Effect of Clinicians' Experience on Chair Time and the Number of Denture Adjustment Visits Required for Complete Denture Treatment
スポンサーリンク
概要
- 論文の詳細を見る
Purpose: The purpose of this study was to demonstrate how a clinician’s experience might affect the complete denture treatment.Methods: A randomized controlled parallel clinical trial at two hospitals was conducted from April 2004 to July 2006. Written informed consent was obtained from the study subjects. Permuted-block randomization was performed with a block size of 4, indicating that not only was the clinician’s experience randomized) but also the denture base materials used (conventional acrylic resin and resilient liner). The chair time required for each step of complete denture treatment was compared between the junior clinician and senior clinician groups. The clinical protocol was carried out as follows: the preliminary impression, final impression, maxillomandibular registration, trial placement, denture delivery, and the number of visits for denture adjustments. Seventy-four subjects were assigned to this trial.Results: Significant differences were observed between the junior clinician and senior clinician groups with regard to chair time required for final impressions and the number of visits required for denture adjustments. There were no differences in chair time required for the other treatment steps.Conclusion: This randomized controlled clinical trial revealed that a clinician’s experience has an obvious influence on the chair time required for a final impression and the number of visits for denture adjustment.
- 日本補綴歯科学会の論文
- 2007-07-01
著者
-
Kimoto Suguru
Department of Gnatho-Oral Prosthetic Rehabilitation, Nihon University School of Dentistry at Matsudo
-
Kimoto Katsuhiko
Department of Oral & Maxillifacial Rehabilitation, Kanagawa Dental College
-
Tanaka Kinya
Department of Oral & Maxillifacial Rehabilitation, Kanagawa Dental College
-
Aoki Hiromichi
Department of Oral & Maxillifacial Rehabilitation, Kanagawa Dental College
-
Toyoda Minoru
Department of Gnatho-Oral Prosthetic Rehabilitation, Nihon University School of Dentistry at Matsudo
-
Kobayashi Kihei
Department of Oral & Maxillifacial Rehabilitation, Kanagawa Dental College
-
Asai Hideki
Department Of Systems Engineering Faculty Of Engineering Shizuoka University
-
Asai Hideki
Department Of Opto-electronics&mechanical Engineering Faculty Of Engineering Shizuoka University
-
Tanaka Kinya
Department Of Oral & Maxillofacial Rehabilitation Kanagawa Dental College
-
Toyoda Minoru
Division Of Removal Prosthetics Department Of Oral And Maxillofacial Rehabilitation Kanagawa Dental
-
Aoki Hiromichi
Division Of Fixed Prosthodontics Department Of Oral And Maxillofacial Rehabilitation Kanagawa Dental
-
Kobayashi Kihei
Department Of Complete Denture Nihon University School Of Dentistry At Matsudo
-
Kobayashi Kihei
Department Of Gnatho-oral Prosthetic Rehabilitation Nihon University School Of Dentistry At Matsudo
-
TAKEO Ai
Department of Gnatho-Oral Prosthetic Rehabilitation, Nihon University School of Dentistry at Matsudo
-
SUGIMURA Kaori
Department of Gnatho-Oral Prosthetic Rehabilitation, Nihon University School of Dentistry at Matsudo
-
IMAMICHI Yasuo
Department of Gnatho-Oral Prosthetic Rehabilitation, Nihon University School of Dentistry at Matsudo
-
ITO Mitsuto
Department of Gnatho-Oral Prosthetic Rehabilitation, Nihon University School of Dentistry at Matsudo
-
Kimoto Suguru
Department Of Gnatho-oral Prosthetic Rehabilitation Nihon University School Of Dentistry At Matsudo
-
Kimoto Suguru
Department Of Complete Denture Nihon University School Of Dentistry At Matsudo
-
Takeo Ai
Department Of Gnatho-oral Prosthetic Rehabilitation Nihon University School Of Dentistry At Matsudo
-
Ito Mitsuto
Department Of Gnatho-oral Prosthetic Rehabilitation Nihon University School Of Dentistry At Matsudo
-
Imamichi Yasuo
Department Of Gnatho-oral Prosthetic Rehabilitation Nihon University School Of Dentistry At Matsudo
-
Sugimura Kaori
