Cu-P複合めっき膜のろう付特性に及ぼす添加P粒子径の影響
スポンサーリンク
概要
- 論文の詳細を見る
To apply a Cu-P composite plating film as a brazing material for Cu plates of a heat exchanger, the effect of a phosphorous particle size in the Cu-P composite plating film on brazability has been investigated. For Cu-P composite plating films using phosphorous particles with average sizes of 7.5μm and 3μm, solidus temperatures were investigated to be 765.0°C and 715.6°C, respectively. These temperatures are lower than 800°C, which is conventional brazing temperature for Cu and Cu alloys. In the case of phosphorous particle with an average size of 1.5μm, however, obvious solidus temperature was not observed by differential scanning calorimetry(DSC). In brazed Cu joints using Cu-P composite plating films with 7.5μm and 3μm size phosphorous particles, Cu phases and eutectic phases were observed. The eutectic phases consist of fine Cu and Cu3P phases. A similar microstructure was observed in a brazed Cu joint with conventional Cu-7mass%P alloy foil. In contrast, brazing was not completed when the average phosphorous particle size is 1.5μm. In the brazed interface, a brazed microstructure of Cu-7P alloy was not observed but a crack was found. In the brazed joint, phosphorus was dispersed uniformly in Cu plates. Since fine phosphorous particles can diffuse easily into Cu plates in heating process of brazing and thus the Cu-P composite film does not remain in the brazed interface, such a Cu-P composite plating film makes brazing difficult.
- 社団法人表面技術協会の論文
- 2007-12-01
著者
関連論文
- Sn-0.7Cu鉛フリーはんだの低サイクル疲労特性および画像を用いた疲労被害評価
- りん銅ろうを用いたステンレス鋼のろう付技術 (特集 各種材料のろう付のポイント)
- 低融点鉛フリーはんだの引張特性 (鉛フリーはんだのレオロジー)
- Sn-3.5Ag, Sn-0.7Cu鉛フリーはんだの表面変形度合による低サイクル疲労寿命の定義
- 234 Sn-Ag系鉛フリーはんだの引張特性
- 座談会 表面技術に見る夢 (踏み出そう!新たな一歩)
- ナノ結晶の硬質純金めっき膜を用いたプローブの電気接点特性の向上(機構デバイス)
- マグネシウム合金溶湯に対するVGCFのぬれ性改善を目的とした表面改質処理
- 無電解Ni-Pめっき処理アルミニウム合金とポリアセタールとの摩耗特性
- Cu-P複合めっき膜のろう付特性に及ぼす添加P粒子径の影響