Using Steer-By-Wire Technology to Improve Motorcycle Handling and Stability
スポンサーリンク
概要
- 論文の詳細を見る
- 2006-07-01
著者
-
NAGAI Masao
Department of Mechanical Systems Engineering, Tokyo University of Agriculture and Technology
-
Nagai Masao
Department Of Mechanical System Engineering Tokyo University Of Agriculture And Technology
-
Marumo Yoshitaka
Department Of Mechanical Engineering College Of Industrial Technology Nihon University
関連論文
- Integrated Simulation between Flexible Body of Catenary and Active Control Pantograph for Contact Force Variation Control
- Experimental Evaluation of Hybrid Truck Driving Torque Controller Considering Human-Vehicle System Dynamics
- Analysis on Drivers' Decisions to Stop During Yellow Signals Using the Drive Recorder
- Study on automatic path tracking using virtual point regulator
- Using Steer-By-Wire Technology to Improve Motorcycle Handling and Stability
- Study of a Vehicle Dynamics Model for Improving Roll Stability
- Study on a vehicle dynamics model for improving roll stability
- Investigation of automatic path tracking using an extended Kalman filter
- Analysis of Driver Behavior in Various Traffic Circumstances Based on Forward Collision Near-Miss Incident Data in Vehicle-Following Situation
- D602 A STUDY OF COMBINED CONTROL OF PRIMARY AND SECONDARY SUSPENSION OF A MAGLEV VEHICLE
- A103 Study on the Vibration Control by the Modal Analysis of a MAGLEV Vehicle
- A Study of the Vibration Control System for a Superconducting Maglev Vehicle
- Yaw-moment control of electric vehicle for improving handling and stability
- Investigation of Intelligent Driving Assistance System Using Direct Yaw Moment Control
- Independent wheel torque control of small-scale electric vehicle for handling and stability improvement
- Integrated Control of Active Rear Wheel Steering and Yaw Moment Control Using Braking Forces
- Study on Car Body Tilting System Using Variable Link Mechanism : Perfect Tilting Condition and Tilting Control(Intemational Symposium on Speed-up and Service Technology for Railway and MAGLEV Systems)
- A203 STUDY ON CAR BODY TILTING SYSTEM USING VARIABLE LINK MECHANISM : 2^ Report, Perfect Tilting Condition and Tilting Control
- A202 STUDY ON CAR BODY TILTING SYSTEM USING VARIABLE LINK MECHANISM : 1^ report, Fundamental Characteristics of Pendulum Motion
- T-4-2-3 Analysis of pendulum motion using a four-link mechanism
- Recent Researches on Active Suspensions for Ground Vehicles
- B803 A STUDY OF ADHESION FORCE MODEL FOR WHEEL SLIDE PROTECTION CONTROL
- Study on handling and stability using tire hardware-in-the-loop simulator
- 718 Development of Hardware-in-the-Loop Simulator for Analyzing Vehicle Handling and Stability
- A NEW MOTION CUE ALGORITHM FOR IMPROVING LONGITUDINAL SENSATION IN DRIVING SIMULATOR
- A Study on Vehicle Lane Departure Delay System
- A Study of Adhesion Force Model for Wheel Slip Prevention Control(Intemational Symposium on Speed-up and Service Technology for Railway and MAGLEV Systems)
- Experiment and Design of Advanced Brake Assist System for Active Interface Vehicle Based on Driver's Gas Pedal Operation
- Vehicle-Driver Response when Traveling on Elevated Highways during Earthquakes : Steering Operation of Drivers
- System Identification of Railway Trains Pantograph for Active Pantograph Simulation