Department Of Gnatho-oral Prosthetic Rehabilitation Nihon University School Of Dentistry At Matsudo
-
Kimoto Katsuhiko
Department Of Oral & Maxillofacial Rehabilitation Kanagawa Dental College
-
Asai Hideki
Department Of Gnatho-oral Prosthetic Rehabilitation Nihon University School Of Dentistry At Matsudo
-
Asai Hideki
Department Of Applied Chemistry Faculty Of Engineering Okayama University
-
Aoki Hiromichi
Department Of Emergency And Critical Care Medicine Tokai University School Of Medicine
-
Kimoto Katsuhiko
Division Of Fixed Prosthodontics Department Of Oral And Maxillofacial Rehabilitation Kanagawa Dental College
関連論文
- Fast Simulation Technique of Plane Circuits via Two-Layer CNN-Based Modeling
- Effects of Resilient Denture Liner in Mandibular Complete Denture on the Satisfaction Ratings of Patients at the First Appointment following Denture Delivery
- Reliability and Validity of the Japanese Version of the Visual Analogue Scale as an Outcome Measurement of Complete Denture Prostheses
- Fast Simulation Technique of Plane Circuits via Two-Layer CNN-Based Modeling
- Acceleration of ADI-FDTD Method by Gauss-Seidel Relaxation Approach
- Progenitor Cells From Dental Follicle Are Able to Form Cementum Matrix In Vivo
- Application of micro-CT to observe the tissue surrounding dental implants at rabbit's bone(15thAnnual Meeting of the Society for Hard Tissue Regenerative Biology,Session 2)
- Observation of Newly Formed Bone Around Implants Using Parametric X-ray
- Fast Transient Simulation of Power Distribution Networks Containing Dispersion Based on Parallel-Distributed Leapfrog Algorithm(Analog Circuit Techniques and Related Topics)
- An Enhanced Time-Domain Circuit Simulation Technique Based on LIM(Numerical Analysis and Optimization)
- An Efficient Simulation Method of Linear/Nonlinear Mixed Circuits Based on Hybrid Model Order Reduction Technique(Nonlinear Theory and its Applications)
- An Efficient Simulator for Multiport Interconnects with Model Order Reduction Technique(Special Section on Papers Selected from ITC-CSCC 2001)
- A New Methodology for Optimal Placement of Decoupling Capacitors on Printed Circuit Board
- Transient Analysis for Transmission Line Networks Using Expanded GMC (Special Section on Nonlinear Theory and Its Applications)
- Relaxation-Based Transient Analysis of Lossy Coupled Transmission Lines Circuits Using Delay Evaluation Technique(Special Section of Papers Selected from ITC-CSCC'97)
- Adhesion of C. albicans to Acrylic Resin Containing Fluoridated Apatite-Coated TiO_2
- A Neuro-Based Optimization Algorithm for Three Dimensional Cylindric Puzzles (Special Section of Papers Selected from ITC-CSCC'96)
- Design Method of Neural Networks for Limit Cycle Generator by Linear Programming
- A Fast Neural Network Simulator for State Transition Analysis (Special Section on Nonlinear Theory and Its Applications)
- A Fast Algorithm for Spatiotemporal Pattern Analysis of Neural Networks with Multivalued Logic (Special Section on Nonlinear Theory and Its Applications)
- A Neuro-Based Optimization Algorithm for Rectangular Puzzles(Special Section of Papers Selected from ITC-CSCC'97)
- Neural Networks for Digital Sequential Circuits
- Mixed Mode Circuit Simulation Using Dynamic Network Separation and Selective Trace (Special Section on the 6th Karuizawa Workshop on Circuits and Systems)
- Mixed Mode Circuit Simulation Using Dynamic Partitioning (Special Section on the 5th Karuizawa Workshop on Circuits and Systems)
- Antifungal Effect of Acrylic Resin Containing Apatite-coated TiO_2 Photocatalyst
- New Criteria of Selective Orthogonal Matrix Least-Squares Method for Macromodeling Multiport Networks Characterized by Sampled Data(Analog Circuit Techniques and Related Topics)
- A Low Voltage Floating Resistor Circuit Having Both Positive and Negative Resistance Values
- Design and Simulation of 4Q-Multiplier Using Linear and Saturation Regions of MOSFET Complementally(Special Section on Papers Selected from ITC-CSCC 2001)
