継目無鋼管のせん孔圧延におけるプラグの温度と表層挙動

概要

論文の詳細を見る
Prediction of tool temperature is very important to improve its life, since tool life is strongly influenced by increase in temperature of tool surface in piercing and rolling process of seamless steel pipes. The temperature of plugs under some piercing conditions of cross roll and press roll piercers was calculated. Actual temperature of plugs were measured and compared with the calculated results to confirm the validity of calculation. In addition, thin layer of actual plug surface after piercing campaign was extracted by solvent method and structure of the thin layer was observed by using an electron microscope. It was clarified that temperature of plug surface becames over 1200℃ in piercing and that a metallic surface plugs were unsuitable for a piercer. Black scale film on plug surface showed a good protective effect against heat conduction. Temperature of a plug treated with scale film became from 700℃ to 800℃ in piercing. The black scale film on plug surface under piercing condition was enriched in SiO_2 and it was presumed that the surface of plug was covered with a thin layer of melted scale, namely, scale lubricant. An amorphous thin layer was confirmed on the surface of a plug after piercing campaign through observation by electron microscope and electron diffraction patterns of the extracted thin layer.
社団法人日本鉄鋼協会の論文
1986-03-01