Heat Loss into Combustion Chamber Wall of 4-stroke Gasoline Engine : 2nd Report, Heat Loss into Cylinder Head, Intake and Exhaust Valves
スポンサーリンク
概要
- 論文の詳細を見る
Following the surface temperature variations and instantaneous heat flux in each cycle in the piston and the cylinder wall mentioned in the first report, the authors tried to verify them in the cylinder head and the suction/exhaust valve of a 4-stroke gasoline engine combustion chamber. The authors could make clear the heat flux distribution and heat loss conditions through the cylinder head and the valve surface for each stroke. In addition to the results as described in the first report, the heat loss on the entire combustion chamber wall against the quantity of supplied heat, namely, the ratio of heat transfer was known.
- 一般社団法人日本機械学会の論文
著者
-
ENOMOTO Yoshiteru
Musashi Institute of Technology
-
Furuhama Shoichi
Musashi Institute Of Technology
-
Furuhama Shoichi
Musashi Institute Of Technolog.
関連論文
- Heat Transfer Characteristics of a Diesel Spray Impinging on a Wall
- Heat loss to combustion chamber wall in a D.I.diesel engine-First report:Tendency of heat loss to piston surface
- Direct Heat Loss to Combustion Chamber Walls in a Direct-injection Diesel Engine : Evaluation of Direct Heat Loss to Cylinder Liner Wall
- Temperature Measurement in Thin-wall Ceramic Catalytic Substrates for D.I. Diesel Engines : Development of Fine Gauge Thermocouples and Study of Temperature Detection Performance and Durability
- Heat loss to the combustion chamber wall with deposit in D. I. diesel engine : variation of instantaneous heat flux on piston surface with deposit
- Development of thin film thermocouple for measurement of instantaneous heat flux flowing into the cast iron combustion chamber wall
- Thermal load in D. I. diesel engine under EGR operation-measurements of steady state temperature of combustion chamber wall surface and intake gas temperature
- Analysis of Knock Phenomenon Induced in a Constant Volume Chamber by Local Gas Temperature Measurement and Visualization(Advanced Combustion Technology in Internal Combustion Engines)
- Analysis of Auto-Ignition Induced in a Constant Volume Vessel by Local Gas Temperature Measurement and Visualization(Measurement, Temperature)
- Effect of Enlarged Piston Top-land Clearance on Loc
- Study on Thin Film Thermocouple Measuring Instantaneous Temperature on Surface of Combustion Chamber Wall In Internal Combustion Engine : 2nd Report, Study on Thin Film Thermocouples Embedded in Combustion Chamber Wall
- Heat Loss to Combustion Chamber Wall of 4-Stroke Gasoline Engine : 1st Report, Heat Loss to Piston and Cylinder
- Study on Thin Film Thermocouple for Measuring Instantaneous Temperature on Surface of Combustion Chamber Wall in Internal Combustion Engine
- Heat Transfer to Wall of Ceramic Combustion Chamber of Internal Combustion Engine
- Piston Temperature of Automobile Gasoline Engine in Driving on the Road
- Self-ignition and combustion stability in a methanol fueled low heat rejection ceramic ATAC engine-analysis of cyclic variation at high wall temperatures and lean burn operation
- Heat Loss into Combustion Chamber Wall of 4-stroke Gasoline Engine : 2nd Report, Heat Loss into Cylinder Head, Intake and Exhaust Valves
- Temperature Measurements of the Connecting Rod, Piston Pin and Crankpin Bearing of an Automobile Gasoline Engine
- Piston Temperatures of an Automobile Engine
- Some Measurements of the Piston Temperatures in a Small Type Gasoline Engine
- The Influence of the Combustion Products on the Piston-Ring Wear of a Diesel Engine : 1st Report, Motoring
- The Wear Properties of Piston Rings of an Automobile Gasoline Engine : Experimental Results by Means of R.I. Method
- On the Flow of Gas Through the Piston-Rings : 2nd Report, The Character of Gas Leakage
- On the Flow of Gas Through the Piston-Rings : 1st Report, The Discharge Coefficient and Temperature of Leakage Gas
- A Dynamic Theory of Piston-Ring Lubrication : 3rd Report, Measurement of Oil Film Thickness
- A Dynamic Theory of Piston-Ring Lubrication : 2nd Report, Experiment
- Tribology on Reciprocating Internal Combustion Engines
- The Influence of the Combustion Products on the Piston-Ring Wear of a Diesel Engine : 2nd Report, Firing
- Temperature Distribution of Piston Rings and Piston in High Speed Diesel Engine
- A Dynamic Theory of Piston-Ring Lubrication : 1st Report, Calculation
- Scavenging Characteristics and Supercharging Effects of Two-stroke Hydrogen Injection Engine
- A Study of the Oil Loss through the Piston
- A Study on Valve Recession Caused by Non-leaded Gasoline : Measurement by means of R. I.
- Effect of the Piston Ring Shape on the Ring-Stick of an Air Cooled 2-Stroke Diesel Engine