- A CMOS Floating Resistor Circuit Having Both Positive and Negative Resistance Values(Special Section on Analog Circuit Techniques and Relate)
- A Positive Negative Resistor for Synaptic Weights
- A Positive Floating Resistor and A Negative Floating Resistor for the Analog Neural Network Implementation
- A Novel Application of Verilog-A to Modeling and Simulation of High-Speed Interconnects in Time/Frequency Transform-Domain(Special Section on Analog Circuit Techniques and Relate)
- Effect of Respiratory Rate on Respiratory Patterns in Patients with Chronic Obstructive Pulmonary Disease
- Effect of Clinicians' Experience on Chair Time and the Number of Denture Adjustment Visits Required for Complete Denture Treatment
- Thin Films formed by Radiofrequency Sputtering of β-tricalcium phosphate
- Assessment of Oxidative Stress in the Spontaneously Hypertensive Rat Brain Using Electron Spin Resonance (ESR) Imaging and in Vivo L-Band ESR
- Influence of Simplified Silica Coating Method on the Bonding Strength of Resin Cement to Dental Alloy
- A Study of the Effects of Irradiation on the Polymerization of Dual-cured Self-etching Bonding System Using Electron Spin Resonance (ESR) Spectroscopy
- A Study of the Effects of Self-etching Primers on the Polymerization of Bonding Agents Using Electron Spin Resonance (ESR) Spectroscopy
- Evaluation of Adhesive Defects using an Ultrasonic Pulse-reflection Technique
- Evaluation of adhesive interface using an ultrasonic pulse-reflection technique
- Determination of Cutoff Values on the 100-mm Visual Analogue Scale to Classify the Satisfaction Levels of Complete Denture Wearers
- Macromodel Generation for Hybrid Systems Consisting of Electromagnetic Systems and Lumped RLC Circuits Based on Model Order Reduction(Analog Circuit Techniques and Related Topics)
- Investigation on how renewal of complete dentures impact on dietary and nutrient adequacy in edentulous patients
- An Assessment of Condylar Dynamics Associated with Grinding Movements : Part 1. Pattern Analysis of Condylar Dynamics
- The use of existing denture-satisfaction ratings for a diagnostic test to indicate prognosis with newly delivered complete dentures
- Mix-mode TiO-C18 monolith spin column extraction and GC-MS for the simultaneous assay of organophosphorus compounds and glufosinate, and glyphosate in human serum and urine
- Hand Grasp Force during Static Teeth Clenching and Nonclenching
- Acceleration techniques for Transient Simulation of Lossy Interconnects based on Waveform Relaxation Approach
- The Influence of Repairs on the Stress Distribution and Compression Fracture Strength of Denture Bases
- A Framework for Macromodeling and Mixed-Mode Simulation of Circuits/Interconnects and Electromagnetic Radiations
- Assessment of Masticatory Performance : Methodologies and Their Application
- Mix-mode TiO-C_ Monolith Spin Column Extraction and GC-MS for the Simultaneous Assay of Organophosphorus Compounds and Glufosinate, and Glyphosate in Human Serum and Urine
- Effects of Resilient Denture Liner in Mandibular Complete Denture on the Satisfaction Ratings of Patients at the First Appointment following Denture Delivery
- A New Entry to Difluoromethylene Compounds; An Electrochemical Method
- ESR investigation of ROS generated by H_2O_2 bleaching with TiO_2 coated HAp
- Evaluation of denture base resin after disinfection method using reactive oxygen species (ROS)
- Enhanced biological responses of a hydroxyapatite/TiO_2 hybrid structure when surface electric charge is controlled using radiofrequency sputtering
- Experimental and Theoretical Approach for Evaluating the Flexural Properties of a Denture Base Material Relined with Three Soft Lining Materials
- Maxillary sensory nerve responses induced by different types of dentures
- Investigation on how renewal of complete dentures impact on dietary and nutrient adequacy in edentulous patients
- Response of human fibroblasts to implant surface coated with titanium dioxide photocatalytic films
- Management of oral candidiasis in denture wearers