysis of a MAGLEV Vehicle
- A Study of the Vibration Control System for a Superconducting Maglev Vehicle
- Yaw-moment control of electric vehicle for improving handling and stability
- Investigation of Intelligent Driving Assistance System Using Direct Yaw Moment Control
- Independent wheel torque control of small-scale electric vehicle for handling and stability improvement
- Integrated Control of Active Rear Wheel Steering and Yaw Moment Control Using Braking Forces
- Study on Car Body Tilting System Using Variable Link Mechanism : Perfect Tilting Condition and Tilting Control(Intemational Symposium on Speed-up and Service Technology for Railway and MAGLEV Systems)
- A203 STUDY ON CAR BODY TILTING SYSTEM USING VARIABLE LINK MECHANISM : 2^ Report, Perfect Tilting Condition and Tilting Control
- A202 STUDY ON CAR BODY TILTING SYSTEM USING VARIABLE LINK MECHANISM : 1^ report, Fundamental Characteristics of Pendulum Motion
- T-4-2-3 Analysis of pendulum motion using a four-link mechanism
- Recent Researches on Active Suspensions for Ground Vehicles
- B803 A STUDY OF ADHESION FORCE MODEL FOR WHEEL SLIDE PROTECTION CONTROL
- Study on handling and stability using tire hardware-in-the-loop simulator
- 718 Development of Hardware-in-the-Loop Simulator for Analyzing Vehicle Handling and Stability
- A NEW MOTION CUE ALGORITHM FOR IMPROVING LONGITUDINAL SENSATION IN DRIVING SIMULATOR
- A Study on Vehicle Lane Departure Delay System
- A Study of Adhesion Force Model for Wheel Slip Prevention Control(Intemational Symposium on Speed-up and Service Technology for Railway and MAGLEV Systems)
- Experiment and Design of Advanced Brake Assist System for Active Interface Vehicle Based on Driver's Gas Pedal Operation
- Vehicle-Driver Response when Traveling on Elevated Highways during Earthquakes : Steering Operation of Drivers
- System Identification of Railway Trains Pantograph for Active Pantograph Simulation